Audiovox CNP2000UCA Bedienungsanleitung

PROTOCOL INTERFACE ADAPTER

and XM DIRECT 2 TUNER

CNP2000UCA

“Compatible with Satellite

Ready Car Stereos”

Installation Guide

Table of Contents

Table of Contents ................................................................................................2

Introduction & Installation Overview ..........................................................3

Installation Basics .......................................................................................4

Installation Planning .................................................................................4

Antenna Installation .............................................................................4

Cable Routing .........................................................................................5

Tools Required ........................................................................................6

Installation Procedure .....................................................................6

Completing Activation .............................................................................8

XM Satellite Radio Operation ................................................................9

XM Radio ID .............................................................................................9

Troubleshooting.................................................................................................10

No Sound ....................................................................................................10

Advisory Message ....................................................................................10

Antenna ..................................................................................................10

Updating ................................................................................................10

No Signal ................................................................................................10

O Air ......................................................................................................11

Loading ...................................................................................................11

No Info .....................................................................................................11

“CH---” ......................................................................................................11

Other Symptoms .................................................................................11

Warranty .............................................................................................................12

TableofContents

Thank you for purchasing the AUDIOVOX Protocol Interface Adapter for satellite

radio ready car stereo head units. The Protocol Interface Adapter allows you

to adapt a satellite radio ready car stereo to receive XM Satellite Radio service.

The PIA is easy to install plugging directly into the car stereo head unit*. The

illustration below shows the installation of the XM Direct system, including

the XM Direct 2 Tuner and the antenna.

*Professional installation is recommended for the XM Direct System

Introduction & Installation Overview

Introduction&InstallationOverview

XM Direct 2 Tuner

Model Specic Head Unit Cable

Interface (Sold Separately)

Antenna

Installation Basics/Installation Planning

Installation Basics

Note: Before installation, your PIA must have the proper radio model

protocol downloaded. Please see an authorized dealer for

programming of your PIA.

When choosing a location to mount the components, care must be taken not

to interfere with any of the vehicles existing systems. Good installation prac-

tices should be observed when mounting components to avoid any vibration,

movement or rattling after installation. When routing the cables avoid blocked

passages and any obstructions that could kink, crimp, twist, or chafe the cables.

Components should be secured in place with methods such as Velcro, double

stick foam tape, screws and nuts, cable ties etc. All mounting hardware and

methods are at the discretion of the installer.

Cables should also be secured in place to avoid movement. Care should be taken

not to crimp any of the cables when installing them. And special care should

be taken not to route cables on or near sharp edges that could eventually cut

into the jacket of the cable.

Installation Planning

The PIA should be located within 2-3 feet of the radio due to the cable lengths.

The antenna should be located in an area to insure the cable will reach the tuner

location. Check this prior to installation.

Prior to installation, locate the area where the XM Direct 2 Tuner shall be in-

stalled. Typical locations are the glove box or the center console.

Antenna Installation

1. Best reception is achieved with the antenna mounted on the metal

surface of the vehicle roof in the center of an area with at least 12” x 12”

of surface area and a minimum of 6” from a window or sun roof.

Installation Basics/Installation Planning/Cable Routing

2. If the vehicle has roof racks or skid ribs, it may be necessary to mount

the antenna o-center.

3. If the vehicle roof does not provide sucient metal surface area then

the antenna can be mounted on the metal trunk lid at least 4” from the

rear window.

Caution: DO NOT INSTALL ANTENNA INSIDE VEHICLE PASSENGER

COMPARTMENT. Mounting the antenna in the passenger com-

partment either on the front dash board or on the rear win-

dow deck area of the vehicle may interfere with reception and

must be avoided.

Caution: Mounting the antenna on a non-metallic surface will also re-

sult in severe degradation in reception.

4. If an appropriate antenna mounting location cannot be identied,

contact your local distributor installation department for additional

guidance.

Cable Routing

1. Once you have mounted the antenna in the correct location, plan how

to route the cable from this location to the receiver, avoiding blocked

passages and any obstructions that could kink, crimp, twist or chafe

the cable. If the cable will come in contact with a rough metal opening,

use a rubber grommet to prevent damage.

Cable Routing/Tools Required/Installation Procedure

2. For antenna mounting locations at the front or middle of the roof,

the cable can be routed down along the door jam and into the car. In

some cars, the cable may be brought into the vehicle through the

grommet in the door jam which carries the power window and power

lock wires. If the cable does not t easily through this grommet, do

not try to force it through. Instead, route the cable under the weather

seal near the lowest part of the trunk to reduce possible water leaks.

3. Use pre-existing wiring channels created by the vehicle manufacturer

whenever possible.

Tools Required

The antenna contains a powerful magnet that will secure it to a metal roof

under normal driving conditions. No additional tools should be needed to

mount the antenna.

Installation Procedure

Step 1

Remove the car stereo head unit from your dash board.

Important: Depending on how your head unit was installed you may

have to remove part or all of your dashboard to remove the

head unit before the head unit can be pulled out. You may

also have to remove screws to complete this step.

Installation Procedure

Step 2

Connect the cable into the PIA. Plug the other end of the cable into the head

unit adapter. Read your cable installation manual for proper installation to

your specic head unit.

Step 3

Start your car and turn on your unit to conrm that the XM Direct system is

properly connected. When you tune to XM channel 1, you should see “XM

Preview” on your head unit LCD, and hear that channel through your car

speakers. If not, check to make sure all connections are correct or refer to the

troubleshooting section of this installation guide.

Step 4

Mount and secure the PIA in a suitable location that will not interfere with

the radio and will not vibrate or rattle after installation.

Installation Procedure/Completing Activation

Step 5

Return the car stereo head unit back to its original location in the dash board,

be careful with cables that you just installed so that they do not unplug or

get kinked by the head unit.

Note: If you had removed screws to pull the car stereo head unit out

please screw those back in.

Step 6

If you had removed the dash board during installation please return it back

to its original location.

Completing Activation

Now that your XM Direct system has been installed your XM Universal Tuner

will need to be activated. Details on how to operate your head unit in XM

mode are listed on the following page. Tune your car stereo head unit to the

XM Preview Channel, channel 1 and follow instructions for activation. You

can also go on-line at XMradio.com or call the toll free XM activation number

at 1-800-967-2346. Once you have activated your tuner box make sure the

XM antenna on the outside of your car has an unobstructed view of the sky.

XM Satellite Radio Operation

Please refer to the “XM tuner control features” section of your cassette, CD or

mobile video receiver manual for instructions on operating your XM satellite

radio service.

XM Radio ID

1. During XM Satellite Radio reception, press the Seek button to select

“CHANNEL 0.”

2. Press the “Seek – (down)” button. “RADIO ID” is indicated for 2 seconds

and the XM Radio ID number is indicated for 10 seconds.

To cancel the XM Radio ID display, press the Seek button to select a channel.

Troubleshooting

No Sound

• Adjust the volume control of the head unit.

• Make sure that all of the cables between the PIA and the head unit and

the tuner are securely plugged in.

Advisory Message

When a problem occurs with the XM Direct system, an error message will be

indicated on the display of the head unit.

ANTENNA

The antenna is not connected properly.

• Check the connection of the antenna to the XM tuner.

UPDATING

Radio is being updated with latest encryption code.

• Wait until the encryption code updates. Channels 0 and 1 should

function normally. You have not subscribed to XM service.

• Contact XM to subscribe.

NO SIGNAL

XM signal is being blocked from reaching the XM antenna.

• The message should disappear as soon as you move out of an

obstructed area such as an indoor garage. If the problem persists,

make sure your antenna is mounted outside and on top of the car

with a clear view of the sky.

Andere Handbücher für CNP2000UCA

Inhaltsverzeichnis

Sprachen:

Andere Audiovox Autoempfänger Handbücher

Audiovox

Audiovox Prestige P-975 Bedienungsanleitung

Audiovox

Audiovox Rampage ACD-70 Bedienungsanleitung

Audiovox

Audiovox ADUO-100-MAZ Fehlerbehebungshandbuch

Audiovox

Audiovox VME 9122 TS - Bedienungsanleitung

Audiovox

Audiovox UMP301 Bedienungsanleitung

Audiovox

Audiovox Rampage AV-428 Programmierhandbuch

Audiovox

Audiovox VME 9425 Bedienungsanleitung

Audiovox

Audiovox Prestige P-953 Bedienungsanleitung

Audiovox

Audiovox XSN1V1 Bedienungsanleitung

Audiovox

Audiovox Jensen MP5620 Bedienungsanleitung

Audiovox

Audiovox Prestige P-49 Bedienungsanleitung

Audiovox

Audiovox Jensen CD3720 Bedienungsanleitung

Audiovox

Audiovox ACD-32A Programmierhandbuch

Audiovox

Audiovox Prestige P-99 Bedienungsanleitung

Audiovox

Audiovox P950WESP Bedienungsanleitung

Audiovox

Audiovox AVD400 - AVD 400 - DVD Player Bedienungsanleitung

Audiovox

Audiovox Jensen MP7610 Bedienungsanleitung

Audiovox

Audiovox MP6610 Bedienungsanleitung

Audiovox

Audiovox Prestige P-955 Bedienungsanleitung

Audiovox

Audiovox PCR4500CS Bedienungsanleitung

Audiovox

Audiovox SPS GC-600 Bedienungsanleitung

Audiovox

Audiovox VME 9425 Bedienungsanleitung

Audiovox

Audiovox FlexVision LCM1331FD Kurzanleitung

Audiovox

Audiovox CR1610 Bedienungsanleitung

Beliebte Autoempfänger Handbücher anderer Marken

Motorola

Motorola VWA63 Bedienungsanleitung

Nextar

Nextar D3201 Bedienungsanleitung

Alpine

Alpine CDE-163BT Bedienungsanleitung

Pioneer

Pioneer DEH-P645R Bedienungsanleitung

Axxera

Axxera XDMA7600 Betriebsanleitung

XM OnyX Bedienungsanleitung

Sound Storm

Sound Storm STM93R Bedienungsanleitung

Soundstream

Soundstream VIR-5000 Bedienungsanleitung

Avson

Avson MKT Platform Bedienungsanleitung

Sony

Sony MEX-1HD - Audio Library System Bedienungsanleitung

Pioneer

Pioneer DVH-P500UB Bedienungsanleitung

JVC

JVC KD-AHD69 Bedienungsanleitung

Blaupunkt

Blaupunkt SANTIAGO CR 87 Bedienungsanleitung

Sony

Sony CDX-4160 - Cd Receiver Bedienungsanleitung

XFIRE AUDIO

XFIRE AUDIO BMW42S Bedienungsanleitung

VDO

VDO CD 2253 Bedienungsanleitung

Volvo

Volvo 13 84 580 Bedienungsanleitung

ZENEC

ZENEC ZE-160DVD Bedienungsanleitung