Important Safety Instructions
1. For toxic vapors produced by spraying certain materials can create intoxication
and serious damage to health. Always wear safety glasses, gloves and
respirator to prevent the toxic vapor hazard, solvent and pointing paint coming
into contact with your eyes or skin.
2. Never use oxygen, combustible or any other bottle gas as a power source or
would cause explosion and serious personal injury.
3. Fluid and solvent can be highly flammable or combustible. Please Use the tool
only in well-ventilated area, and avoid any ignition sources, such as smoking,
open flames and decrial hazard.
4. Disconnect paint gun from air supply hose before doing tool maintenance and
during non-operation, for emergency stop and prevention of unintended
operation, a ball valve near the gun to air supply is recommend.
5. Use clean, dry and regulate compressed air rated at 3.0~4.0bar, never exceed
maximum permissive operating pressure 8.3 bar(120psi).
6. Never use homogenate hydrocarbon solvent, which can chemically react with
aluminum and zinc parts and chemically compatible with aluminum and zinc
parts.
7. Never point gun at yourself or others at any time.
8. Before operating the paint gun, ensure all the screws & caps are securely tightened to prevent leaking.
9. Before painting, make inspection for free movement of trigger and nozzle to insure tool can operate well.
10. Never modify this paint gun for any applications. Only use parts, nozzles and accessories recommended
by the manufacturer.
Instructions for Operation
Preparation
1. After unpacking the paint gun, inspect carefully for any damage that may have occurred during transit.
Make sure to tighten fittings, bolts, etc., before putting unit into service.
2. Thoroughly mix and thin paint in accordance with the paint manufacturer’s instructions. Most materials
will spray readily if thinned properly.
3. Strain material through filter, cheese cloth or a paint strainer.
4. Fill the canister about ¾ full and start the air compressor.
WARNING Do not exceed Maximum Pressure of Spray Gun or any other parts in the compressor system.
5. After connecting the gun to the air supply, please make sure that the fluid cap, container and air hose
have been connected tightly to the spray gun.
6. Set up a piece of cardboard or other scrap material to use as a target and adjust for best spray pattern.
WARNING Never aim or spray at yourself or anybody else as it could cause serious injury.
7. Test the consistency of the material by making a few strokes on a cardboard target. If material still
appears too thick, add a small amount of thinner. THIN WITH CARE! Do not exceed paint
manufacturer’s thinning recommendations.
