Asus pmn Bedienungsanleitung
Pundit P1-PH1
User Guide
Barebone System
ii
Copyright © 2006 ASUSTeK COMPUTER INC. All Rights Reserved.
No part of this manual, including the products and software described in it, may be
reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any
language in any form or by any means, except documentation kept by the purchaser for
backup purposes, without the express written permission of ASUSTeK COMPUTER INC.
(“ASUS”).
Product warranty or service will not be extended if: (1) the product is repaired, modified or
altered, unless such repair, modification of alteration is authorized in writing by ASUS; or (2)
the serial number of the product is defaced or missing.
ASUS PROVIDES THIS MANUAL “AS IS” WITHOUT WARRANTY OF ANY KIND, EITHER
EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES
OR CONDITIONS OF MERCHANTABILITY OR FITNESS FORA PARTICULAR PURPOSE.
IN NO EVENT SHALLASUS, ITS DIRECTORS, OFFICERS, EMPLOYEES OR AGENTS BE
LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES
(INCLUDING DAMAGES FOR LOSS OF PROFITS, LOSS OF BUSINESS, LOSS OF USE
OR DATA, INTERRUPTION OF BUSINESS AND THE LIKE), EVEN IF ASUS HAS BEEN
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES ARISING FROM ANY DEFECT OR
ERROR IN THIS MANUAL OR PRODUCT.
SPECIFICATIONS AND INFORMATION CONTAINED IN THIS MANUALARE FURNISHED
FOR INFORMATIONAL USE ONLY, AND ARE SUBJECT TO CHANGEATANY TIME
WITHOUT NOTICE,AND SHOULD NOT BE CONSTRUED AS A COMMITMENT BYASUS.
ASUS ASSUMES NO RESPONSIBILITY OR LIABILITY FOR ANY ERRORS OR
INACCURACIES THAT MAY APPEAR IN THIS MANUAL, INCLUDING THE PRODUCTS
AND SOFTWARE DESCRIBED IN IT.
Products and corporate names appearing in this manual may or may not be registered
trademarks or copyrights of their respective companies, and are used only for identification or
explanation and to the owners’ benefit, without intent to infringe.
E2346
Revised Edition V2
February 2006
iii
Table of contents
Notices ...........................................................................................vi
Safety information ......................................................................... vii
About this guide............................................................................ viii
System package contents ...............................................................x
Chapter 1: System introduction
1.1 Welcome! ........................................................................... 1-2
1.2 Front panel (external) ......................................................... 1-2
1.3 Front panel (internal) .......................................................... 1-3
1.4 Rear panel.......................................................................... 1-4
1.5 Internal components........................................................... 1-6
1.6 System dimension .............................................................. 1-6
Chapter 2: Basic installation
2.1 Preparation......................................................................... 2-2
2.2 Before you proceed ............................................................ 2-2
2.3 Removing the cover ........................................................... 2-3
2.4 Removing the front panel cover ......................................... 2-4
2.5 Removing the storage drive assembly ............................... 2-4
2.6 Installing a CPU.................................................................. 2-5
2.6.1 Removing the CPU fan and heatsink assembly... 2-5
2.6.2 CPU installation.................................................... 2-6
2.6.3 Reinstalling the CPU fan
and heatsink assembly ......................................... 2-8
2.7 Installing memory modules................................................. 2-9
2.7.1 Overview .............................................................. 2-9
2.7.2 Memory configurations......................................... 2-9
2.7.3 Qualified Vendor List .......................................... 2-10
2.7.4 Installing a DIMM ............................................... 2-10
2.7.5 Removing a DIMM ............................................. 2-13
2.8 Installing PCI cards .......................................................... 2-13
2.8.1 PCI slots............................................................. 2-13
2.8.2 PCI card installation ........................................... 2-13
2.8.3 Configuring an expansion card .......................... 2-15
iv
Table of contents
2.9 Installing optical and storage drives ................................. 2-16
2.9.1 Optical and storage drives installation ............... 2-16
2.9.2 Recommended optical drive dimension ............. 2-18
2.10 Replacing the cover.......................................................... 2-20
2.11 Removing and reinstalling the foot stand ......................... 2-21
2.11.1 Installing the foot stand ...................................... 2-21
2.11.2 Removing the foot stand .................................... 2-23
2.12 Power supply unit information .......................................... 2-23
2.12.1 Voltage selector.................................................. 2-23
2.12.2 Power supply specifications ............................... 2-24
2.13 Connecting devices .......................................................... 2-25
Chapter 3: Starting up
3.1 Installing an operating system............................................ 3-2
3.2 Powering up ....................................................................... 3-2
3.3 Using the system................................................................ 3-2
3.3.1 CompactFlash card slot ....................................... 3-2
3.3.2 Storage card slot .................................................. 3-3
3.3.3 Optical drive ......................................................... 3-3
3.4 Support CD information...................................................... 3-4
3.4.1 Running the support CD....................................... 3-4
3.4.2 Drivers menu........................................................ 3-4
3.4.3 Utilities.................................................................. 3-5
3.4.4 ASUS contact information .................................... 3-6
3.4.5 Other information ................................................. 3-7
Chapter 4: Motherboard information
4.1 Introduction......................................................................... 4-2
4.2 Motherboard layout ............................................................ 4-2
4.3 Jumper ............................................................................... 4-3
4.4 Internal connectors............................................................. 4-4
v
Table of contents
Chapter 5: BIOS setup
5.1 Managing and updating your BIOS .................................... 5-2
5.1.1 ASUS EZ Flash utility........................................... 5-2
5.1.2 Recovering the BIOS with CrashFree BIOS 2 ..... 5-3
5.1.3 ASUS Update....................................................... 5-5
5.2 BIOS Setup program .......................................................... 5-7
5.2.1 BIOS menu bar .................................................... 5-8
5.2.2 Legend bar ........................................................... 5-8
5.3 Main Menu........................................................................ 5-10
5.3.1 System Time ...................................................... 5-10
5.3.2 System Date....................................................... 5-10
5.3.3 Primary IDE Master/Slave; First SATA Master ....5-11
5.3.4 HDD SMART Monitoring .................................... 5-12
5.3.5 Installed Memory................................................ 5-12
5.3.6 Usable Memory .................................................. 5-12
5.4 Advanced Menu ............................................................... 5-13
5.4.1 CPU configuration .............................................. 5-13
5.4.2 Chipset configuration ......................................... 5-14
5.4.3 PCIPnP .............................................................. 5-15
5.4.4 Onboard device configuration ........................... 5-16
5.4.5 USB configuration ............................................. 5-18
5.5 Power menu ..................................................................... 5-19
5.5.1 APM configuration.............................................. 5-20
5.5.2 Hardware Monitor............................................... 5-22
5.6 Boot menu5-23
5.6.1 Boot device priority............................................. 5-23
5.6.2 Removable drives .............................................. 5-24
5.6.3 Hard disk drives ................................................. 5-24
5.6.4 CD-ROM drives.................................................. 5-25
5.6.5 Boot Settings Configuration ............................... 5-26
5.6.6 Security .............................................................. 5-27
5.7 Exit menu ......................................................................... 5-29
vi
Notices
Federal Communications Commission Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with manufacturer’s instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Canadian Department of Communications Statement
This digital apparatus does not exceed the Class B limits for radio noise
emissions from digital apparatus set out in the Radio Interference
Regulations of the Canadian Department of Communications.
This class B digital apparatus complies with Canadian ICES-003.
WARNING! The use of shielded cables for connection of the monitor
to the graphics card is required to assure compliance with FCC
regulations. Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the user’s
authority to operate this equipment.
vii
Safety information
Electrical safety
• To prevent electrical shock hazard, disconnect the power cable
from the electrical outlet before relocating the system.
• When adding or removing devices to or from the system, ensure
that the power cables for the devices are unplugged before the
signal cables are connected.
• If the power supply is broken, do not try to fix it by yourself.
Contact a qualified service technician or your retailer.
Operation safety
• Before installing devices into the system, carefully read all the
documentation that came with the package.
• Before using the product, make sure all cables are correctly
connected and the power cables are not damaged. If you detect
any damage, contact your dealer immediately.
• To avoid short circuits, keep paper clips, screws, and staples
away from connectors, slots, sockets and circuitry.
• Avoid dust, humidity, and temperature extremes. Do not place the
product in any area where it may become wet. Place the product
on a stable surface.
• If you encounter technical problems with the product, contact a
qualified service technician or your retailer.
Lithium-Ion Battery Warning
CAUTION: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by
the manufacturer. Dispose of used batteries according to the
manufacturer’s instructions.
VORSICHT: Explosionsgetahr bei unsachgemäßenAustausch der
Batterie. Ersatz nur durch denselben oder einem vom Hersteller
empfohlenem ähnljchen Typ. Entsorgung gebrauchter Batterien
nach Angaben des Herstellers.
LASER PRODUCT WARNING
CLASS 1 LASER PRODUCT
viii
Safeguards
About this guide
Audience
This guide provides general information and installation instructions about
the ASUS Book size barebone system. This guide is intended for
experienced users and integrators with hardware knowledge of personal
computers.
How this guide is organized
This guide contains the following parts:
1. Chapter 1: System introduction
This chapter gives a general description of the ASUS Book size
barebone system. The chapter lists the system features including
introduction on the front and rear panels, and internal components.
2. Chapter 2: Basic installation
This chapter provides step-by-step instructions on how to install
components in the system.
3. Chapter 3: Starting up
This chapter helps you power up the system and install drivers and
utilities from the support CD.
4. Chapter 4: Motherboard information
This chapter gives information about the motherboard that comes
with the system. This chapter includes the motherboard layout,
jumper settings, and connector locations.
5. Chapter 5: BIOS setup
This chapter tells how to change system settings through the BIOS
Setup menus and describes the BIOS parameters.
ix
Conventions used in this guide
WARNING: Information to prevent injury to yourself when trying to
complete a task.
CAUTION: Information to prevent damage to the components
when trying to complete a task.
IMPORTANT: Information that you MUST follow to complete a task.
NOTE: Tips and additional information to aid in completing a task.
Where to find more information
Refer to the following sources for additional information and for product
and software updates.
1. ASUS websites
The ASUS websites worldwide provide updated information on ASUS
hardware and software products. Refer to the ASUS contact
information.
2. Optional documentation
Your product package may include optional documentation, such as
warranty flyers, that may have been added by your dealer. These
documents are not part of the standard package.
x
System package contents
Check your book size barebone system package for the following items.
1. ASUS book size barebone system with:
• ASUS motherboard
• CPU fan and heatsink assembly
• CompactFlash card reader
• 3-in-1 storage card reader
• PCI riser card
• 250W power supply unit
2. Cables
• Power cable and plug
• Serial ATA power cable and signal cable
• IDE cable (one preinstalled)
3. CDs
• Support CD
• Recover PRO CD
4. Quick Installation Guide
If any of the items is damaged or missing, contact your retailer
immediately.
Dieses Handbuch passt für folgende Modelle
3
Inhaltsverzeichnis
Andere Asus Server Handbücher
Asus
Asus AP100 Bedienungs- und Wartungshandbuch
Asus
Asus RS300-E9-RS4 Bedienungsanleitung
Asus
Asus Pedestal/5U Rackmount Server TS500-E4 Server Bedienungsanleitung
Asus
Asus RS720-E8-RS24-ECP Bedienungsanleitung
Asus
Asus RS720A-E9-RS24-E Bedienungsanleitung
Asus
Asus RS320Q-E7 RS12 Bedienungsanleitung
Asus
Asus RS720A-E9-RS24V2 Bedienungsanleitung
Asus
Asus 1U Rackmount Barebone Server RS120-E3 (PA4) Bedienungsanleitung
Asus
Asus RS162-E4 RX4 Bedienungsanleitung
Asus
Asus AP140R Bedienungsanleitung
Asus
Asus AP1400R Bedienungsanleitung
Asus
Asus DSBF-D16 SAS Bedienungsanleitung
Asus
Asus AP6000 Bedienungs- und Wartungshandbuch
Asus
Asus RS260-E4 RX8 Bedienungsanleitung
Asus
Asus RS700D-E6/PS8 - 0 MB RAM Bedienungsanleitung
Asus
Asus RS300-E7/PS4 Bedienungsanleitung
Asus
Asus KFN5-D SLI Administratorhandbuch
Asus
Asus RS720-E9-RS24-E Bedienungsanleitung
Asus
Asus RS500A-E10 Series Bedienungsanleitung
Asus
Asus RS740-E70RS24-EG Bedienungsanleitung
