Note:Music control is only compatible with
devices that support A2DP, please refer to your
mobile phone user manual for the A2DP
compatibility of your phone.
5.4 Audio-In
To use the SE30 as a wired speaker, use a 3.5mm
audio cable to connect the SE30 with your source
device. Once the audio cable is connected to the
SE30, the device automatically switches to
Audio-in mode.
English
-For mobile phones
1) Scan for available Bluetooth devices on your
mobile phone (see your mobile phone user
manual for instructions if needed).
2) Select “SE30” from the available devices.
3) Once successfully paired and connected, the status
LED will slowly flash blue.
-For computers
1) Enable Bluetooth on your PC.
2) Select “Devices and Printers” from the Control
Panel and click “Add a Device”.
3) Select “SE30” from the available devices to
install drivers.
Note: For Windows XP and Vista, a third-party
Bluetooth driver is needed (not included).
4) If the SE30 is not automatically set as your
output device, select “Sound” from the control
panel then highlight the SE30 and select “Set
Default”.
5.3 Music Control
The SE30 is able to control music playing on either
a mobile phone or a computer through a Bluetooth
connection.
Tap the “ ” or “ ” buttons to select the previous
or next track, or press and hold them to adjust the
volume and press “ ”to pause or resume playback.
-6-
-5-
6. Charging
To charge the SE30, connect the micro USB lead to
the device’s power socket, and the other end of the
USB cable to a powered USB port.
The LED lights red whilst charging and turns off
once the battery is fully charged.
