Atwood LPCO Betriebsanleitung

Atwood Mobile Products LLC

1120 North Main Street Elkhart, IN 46614-3203

USA : 800-546-8759

USA & Canada 800-825-4328

Internet: http://www.atwoodmobile.com

Models LPCO

USER’S MANUAL AND INSTALLATION INSTRUCTIONS

TESTED TO UL2034, UL1484 AND CSA 6.19

For questions concerning your Alarm, please call our Customer

Service at 1-800-546-8759

Please have the following information ready when calling:

Alarm Model Number (located on the back of alarm):

Alarm Assembly Number (located on the back of alarm):

Date of Manufactured (located on the bottom of alarm):

Date of Purchase:

Where Purchased:

P/N 30094 Rev

6/12

CARBON MONOXIDE AWARENESS............................................................................ 3

LIQUEFIED PETROLEUM GAS AWARENESS ............................................................ 4

ACTIVE ALARM PROCEDURES................................................................................... 6

TESTING ......................................................................................................................... 8

MODEL DESCRIPTION .................................................................................................. 9

SPECIFICATIONS........................................................................................................... 9

POWER CONSERVATION MODE.........................................................................................10

ALARM OPERATION ................................................................................................... 10

Power Off Mode.....................................................................................................................10

Normal Gas Detection Mode ................................................................................................10

Alarm Active Mode................................................................................................................11

Alarm Test Mode ...................................................................................................................11

Alarm Reset / Stabilization Mode.........................................................................................11

Fault Mode.............................................................................................................................11

FUNCTIONS.................................................................................................................. 12

INSTALLATION INSTRUCTIONS ................................................................................ 13

WIRING.......................................................................................................................... 15

SURFACE MOUNTING BOX........................................................................................ 16

Surface Mounting..................................................................................................................17

Flush Mounting .....................................................................................................................18

AC Power Adapter Mounting...................................................................................... 19

OPERATING INSTRUCTIONS ..................................................................................... 19

DETECTOR TEST......................................................................................................... 19

LP GAS DETECTION.................................................................................................... 19

POWER MANAGEMENT.............................................................................................. 20

Low Power Warning Mode ...................................................................................................20

Power conservation Mode: ..................................................................................................21

Low Power Alarm Mode: ......................................................................................................21

Power Failure ........................................................................................................................21

End of Life .................................................................................................................... 22

TROUBLESHOOTING QUICK-GUIDE......................................................................... 22

WARRANTY.................................................................................................................. 25

READ ENTIRE MANUAL BEFORE USING THIS ALARM

Your new Atwood Carbon Monoxide and Propane (CO/LP) alarms are sophisticated

instruments that has been carefully designed and tested to detect CO and LP build

up in a residential or recreation vehicle environment.

Carbon Monoxide (CO) and Liquefied Petroleum (LP or Propane) gases can cause

hazardous conditions when found in high concentrations. Both gases are known to

be found in recreational vehicles and the proper detection of these gases provides

a safe environment for the occupants of the vehicle.

CARBON MONOXIDE AWARENESS

The following are the symptoms of Carbon Monoxide poisoning and must be

discussed with all occupants of the vehicle.

1. Mild Exposure: Slight headache, nausea, vomiting, fatigue (“Flue like

symptoms).

2. Medium Exposure: Severe throbbing headache, drowsiness, confusion, fast

heart rate.

3. Extreme Exposure: Unconsciousness, convulsions, heart and lung failure,

brain damage, and death.

Many cases of reported CARBON MONOXIDE POISONING indicate that while

victims are aware they are not well, they become so disoriented they are unable to

save themselves by either exiting the building or calling for assistance. Young

children and house hold pets are typically the first affected. This device does not

provide warnings for all levels of CO. Individuals with certain medical conditions

may consider using a warning device that provides both audible and visual signals

for carbon monoxide concentrations below 30 ppm. Everyone is susceptible to the

danger of CO, but experts agree that unborn babies, small children, pregnant

women, senior citizens and people with heart or respiratory problems are at the

highest risk for serious injury or death.

If you experience ANY symptoms of CO poisoning, consult your physician.

Be aware that the following conditions can result in transient CO situations, such

as:

1. Excessive spillage or reverse venting of fuel burning appliances caused by:

•

Outdoor ambient conditions such as wind direction and/or velocity, including

high gusts of wind; heavy air in the vent pipes (cold/humid air with extended

periods between cycles).

•

Negative pressure differential resulting from the use of exhaust fans.

•

Simultaneous operation of several fuel burning appliances competing for

limited internal air.

•

Vent pipe connection vibrating loose from clothes dryers, furnaces, or water

heaters.

•

Obstructions in or unconventional vent pipe designs which amplify the

above situations.

2. Extended operation of un-vented fuel-burning devices (range, oven, fireplace,

etc.

3. Temperature inversions which can trap exhaust gasses near the ground.

4. Car idling in an open or closed attached garage, or near a home.

LIQUEFIED PETROLEUM GAS AWARENESS

LP gas is commonly called Propane and is sold commercially as a suitable fuel in

portable and permanent heating and cooking appliances.

It is important to detect LP gas due to its explosiveness at concentrated volumes.

The lowest explosive limit for LP concentration is 21,000 parts per million (ppm).

This detector was designed to alarm at 10% of this limit or 2100 ppm.

SAFETY ALERT SYMBOLS

Safety symbols alerting you to potential personal safety hazards,

Obey all safety messages following these symbols.

CAUTION

This alarm will only indicate the presence of gas at the sensor. Gases may be

present in other areas. Read this entire manual before using the alarm.

WARNING

Avoid possible injury or death

WARNING

Actuation of your CO alarm indicates the presence of carbon monoxide (CO)

which can KILL YOU.

WARNING

This product is intended for us in ordinary indoor locations of family living units. It is

not designed to measure compliance with Occupational Safety and Health

Administration (OSHA) commercial or in

dustrial standards.

CAUTION

Avoid possible injury and/or property

damage

ACTIVE ALARM PROCEDURES

IF ALARM SIGNAL SOUNDS:

1. Operate Reset/silence button;

1. Immediately move to fresh air-outdoors or by an open door/window. Do a head

count to check that all persons are accounted for: Do not reenter the premises

nor move away from the open door/window until the emergency services

responders arrive, the premises have been aired out, and your alarm returns to

its normal condition?

2. Call your local Emergency Services Number or 911

( )

Fill in your local Fire Department number here

3. After following steps 1-3, if your alarm reactivates within a 24 hour period,

repeat steps 1-3 and call a qualified appliance technician

( )

to investigate for sources of CO and LP from fuel burning equipment and

appliances, and inspect for proper operation of this equipment. If problems are

identified during this inspection, have equipment serviced immediately. Note

any combustion equipment not inspected by technician consult the

manufacturers Instructions, or contact the manufacturers directly, for more

information about CO and LP safety. Make sure that motor vehicles are not, or

have not been operating in an enclosed area or in close proximity of other

vehicles.

Note: two self adhesive emergency contact tables are provided. The user must

add telephone numbers for the local emergency service provider and for a

qualified service technician. User must place one label next to the alarm. The

other label must be placed near a source of fresh air where you plan to gather

in the event the alarm indicates carbon monoxide presence.

WHAT TO DO IF YOU SMELL GAS

•

Evacuate all persons from vehicle.

•

Shut off gas supply at gas container or source.

•

Do not touch any electrical switch, or use any phone or radio in vehicle.

•

Do not start vehicle’s engine or electric generator.

•

Contact nearest gas supplier or qualified Service Technician for repairs.

•

If you cannot reach a gas supplier or qualified Service Technician, contact the

nearest fire department.

•

Do not run on gas supply until gas leak(s) has been repaired.

WARNING

Activation of this device indicates the presence of LP gas, which can cause an

explosion and/or fire. This normally indicates a leak in the LP gas piping or an LP

gas appliance.

WARNING

Test Alarm operation after vehicle has been in storage, before each trip, and at

least once per week during use.

WARNING

:If the information in this manual is not followed exactly, a fire or

explosion may result c

ausing property damage, personal injury or loss of life.

TESTING

Note: Unit must be powered for three minutes before test can be performed.

The Test/Rest button is used to verify proper alarm operating. Executing the test

function sounds the alarm and lights up all LED's. The test will sound the alarm

twice, with 4 “beeps” in 1 second followed by 5 seconds of silence.

By pressing the button, you can verify that the alarm sounds and that all visual

indicators function properly. The alarm is internally monitored while powered to

ensure proper operation and to detect faults.

Important

•

This detector will only indicate the presence of CO or LP gas at the sensor.

Gases may be present in other areas.

•

The detector is not suitable as a smoke or fire detector. Not suitable for

installation in hazardous locations as defined in the National Electrical Code.

WARNING

Test Detector operating after vehicle has been in storage, before each trip, and at

least once per week during use.

MODEL DESCRIPTION

LP=Propane CO=Carbon Monoxide D=12Vdc A=120Vac O=OEM R=Retail

OEM Package Retail Package

Model Part No Color Model Part No Color

LPCO_DOW 36636 White LPCO_DRW 36681 White

LPCO_DOB 31011 Black LPCO_DRB 31012 Black

LPCO_AOW 36520 White LPCO_ARW 36521 White

LPCO_AOB 31003 Black LPCO_ARB 31004 Black

Surface Box 31128 Black Surface Box 36689 White

SPECIFICATIONS

LP CO

Alarm Level: 2100 ppm for 10

seconds

70 ppm for 60 to 240 minutes

150 ppm for 10 to 50 minutes

400 ppm for 4 to 15 minutes

Audio Alarm Min. 85 dB at 10 Feet

Visual Alarm LP blinking red LED and

Chirping

CO blinking red LED and

Chirping

Malfunction Red Fault LED on and chirping sound

Sensor End of Life

Alarm Blinking red LED’s and Chirping

Dimensions 3-9/16” H X 3-7/16” W

Supply Voltage

Thresholds 9 to 18 VDC (13.5 V nominal)

Supply Current (Max) 75 am

Supply Current

(Typical) 40 mA

IAS Tested @ 67% to 133% of supply voltage

Current Draw Typical 70 mA – Alarm 100 mA

POWER CONSERVATION MODE

Current Draw 10 mA

Temperature -40°to 70°C (-40°to 158°F)

Storage Temperature -40°to 70°C (-40°to 158°F)

Humidity 15 to 90%

Warranty Limited, 2 year

Alarm Lifetime 7 years ( powered operation)

Standards ETL tested to UL 2034 & UL 1484 Residential and RV and

Complies with CSA 6.19

For Service and Information Contact

Atwood Mobile Products LLC, 1874 South Pioneer Road Salt Lake City, Utah 84104-4226

Consumer Service Department, 1120 North Main, Elkhart, IN 46514 USA.

Phone: 866-869-3118

ALARM OPERATION

The alarm includes four LED indicators, an LP, CO and LPCO oscillating multi-tone

audible alarms, and one Test/Reset button that provide interaction and feed back

with your alarm. The indicators allow you to troubleshoot your alarm and to

determine the proper actions to take. The visual indicators are labeled Power, Fault,

Carbon Monoxide, and Propane.

The alarm operates in six separate modes that will be identified in this section.

Power Off Mode

This mode indicates that there is insufficient power provided to the alarm. The

indicators and button will not function in this mode. Sufficient power must be

provided to the alarm to exit this mode.

Normal Gas Detection Mode

This mode indicates that gas concentrations are continuously monitored. It also

indicates that gas concentrations are at safe levels. In this mode the Power

indicator will be lit, and all other indicators will not be active. The Test function for

the Test/Reset button will be active.

Andere Handbücher für LPCO

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Atwood Sicherheitssystem Handbücher

Atwood

Atwood LPCO Bedienungsanleitung

Beliebte Sicherheitssystem Handbücher anderer Marken

Inner Range

Inner Range Concept 2000 Bedienungsanleitung

Climax

Climax Mobile Lite R32 Montageanleitung

CADDX

CADDX NX-6 Bedienungsanleitung

FBII

FBII XL-31 Series Bedienungsanleitung

Johnson Controls

Johnson Controls PENN Connected PC10 Bedienungsanleitung

Aeotec

Aeotec Siren Gen5 Bedienungsanleitung

Blaupunkt

Blaupunkt SA 2700 Bedienungsanleitung

IDEAL

IDEAL Accenta Betriebsanleitung

AJAX

AJAX DoubleButton Bedienungsanleitung

Swann

Swann SW-P-MC2 Bedienungsanleitung

Ecolink

Ecolink Siren+Chime Bedienungsanleitung

Digital Monitoring Products

Digital Monitoring Products XR150 Bedienungsanleitung

EDM

EDM Solution 6+6 Wireless-AE Bedienungsanleitung

Highway Safety Group

Highway Safety Group EA401 Bedienungsanleitung

Siren

Siren LED GSM Bedienungsanleitung

Detection Systems

Detection Systems 7090i Montageanleitung

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Bedienungsanleitung

Siemens

Siemens FDM273 Bedienungsanleitung