QUICK START MANUAL
Specifications are subject to change without notice
www.AtlasSound.com
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435
© 2007 ATLAS SOUND LP Printed in U.S.A. ATS002744 RevA 3/07 3
ASP-MG24
3. After both programs are installed you need to find out which comport in your computer is assign to use with
the ASP-MG24 generator. Turn on the ASP-MG24, the Blue power LED should be on. Next, connect a USB
cable from the ASP-MG24 to your computer. Note: A prompt on your computer should pop up and say
“New USB Device Found”. Click on it and tell it to locate the USB driver automatically. After the computer
matches the computer to the USB driver it must find which COM Port it was assigned to.
Note: If the ASP-MG24 is not connected to your computer, it will not indicate a COM Port.
4. Finding the assigned COM Port. Follow these steps from your Windows desk top screen. Note: Your Control
Panel window may appear "Category" view. It is easier to operate in "Classic: view. To do so, click on the tab
on the left side of the screen that says "Switch to Classic View", then follow the steps below.
• 1. Start, 2. Control Panel, 3. System, 4. Hardware, 5. Device Manager, 6. Scroll to “Ports (Com &
LPT)”. Click on the “+” sign and listed should be “CP210x USB to UART to Controller”, followed by
the assigned COM Port number. In this case it was COM6.
