AT&T EL51109 Bedienungsanleitung

Quick start guide

EL51109

DECT 6.0 cordless telephone

with caller ID/call waiting

Installation

Install the telephone base close to a telephone jack and a power outlet not

controlled by a wall switch. For optimum range and better reception, place

the telephone base in a central and open location.

If you subscribe to high-speed Internet service (digital subscriber line - DSL)

through your telephone line, you must install a DSL filter between the

telephone line cord and the telephone wall jack (see the following page). The

filter prevents noise and caller ID problems caused by DSL interference.

Please contact your DSL service provider for more information about DSL

filters.

Your product may be shipped with a protective sticker covering the handset or

telephone base display - remove it before use.

For customer service or product information, visit our website at

www.telephones.att.com or call 1 (800) 222-3111. In Canada, dial

1 (866) 288-4268.

Avoid placing the telephone base too close to:

• Communication devices such as: television sets, VCRs, or other cordless

telephones.

• Excessive heat sources.

• Noise sources such as a window with traffic outside, motors, microwave

ovens, refrigerators, or fluorescent lighting.

• Excessive dust sources such as a workshop or garage.

• Excessive moisture.

• Extremely low temperature.

• Mechanical vibration or shock such as on top of the washing machine or

workbench.

Battery installation & charging

Install the battery as shown on the next page. Once you have installed the

battery, the screen indicates the battery status (see table below). If necessary,

place the handset in the telephone base to charge the battery. For best

performance, keep the handset in the charger when not in use. The battery is

fully charged after 16 hours of continuous charging. See the table on the

Technical specifications page of the user's manual for battery

operating times.

If the screen is blank, you need to charge the handset without interruption for

at least 10 minutes to give the handset enough charge to use the telephone

for a short time. The screen shows LOW BATTERY and the backlight is off until

you have charged the battery without interruption for at least one hour. The

following table summarizes the battery charge indicators and actions to take.

Battery indicators Battery status Action

The screen is blank. Battery has no charge

and the handset

cannot be used.

Charge without

interruption until the

screen shows LOW

BATTERY (at least 10

minutes).

The screen shows

PLACE IN CHARGER

and flashes

Battery has very little

charge and the handset

cannot be used.

Charge without

interruption until the

screen shows LOW

BATTERY (at least four

minutes).

The screen shows LOW

BATTERY and flashes.

Battery has enough

charge to be used for a

short time.

Charge without

interruption until the

screen shows HANDSET

(at least one hour).

The screen shows

HANDSET.

Battery is charged. To keep the battery

charged, place it in the

telephone base or

charger when not in use.

NOTE: If you are on a phone call in low battery mode, you hear four short beeps

every minute.

Battery installation & charging

IMPORTANT INFORMATION

Use only the supplied rechargeable battery or replacement battery (model BT8001).

To order, visit our website at www.telephones.att.com, or call

1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.

Step 1

Plug battery connector

securely into the socket

inside the handset battery

compartment, matching

the color-coded label.

Insert the supplied battery

with the label THIS SIDE

UP facing up as indicated.

Step 2

Align the cover flat

against the battery

compartment, then

slide it upwards

until it clicks into

place.

Step 3

Charge the handset by

placing it face up in the

telephone base. The

CHARGE light is on when

charging.

To replace the battery, press the tab and slide the

battery compartment cover downwards. Lift out the

old battery and disconnect it from the handset.

Follow the instructions above to install and charge

the new battery.

CHARGE light

Telephone base installation

Install the telephone as shown below. The telephone base is ready for table

use.

IMPORTANT INFORMATION

1. Use only the power adapter supplied with this product. To order a replacement

power adapter, visit our website at www.telephones.att.com, or call

1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.

2. The power adapter is intended to be correctly oriented in a vertical or floor mount

position. The prongs are not designed to hold the plug in place if it is plugged into

a ceiling, under-the-table or cabinet outlet.

1. Plug one end of

the telephone

line cord into

the telephone

jack on the

bottom of the

telephone base.

2. Plug the small

end of the AC

power adapter

into the power

jack on the

bottom of the

telephone base.

If you have DSL high speed

Internet service, a DSL filter

(not included) is required.

5. Plug the other end

of the telephone

line cord into a

telephone jack or a

DSL filter.

4. Plug the large end

of the AC power

adapter into a

power outlet not

controlled by a wall

switch.

3. Route the power

adapter cord

through the slot.

Telephone line cord

Quick reference guide - handset

SDIR/VOLUME

Press DIRSto show directory

entries when the phone is not in

use.

Press to scroll up while in

menus. Press SVOLUME to

increase the volume level during

a call.

CHARGE light

The charge light is on when the

handset is charging.

REDIAL/PAUSE

Press repeatedly to view the last

five numbers dialed.

While entering numbers, press

and hold to insert a dialing

pause.

SPEAKER

Press to turn on the handset

speakerphone, press again to

resume normal handset use.

MENU/SELECT

Press to display the menu. Once

in the menu, press to select an

item or save an entry or setting.

OFF/CLEAR

Press and hold while the

telephone is not in use to erase

the missed calls indicator.

During a call, press to hang up.

While using menus, press to

cancel an operation, back up to

the previous menu, or exit the

menu display.

MUTE

During a call, press to mute

microphone.

DELETE

While reviewing the caller ID

history, or the directory, or the

redial memory, press to delete

an individual entry.

While predialing, press to delete

digits.

While reviewing a call log entry,

press repeatedly to add or

remove 1 in front of the

telephone number before dialing

or saving it in the directory.

Press repeatedly to display

other dialing options when

reviewing a call log entry.

TCID/VOLUME

Press TCID to show caller ID

information when the phone is

not in use.

Press to scroll down while in

menus. Press TVOLUME to

decrease the volume level

during a call.

PHONE/FLASH

Press to make or answer a call.

During a call, press to answer an

incoming call when you receive

a call waiting alert.

Quick reference guide - handset & telephone base

IN USE indicator

On when the handset is

in use.

Flashes when another

telephone is in use on

the same line.

Flashes quickly when

there is an incoming call.

VOICEMAIL indicator

Flashes when you have

new voicemail.

Voicemail service is

offered by your local

telephone company.

HANDSET LOCATOR

Press to make handset

beep so you can locate

it.

Main menu

Beliebte Schnurloses Telefon Handbücher anderer Marken

3Com

3Com NBX Bedienungsanleitung

Panasonic

Panasonic KX-TGK210HK Bedienungsanleitung

Panasonic

Panasonic KX-TCA181EX Bedienungsanleitung

BT FREESTYLE 3200 Bedienungsanleitung

BREZZICNI

BREZZICNI CL-3622 Bedienungsanleitung

Panasonic

Panasonic KX-TG1831NZ Bedienungsanleitung

Panasonic

Panasonic KX-TG7301E Bedienungsanleitung

Sanyo

Sanyo CLT-J70 Bedienungsanleitung

Amplicomms

Amplicomms BigTel 201 Bedienungsanleitung

GE 26992 Bedienungsanleitung

Sanyo

Sanyo CLT-670 Bedienungsanleitung

GE 15432970 Bedienungsanleitung

Curtis

Curtis TC595 Bedienungsanleitung

Gigaset

Gigaset Gigaset 3000 Micro Bedienungsanleitung

Poly

Poly VVX D230 Einrichtungshandbuch

Panasonic

Panasonic KX-TGP700 Bedienungsanleitung

GE 27930 Bedienungsanleitung

Radio Shack

Radio Shack 43-3557 Bedienungsanleitung