Dimensions of xtures are approximate and may vary ± 6mm (1/4”). Structure measurements must be veried against the unit to ensure proper t.
Product images and specications are for illustrative purposes only, product design may vary.
Installation Manual
ASR1202-OO *** Valve Rough-In
5
1
23
1
2
3
Test the Handle/Valve:
Water temperature will decrease when you rotate
clockwise, and water temperature will increase when you
rotate counter clockwise.
CLEANING STOP FILTERS
Removing the stop lters:
Using a wrench, take out both of the Stops (1) by rotating
them counter-clockwise.
Remove Filter (2) and Valve (3) and check for any debris
or build up.
Use clean water to rinse and clean Filter (2).
Installing the stop lters:
Slide Filter (2) on to Valve (3). Then thread it to the valve
body.
Use a wrench to tighten the Stops (1) to the valve.
3A.
4A.
4B.
Thermostatic Valve Cover Plate and Handle Installation
)
Tempature Lock;
must be pushed.
3A.
4A. 4B.
CAUTION!
If you need to adjust temperature more
than 38°C (100°F), then you need to press
the override button and rotate it counter
clockwise. It should not be possible to turn
the stem further counter-clockwise.
Testing Handles and Replacing and Cleaning Stop Filters
Installing Cover Plate:
Carefully install the Trim Plate (1), make sure to keep the
Trim Plate (1) tight against the wall.
Conguring the Cartridge:
Before installing the handle and the rest of the trim,
ensure the thermo cartridge is positioned correctly. Verify
that the line etched on the top of the Plastic Body (1) of
the cartridge lines up exactly with the black line on the
brass Boarch (2) as you are looking down on it.
(See Figures D2. and D3. on the left)
Installing Volume Control Handle:
Install Plastic Washer (4) on diverter. Install the Volume
Control Handle (1). Use the Allen Key (9) to tighten the
Handle Set Screw (3), then insert Set Screw Cap (3).
Installing Thermostatic Handle:
Install Plastic Washer (5) on the thermostatic mixer.
Install the Thermostatic Mixer Handle (6), so that the
safety stop override button is at the 9:00 position. Use
the Allen Key (9) tighten the Handle Set Screw (8), then
insert Set Screw Cap (7).
2C.
2D.
2E.
Thermo Cartridge Calibration Area
D2. D3.
CAUTION!
Please check that the marked line on
the thermostatic cartridge points to the
rectangle notch on the plastic parts, if not,
please rotate the brass part. Then install
the handle.
Marked Line & Groove
MUST ALIGN
1
2
1
2
3
6
9
4
10
511
7
1
2C. 2D.
TOP VIEW
(1)
(2)
Plastic Body
Boarch
