Attwood 5095 Bedienungsanleitung

12-Volt 1-Mile Bi-Color

Pole Light with Task Light

5095

Installation Instructions

Attwood marine hardware, navigational lighting, bilge pumps, and

other marine accessories are specified more than any other brand by

America’s best-known boat manufacturers as original equipment.

Look to Attwood for quality replacement parts and marine accessories.

SAVE THESE INSTRUCTIONS

Form Number 69383 Rev. B 03-10

POLE LIGHT INSTALLATION

CAUTION:

All positive (+12V DC) wires must be fused to protect your circuits

and vessel. The Combination Light requires a 1-amp fuse. The Task

Light requires a 1-amp fuse and separate wire circuit. The aluminum

pole of the Universal Fit Light is not connected to an electrical

ground. (Figure 2)

1. Insert pole into base, aligning screw with slot in base.

2. Press down firmly to engage electrical connectors.

3. Slide locking collar down to base, rotate until lower ring can be

inserted inside top of base.

4. Press down into base and rotate until locking collar tightens

between pole and base.

NOTE:

Periodically check pole to make sure it is secure.

5. To remove light, rotate locking collar in opposite direction until it

loosens, then pull up on pole. (Figure 3)

After installation, activate lights to verify proper operation. Navigation

light regulations require lights to be operated with a three-position

switch that provides for:

•Running lights (combination light and all-round light).

•Anchor lights (all-round light only).

•Off.

•Check the Task Light by pressing on switch at rear of light to turn

Task Light on. (Figure 4)

FEATURES

The Attwood 12-Volt, 1-Mile Navigation Combination Lights for boats

to 39.6 ft. (12 meters) incorporate a separately switched Task Light.

They feature impact resistant, UV-stable polycarbonate housings.

Certification: Bi-Color, 12-Volt, Sidelight with Tasklight.

Meets USCG CFR 183.810, ABYC A-16 requirements, and all applicable

standards as tested by Imanna Labs on 1/13/2003. 1 Nautical Mile

visibility. Uses 9235 #906 Lamp, 13V, 6 Candle Power.

REQUIRED FOR INSTALLATION

• Cordless drill with 1/8" (3mm), 3/8" (10mm) and 3/4" (19mm) bits.

• Screwdriver.

• Three #8 or #10 stainless pan head screws per light.

• Non-silicone sealant.

WARNING:

To prevent personal injury, always disconnect the power source

when installing or servicing this product. Always remove the boat

from the water before using 120V AC power tools.

LOCATION

Lights must be mounted to an unobstructed smooth surface on the

gunwale, deck or superstructure. Locate Bi-Color Combination Light

in an area as far forward as possible. (Figure 1)

STANDARD 3-PIN BASE WIRING CONFIGURATION

For proper operation, the base that will accept the pole light must be

wired as in Figure 2.

Figure 1 Figure 2

Red Green

White

•

Locking Collar •

Lower Ring •

Screw

•

To +12-Volt

Navigation

Light Switch

•

To -12-Volt

Battery

•

To +12-Volt

Circuit with Fuse

(Powered Constantl

)

Figure 3

NOTE:

Navigation light poles are designed to support only the light. They

should never be used as flag poles or handles.

MAINTENANCE

When not in use, always store pole light in Pole Light Storage Clips

(Attwood 7571). Choose a storage location where it will not be damaged

or be in constant contact with water. Close the base cover when light

is stowed to protect the contacts and seal the deck.

Replacing Bulb

1. Twist lens helmet 1/4 turn counter-clockwise to remove.

2. Replace Navigation Light bulb with 9-Watt Wedge Base

Replacement Bulb (Attwood 9235).

3. Re-seat lens helmet and twist 1/4 turn clockwise until it clicks in

place. (Figure 4)

Task Light lamp is not serviceable. Clean the light with a mild soap

and warm water solution. Never use solvents or abrasives that may

damage the lens or housing of the Universal Fit Light.

ATTWOOD LIMITED WARRANTY

ATTWOOD CORPORATION, 1016 North Monroe, Lowell, Michigan

49331 (“Attwood”) warrants to the original consumer purchaser that

Attwood brand products will be free from defects in materials and

workmanship under normal use and service for one year from the

date of original consumer purchases.

This limited warranty is not applicable if the product has been damaged

by accident, improper installation, unreasonable or improper use, lack

of proper maintenance, unauthorized repairs or modifications, normal

wear and tear, or other causes not arising out of defects in materials

or workmanship.

Attwood products are warranted for use on pleasure boats. Any other

use — including but not limited to commercial, racing, or non-marine

use — are not covered under this warranty. Attwood’s obligation under

this warranty is limited to repair of the product at Attwood’s plant or

replacement of the products at Attwood’s option without expense

to the original consumer purchaser. Any expenses involved in the

removal, reinstallation or transportation of the product are not

covered by this warranty.

The product must be returned to Attwood’s plant at the address

above, postage prepaid, and insured with proof of original purchase

including date.

If Attwood is unable to replace the product and repair is not commer-

cially practical or cannot be timely made, or if the original consumer

purchaser is willing to accept a refund in lieu of repair or replacement,

Attwood may refund the purchase price, less an amount for deprecia-

tion. The acceptance by Attwood of any product returned or any refund

provided by Attwood shall not be deemed an admission that the product

is defective or in violation of any warranty. Products that are replaced

or for which a refund is issued become the property of Attwood.

THIS WARRANTY IS ATTWOOD’S ONLY EXPRESS WARRANTY

OF THIS PRODUCT. NO IMPLIED WARRANTY SHALL EXTEND

BEYOND ONE (1) YEAR FROM THE DATE OF ORIGINAL CON-

SUMER PURCHASE. ATTWOOD SHALL NOT BE LIABLE FOR

ANY DAMAGES FOR LOSS OF USE OF THIS PRODUCT, NOR

FOR ANY OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES,

COSTS OR EXPENSES.

Some states do not allow limitations on how long an implied warranty

lasts or the exclusion or limitation of incidental or consequential

damages, so the above limitations and exclusions may not apply to

you. This warranty gives you specific legal rights, and you may have

other rights which vary from state to state.

Figure 4

Off

Lens Helmet

•

Bulb #906

•

Lens Bayonet

Channels

•

Press Here

•

Task Light

Bulb

•

1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com

Andere Attwood Schiffsbeleuchtung Handbücher

Attwood

Attwood 3592 Bedienungsanleitung

Attwood

Attwood 91041 Bedienungsanleitung

Attwood

Attwood 66318 Bedienungsanleitung

Attwood

Attwood 3830 Bedienungsanleitung

Attwood

Attwood 7800 Series Bedienungsanleitung

Attwood

Attwood 6510SS1 Bedienungsanleitung

Attwood

Attwood 6350 Series Bedienungsanleitung

Attwood

Attwood 6510 Series Bedienungsanleitung

Attwood

Attwood 6320 Series Bedienungsanleitung

Attwood

Attwood 3800 Series Bedienungsanleitung

Attwood

Attwood 6375D Bedienungsanleitung

Attwood

Attwood Quasar 3200 Bedienungsanleitung

Attwood

Attwood 6356D Bedienungsanleitung

Attwood

Attwood 6340 Series Bedienungsanleitung

Attwood

Attwood 3560 Bedienungsanleitung

Attwood

Attwood Pulsar 5040 Bedienungsanleitung

Attwood

Attwood 5100 Series Bedienungsanleitung

Attwood

Attwood 3500 Series Bedienungsanleitung

Attwood

Attwood 14060 Bedienungsanleitung

Attwood

Attwood 5530 Series Bedienungsanleitung

Attwood

Attwood 91020 Bedienungsanleitung

Attwood

Attwood 911339 Bedienungsanleitung

Attwood

Attwood 5550 Series Bedienungsanleitung

Attwood

Attwood 7200 Series Bedienungsanleitung

Beliebte Schiffsbeleuchtung Handbücher anderer Marken

Francis Searchlights

Francis Searchlights FX560 Bedienungsanleitung

Glamox

Glamox aqua signal TX20 Series Bedienungsanleitung

Imtra

Imtra BCM California 60 Bedienungsanleitung

Sealite

Sealite SL60 Beilage

Hella marine

Hella marine NAVILED PRO 2NM Bedienungsanleitung

ACR Electronics

ACR Electronics 3940 Montageanleitung

ETI Solid State Lighting

ETI Solid State Lighting 504081020 Bedienungsanleitung

Sea gull lighting

Sea gull lighting Traverse Lyte Retrofit Kit Bedienungsanleitung

Sealite

Sealite SL-15 Beilage

Daniamant

Daniamant W3-1 Bedienungsanleitung

Tranberg

Tranberg TEF 2438N Bedienungsanleitung

Weems & Plath

Weems & Plath 700 Bedienungsanleitung

Hella marine

Hella marine NaviLED 360 2LT 980 960-0 Series Bedienungsanleitung

Hella marine

Hella marine NaviLED 360 PRO 2LT 980 910 Series Bedienungsanleitung

Hurley Marine

Hurley Marine LED Sea-Vue Bedienungsanleitung

Sealite

Sealite SL-300-2D5 Series Beilage

ACR Electronics

ACR Electronics MS-2000(M) Montageanleitung

Sealite

Sealite SLC600 Beilage