Asus P4SD - 865GV Socket 478 mATX Motherboard Bedienungsanleitung

Motherboard

P4SD-LA

( Oxford )

User Guide

Checklist

Contents

P4SD-LA specifications summary .................................................. iii

1. Motherboard layout ............................................................... 1

2. Central Processing Unit (CPU).............................................. 2

3. System memory .................................................................... 3

Memory configurations .......................................................... 3

Installing a DIMM................................................................... 4

4. Expansion slots ..................................................................... 5

Standard interrupt assignments ............................................ 5

IRQ assignments for this motherboard.................................. 5

PCI slots ................................................................................ 6

AGP slot ................................................................................ 6

5. Jumper .................................................................................. 7

6. Connectors ............................................................................ 8

iii

P4SD-LA specifications summary

CPU

Chipset

Front Side Bus (FSB)

Memory

Expansion slots

VGA

Serial ATA

IDE

Audio

LAN

Special features

Rear panel I/O

Internal I/O

BIOS features

Industry standard

Manageability

Form factor

Socket 478 for Intel

Pentium

4 Northwood/Prescott

On-die 512KB/256KB L2 cache with full speed

Intel

Hyper-Threading technology ready

New power design for up to 3.4+ GHz or faster speed

Intel

Breeds Hill MCH(848P)

Intel

ICH5

800/533/400 MHz

2x 184-pin DDR DIMM sockets for up to 2GB memory

Supports PC3200/PC2700/PC2100 unbuffered

non-ECC DDR DIMMs

1 x AGP 4X/8X

3 x PCI

No support for on-board VGA

Intel ICH5 supports two UltraDMA/150 SATA connectors

2 x UltraDMA 100/66/33 connectors

RealTek ALC650 6-channel audio CODEC

Realtek 8101L 10/100 Mbps Fast Ethernet controller

Power Loss Restart

ASUS EZ Flash

1 x Parallel port

1 x Serial port

1 x Video port

1 x PS/2 keyboard port

1 x PS/2 mouse port

4 x USB 2.0/USB 1.1 ports

1 x RJ-45 port

1 x IEEE 1394 port

Line In/Line Out/Microphone ports

2 x USB 2.0/1.1 connector for 4 additional USB ports

CPU/Chassis fan connectors

20-pin/4-pin ATX 12V power connectors

S/PDIF connector

Speaker Out connector

CD/AUX audio connectors

Front HP-OUT connector

4Mb Flash ROM, AMI BIOS with enhancedACPI, PnP,

DMI2.0, Green features

PCI 2.2, USB 2.0

WfM 2.0. DMI 2.0, WOL/WOR by PME

Micro-ATX form factor: 9.6 in x 9.6 in (24.5 cm x 24.5 cm)

ASUS P4SD-LA motherboard

1. Motherboard layout

ATX12V1

24.5cm (9.64in)

SECONDARY IDE

FLOPPY1

P4SD-LA

Intel

ICH5

Chipset

Accelerated Graphics Port (AGP8X1)

Intel

Breeds Hill

MCH

Chipset

Super

I/O

4Mb

BIOS

PCI 1

PS/2

T: Mouse

B: Keyboard

Realtek

RTL8101L

CHA_FAN1

Audio

Codec

Below:Mic In

Center:Line Out

Top:Line In

DDR DIMM1 (64/72 bit, 184-pin module)

PCI 2

PCI 3

24.5cm (9.64in)

CPU_FAN1

COM1

PARALLEL PORT

VGA

RJ-45

Top:

USB1

USB2

Bottom:

1394

Top:

USB1

USB2

Bottom:

BUZZER

BATTERY1

USB1 HPANEL

1394

CD_IN AUX SPEAKER OUT

FRONT MICIN

ATX Power Connector

DDR DIMM2 (64/72 bit, 184-pin module)

Socket 478

USB2

P30

TI43AB22A

1394

PHY

FRONT HP-OUT

PRIMARY IDE

P31

J19

SPDI/F

ASUS P4SD-LA motherboard

2. Unlock the socket by pressing the

lever sideways, then lift it up to a 90°-

100°angle.

3. Position the CPU above the socket

such that its marked corner matches

the base of the socket lever.

4. Carefully insert the CPU into the

socket until it fits in place.

5. When the CPU is in place, push

down the socket lever to secure the

CPU. The lever clicks on the side tab

to indicate that it is locked.

6. Install a CPU heatsink and fan

following the instructions that came

with the heatsink package.

7. Connect the CPU fan cable to the

CPU_FAN1 connector on the

motherboard.

Gold Mark

2. Central Processin Unit (CPU)

The motherboard comes with a surface mount 478-pin Zero Insertion Force (ZIF)

socket. The socket is designed for the Intel

Pentium

4 Northwood/Prescott

processor in the 478-pin package with 512KB L2 cache. This processor supports

800/533/400MHz front side bus (FSB), and allows data transfer rates of 3.2GB/s,

2.1GB/s, and 1.6GB/s.

Follow these steps to install a CPU.

1. Locate the 478-pin ZIF socket on the motherboard.

Make sure that the socket lever is lifted

up to 90°-100°angle, otherwise the

CPU does not fit in completely.

Socket Lever

90 -100

The CPU fits only in one correct

orientation. DO NOT force the CPU

into the socket to prevent bending

the pins and damaging the CPU!

ASUS P4SD-LA motherboard

3. System memory

The motherboard comes with two Double Data Rate (DDR) Dual Inline Memory

Module (DIMM) sockets. These sockets support up to 2GB system memory using

184-pin unbuffered non-ECC PC3200/PC2700/PC2100 DDR DIMMs.

The following figure illustrates the location of the DDR DIMM sockets.

P4SD-LA

P4SD-LA 184-Pin DDR

DIMM Sockets

80 Pins

104 Pins

DIMM1

DIMM2

Memory configurations

You may install 64MB, 128MB, 256MB, 512MB, and 1GB DDR DIMMs into the

DIMM sockets using the memory configurations in this section.

Important notes on memory configurations

1. Installing DDR DIMMs other than the recommended configurations may

cause memory sizing error or system boot failure. Use any of the

recommended configurations in Table 1.

2. Install only identical (the same type and size) DDR DIMM pairs using the

recommended configurations.

3. Make sure that the memory frequency matches the CPU FSB (Front Side

Bus). Refer to Table 2 below.

4. Double-sided 16-bit DDR DIMMs are not supported on this motherboard.

ASUS P4SD-LA motherboard

Make sure to unplug the power supply before adding or removing DIMMs or

other system components. Failure to do so may cause severe damage to both

the motherboard and the components.

Follow these steps to install a DIMM.

1. Unlock a DIMM socket by pressing

the retaining clips outward.

2. Align a DIMM on the socket such that

the notch on the DIMM matches the

break on the socket.

3. Firmly insert the DIMM into the socket

until the retaining clips snap back in

place and the DIMM is properly

seated. Unlocked Retaining Clip

DDR DIMM notch

Table 1 Recommended memory configurations

Table 2 Memory frequency/CPU FSB synchronization

Sockets

Mode DIMM1 DIMM2

Single-channel (1) Installed —

(2) —Installed

(3) Installed Inst

alled

CPU FSB DDR DIMM Type Memory Frequency

800 MHz PC3200/PC2700/PC2100 400/333/266 MHz

533 MHz PC2700/PC2100 333/266 MHz

400 MHz PC2100 266 MHz

Installing a DIMM

ASUS P4SD-LA motherboard

4. Expansion slots

The motherboard has three PCI slots and one Accelerated Graphics Port (AGP) slot.

To install and configure an expansion card:

1. Install an expansion card following the instructions that came with the chassis.

NOTE: The AGP slot supports only +0.8V and +1.5V AGP cards.

2. Turn on the system and change the necessary BIOS settings, if any. See

Chapter 2 for BIOS information.

3. Assign an IRQ to the card. Refer to the tables below.

4. Install the drivers and/or software applications for the expansion card

according to the card documentation.

Standard interrupt assignments

IRQ Priority Standard Function

0 1 System Timer

1 2 Keyboard Controller

2 N/A Programmable Interrupt

3* 11 Communications Port (COM2)

4* 12 Communications Port (COM1)

5* 13 IRQ holder for PCI steering

6 14 Floppy Disk Controller

7* 15 Printer Port (LPT1)

8 3 System CMOS/Real Time Clock

9* 4 IRQ holder for PCI steering

10* 5 Advance AC’97 CODEC

11* 6 Standard PCI Graphics Adapter (VGA)

12* 7 PS/2 Compatible Mouse Port

13 8 Numeric Data Processor

14* 9 Primary IDE Channel

15* 10 Secondary IDE Channel

*These IRQs are usually available for ISA or PCI devices.

IRQ assignments for this motherboard

ABCDEFGH

PCI slot 1 —————shared ——

PCI slot 2 ——————used —

PCI slot 3 ———————shared

AGP slot shared ———————

Onboard USB controller 1 shared ———————

Onboard USB controller 2 ———shared ————

Onboard USB controller 3 ——used —————

Onboard USB controller 4 shared ———————

Onboard USB 2.0 controller ———————shared

Onboard LAN ———shared ————

Onboard audio —used ——————

Onboard 1394 controller —————shared ——

ASUS P4SD-LA motherboard

Install only +0.8V/+1.5V AGP cards on this motherboard!

PCI slots

There are three 32-bit PCI slots on this motherboard. The slots support PCI cards

such as a LAN card, SCSI card, USB card, and other cards that comply with PCI

specifications.

AGP slot

This motherboard has an Accelerated Graphics Port (AGP) slot that supports

+0.8V AGP 8X and +1.5V AGP 4X cards. When you buy an AGP card, make sure

that you ask for one with +0.8V+1.5V specification.

Note the notches on the card golden fingers to ensure that they fit the AGP slot on

your motherboard.

P4SD-LA

P4SD-LA Accelerated

Graphics Port (AGP8X)

AGP Card without Retention Notch

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Asus Hauptplatine Handbücher

Asus

Asus PCH DR - Motherboard - Extended ATX Bedienungsanleitung

Asus

Asus F1A75-M PRO R2.0 Bedienungsanleitung

Asus

Asus P2L-M Bedienungsanleitung

Asus

Asus STRIX Z270H Gaming Bedienungsanleitung

Asus

Asus P8H77-V LE Bedienungsanleitung

Asus

Asus Motherboard P5VDC-MX Konfigurationshandbuch

Asus

Asus ProArt B660-Creator D4 Bedienungsanleitung

Asus

Asus C8HM70-I Series Bedienungsanleitung

Asus

Asus Motherboard P5LD2 Bedienungsanleitung

Asus

Asus prime B250M-K Bedienungsanleitung

Asus

Asus ROG MAXIMUS XII EXTREME Bedienungsanleitung

Asus

Asus Motherboard A7N8X-VM Kurzanleitung

Asus

Asus P5QD Turbo Bedienungsanleitung

Asus

Asus P5QC - Motherboard - ATX Bedienungsanleitung

Asus

Asus Motherboard P5LD2 Bedienungsanleitung

Asus

Asus Pro Q670M-C Bedienungsanleitung

Asus

Asus STRIX X99 Bedienungsanleitung

Asus

Asus TUF Z390-PRO GAMING Bedienungsanleitung

Asus

Asus H61M-K Bedienungsanleitung

Asus

Asus P8H61-M EVO Gebrauchsanweisung

Asus

Asus ITX 220 - Motherboard - Mini ITX Kurzanleitung

Asus

Asus MAXIMUS VI IMPACT Bedienungsanleitung

Asus

Asus Tinker Board Series Bedienungsanleitung

Asus

Asus SABERTOOTH Z97 MARK 1 Bedienungsanleitung

Beliebte Hauptplatine Handbücher anderer Marken

DFI

DFI SD170 Bedienungsanleitung

ASROCK

ASROCK ROMED8-2T Bedienungsanleitung

Winmate

Winmate IC70 Bedienungsanleitung

Grantech

Grantech SYS8F377VGGA-3OMN Bedienungsanleitung

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Bedienungsanleitung

Texas Instruments

Texas Instruments ADS8372EVM Bedienungsanleitung

Commell

Commell MS-C73 Bedienungsanleitung

Gigabyte

Gigabyte GA-9IVDT Bedienungsanleitung

IBT Technologies

IBT Technologies MB860 Bedienungsanleitung

Nvidia

Nvidia TEGRA DG-04927-001_V01 Bedienungsanleitung

Intel

Intel D33217CK Bedienungsanleitung

EPC

EPC EPC9147C Bedienungsanleitung

EPOX

EPOX MU-8KHA0010 Bedienungsanleitung

Ski-Doo

Ski-Doo Bombardier MPEM 219 700 090 Bedienungsanleitung

Epson

Epson S5U13700P00C000 Bedienungsanleitung

Gigabyte

Gigabyte GA-K8N Ultra-SLI Bedienungsanleitung

Albatron

Albatron PX925XE Series Bedienungsanleitung

Medion

Medion MS-7091 Bedienungsanleitung