Table of Contents
4AVENTICS | Marex 3D | R417003094–BDL–001–AA
4.3.3 Heading sensor ...................................................................... 35
4.4 Applied standards and classification ................................35
5 Installation ................................................................... 36
5.1 Mounting the 3D Controller and Joystick Type 531 ......36
5.2 Mounting the heading sensor ..............................................37
5.3 Establishing the electrical connections............................39
5.3.1 Connecting the 3D Controller ............................................. 39
5.3.2 Connecting Marex OS III and Marex ECS ........................ 44
5.3.3 Connecting the Joystick ....................................................... 47
5.3.4 Connecting an optional heading sensor ......................... 49
5.3.5 Connecting the thrusters .................................................... 50
6 Commissioning ............................................................ 58
6.1 General .......................................................................................58
6.1.1 Software requirements of Marex OS and Marex ECS 59
6.1.2 Verifying the correct system installation ....................... 59
6.1.3 Installation sites .................................................................... 59
6.1.4 Reviewing the cable connections ..................................... 60
6.2 Preadjusting the 3D Controller............................................61
6.2.1 Operation of the display ...................................................... 61
6.2.2 Adjusting the 3D Controller for the operation with Marex
OS ............................................................................................... 62
6.2.3 Enabling control stations for the joystick operation and
assigning the joysticks ........................................................ 64
6.2.4 Deactiving the heading sensor .......................................... 65
6.2.5 Adjusting Marex OS for the operation with Marex 3D 66
6.2.6 Disabling the direct command transfer ......................... 67
6.2.7 Marex ECS in combination with Marex 3D ..................... 68
6.2.8 Thruster parameter settings ............................................. 68
6.3 Initial operation ........................................................................69
6.3.1 Defining the drive combinations ....................................... 69
6.3.2 Tests and adjustments ........................................................ 69
7 Operation ..................................................................... 80
7.1 Switching Marex3D on...........................................................80
7.2 Activating the 3D-mode.........................................................81
7.3 Switching the 3D-mode off...................................................81
7.3.1 By using the COM-key at the control head ..................... 81
3D_manual_R417003094_DE_EN.book Seite 4 Freitag, 30. November 2018 11:36 11
