DIP Switch 1 and 4 must be power off and restart can switch mode.
This dip switch can only turn off the voice of remote. If needed turn off the
voice of wireless push button, it should press learning button, then switch on or
off.
Pet mode to half open mode:
Turn to close signal (A) Turn to open signal (B)
Photocell Outside
Inside Pet
Active any terminal of A and B at same time, will work active to open or active to
close. (Attention: Must be one terminal from A and B active at same time)
b. The desired mode is selected by successive presses of the Mode button, to the
right of the LED display. The modes will cycle in the order shown above
(although the pet mode will be omitted if no pet opening width has been set).
The selected mode will engage after a short delay.
a. Toggle DIP switch for pet learn.
b. The door will begin to close slowly. If the door is already closed there will be a
short delay.
c. After a short delay, the door will begin to open slowly. When the door reaches
the desired pet opening width stop the door preferably with your foot. Be
careful to not get anything caught in the opening door!
d. After a short delay, the door will begin too slowly close. Once fully closed the
Multi-Controller Lock will return to Automatic mode, indicated by a green LED on
the display, and pet options will be available.
e. Test the pet opening width by pressing the ‘pet sensor’ button. If the width is
incorrect then return to step ‘a’.
SETTING PET OPENING WIDTH
Learning Process:
Turn on the power switch, ensure dip 1 is correct, if direction is wrong. Please
switch the dip to opposite direction, turn off the power and make sure
door/window is fully closed. Then, power on.
Opening width learning (pet):
Pet mode indicator will flash, door will start to open slowly. Have an obstacle at
the position you need, after short pause, door will close slowly. The learning
process will be done after the door/window is fully closed, standard opening
width learning.
All Mode indicator flash, door:
Will open and close slowly. When the door is fully closed, automatic mode
indicator flashes, indicating the learning process is done. Controller is with
memory of opening width
Congratulations, you should now have a fully functioning
Multi-Controller automatic door!!
18
17
