3
SAFETY INFORMATION FOR
EXPOSURE TO RADIO FREQUENCY SIGNALS
Your wireless mobile telephone is a low power radio tran-
smitter and receiver. When it is ON, it receives and also se-
nds out radio frequency (RF) signals.
In August, 1996, the Federal Communications Commission
(FCC) adopted RF exposure guidelines with safety levels
• ICNIRP (1996)
Those standards were based on comprehensive and periodic
evaluations of the relevant scientific literature. For example,
over 120 scientists, engineers, and physicians from universities,
government health agencies, and industry reviewed the av-
ailable body of research to develop the ANSI Standard (C95.1).
The design of your phone complies with the FCC guidelines
(and those standards).
Use only the supplied or an approved replacement antenna.
Unauthorized antennas, modifications, or attachments could
damage the phone and may violate FCC regulations.
SAFEPHONEINSTALLATIONANDOPERATION
For safe and efficient operation, this phone must be properly
installed using recommended installation procedure specified
in the installation guide for this unit. A "thru-glass" antenna
must be mounted on the center of the rear window of the
vehicle. At no time should anyone touch the antenna or come
in close contact with it while the phone is in operation.
ANTENNA CARE
WIRELESS MOBILE PHONES
READ THIS INFORMATION BEFORE USING
YOUR MOBILE CELLULAR TELEPHONE
for mobile wireless phones. Those guidelines are consis-
tent with the safety standards previously set by both U.S. and
International standards bodies:
• ANSI C95.1 (1992)
• NCRP Report 86 (1986)
