6. Clear floor of all debris and dust
7. Apply supplied construction adhesive liberally to the webbed
support rings
8. Install base in final position, ensuring that it is level
9. The inside face of the upstand must be close to flush with the
inside face of the wall board.
10. Screw the upstand of the shower base back to the extra nogging.
11. Allow suitable time for the base adhesive to cure. Keep the
shower base surface free of dust and dirt prior to the application
of your interlayer/waterproofing/tiles to the base.
12. Insert the inner ring through the waste outlet in the shower base
and screw the inner ring into the waste body. Hand tighten using
the installation key.
13. Place the waste cup and Easy Clean component (not pictured) into
position within the inner ring.
