Award DC1700EW Bedienungsanleitung
DRYING CABINET
DC1700EW
GB
Before using this product,
please read the user manual
carefully. Save the user
manual for future reference.
User Manual
2
CONTENTS
THIS USER MANUAL 3
SAFE OPERATION 3
FOR A HEALTHY ENVIRONMENT 4
Packaging material 4
Disposing of a worn-out drying cabinet
4
COMPONENTS 5
Control panel 5
INSTALLATION 6
Unpacking 6
Reversing the door 6
PLACEMENT 7
Levelling 7
Securing to wall 7
VENTILATION/AIR SUPPLY 8
CONNECTING TO VENTILATION 8
With draft stabilizer 9
Direct connection to mechanical
extractor 9
ELECTRICAL SUPPLY 10
BEFORE USING THE DRYING CABINET
11
ARRANGING ITEMS FOR DRYING 11
User advice 11
Air ow 11
DRYING PROGRAMME 12
Programme 12
Programme selection 12
Control panel 12
CHILD LOCK 13
Switching child lock on/o 13
DRYING WITHOUT CHILD LOCK 14
Automatic programme 14
Manual programme 14
Pausing a programme 15
Stopping the drying phase 15
DRYING WITH CHILD LOCK 16
Automatic programme 16
Manual programme 16
Pausing a programme 17
Stopping the drying phase 17
THERMAL CUTOUT 18
CARE 19
Cleaning 19
Replacement parts 19
Servicing 19
TECHNICAL DATA 20
Energy consumption and drying times
20
WARRANTY 21
3
THIS USER MANUAL
The contents of this manual describe the
operation and use of the drying cabinet and
provide instructions for its installation and
maintenance.
_______________________________________
NOTE! Keep this user manual
handy, so that it is always available
for future reference.
______________________________________
SAFE OPERATION
This drying cabinet complies with the relevant safety requirements Incorrect
use can lead to injury and damage to property.
This advice on using the appliance safely is provided to help you avoid
incorrect use and unnecessary risks, and you should read it before installing
or using the drying cabinet
WARNING! This equipment is only intended for drying textiles that
are washed in water.
pThe drying cabinet must be installed and kept indoors.
pThe appliance is not to be used by persons (including children)
with reduced physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have been given
supervision or instruction.
pDo not let children play in, on or with the drying cabinet. Keep
an eye on children when they are close to the cabinet.
pCleaning and maintenance must not be carried out by children
without supervision.
pReplace the power cord immediately if it is damaged. The
power cord may only be replaced by the manufacturer, an
authorised service representative or a qualied electrician!
pFollow AWARD instructions when repairing and replacing
parts.
4
FOR A HEALTHY ENVIRONMENT
PACKAGING MATERIAL
The packaging that protects the drying
cabinet during transport was chosen with
the environment in mind and is therefore
recyclable.
By recycling packaging you reduce the use
of new resources and reduce the amount of
waste.
DISPOSING OF A WORN-OUT
DRYING CABINET
When the drying cabinet has reached the end
of its useful life it must be sent for dismantling.
Many parts can be recycled, but the cabinet
also contains materials that must be disposed
of correctly. So never dispose of the drying
cabinet or its components with general
household waste, as this could cause health
risks and harm the environment.
Send the worn-out drying cabinet to a
recycling station instead. Contact your retailer
for information if necessary.
All the plastic components of the drying
cabinet are marked with standardised
international symbols. These allow the parts to
be sorted correctly for recycling.
5
CONTROL PANEL
COMPONENTS
Buttons for selecting drying program
See page 12
Stop button
LEDs
Power cord
Damp air outlet
Air intake
Heater and fan components assembled
in a removable fan unit behind the
cover panel
Door hangers
Three sliding sets of hangers
Door, right-hung or left-hung
Shoe rack
Adjustable feet (4)
6
INSTALLATION _______________________________________
Check that all transport safety devices have been
removed before connecting the drying cabinet.
_______________________________________
Keep packaging materials such as plastics and
polystyrene foam away from children
______________________________________
________________________________________
Take care, as the drying cabinet is
top-heavy and can easily tip over.
Do not move the cabinet alone,
make sure you are at least two.
________________________________________
Complete delivery should include:
Cabinet with pre-installed fan unit
Installation kit
User manual
_______________________________________
Check that the goods have not been damaged
in transport. Any transport damage must be
reported to the retailer within 7 days
______________________________________
UNPACKING
Remove all packaging material; do not use sharp tools that could damage the product.
_______________________________________
After unpacking the product, check that it is free
from damage. Any damage, faults or missing parts
must be reported to the retailer immediately
_______________________________________
Installation kit,
- for cabinet - for wall fixing
Draft stabilizer (1)
Hose (1)
Spigot (1)
Fixing screw for spigot (2)
Cover plug, white (4) for
adjustable feet
Allen key (1)
Screw TRX 5x70 zinc-
plated (2)
Washer NB 5x25 (2)
Wall plug (2)
Spacer 8.2x12x15 (2)
REVERSING THE DOOR
The cabinet is supplied from the factory with a right-hung or left-hung door. The door can be reversed
afterwards.
If this is required, contact Award Appliances.
3
25
4
7
1
6
7
1. Pre-drilled holes
2. Wall plug
3. Wall behind the cabinet
4. Spacer
5. Drying cabinet back wall
6. Washer
7. Attachment screw
8. Spirit level
9. Cover plug (4)
PLACEMENT
_________________________________________
The drying cabinet is only intended for use indoors
in a dry area.
_________________________________________
Do not place the drying cabinet in an area where
high-pressure water is used for cleaning.
______________________________________
LEVELLING
The drying cabinet must be installed upright on a at
surface and be supported by all four feet. It can be
levelled using the adjustable feet.
Use the supplied Allen key to adjust the feet from
inside the cabinet.
Press the four covering plugs rmly into the holes.
SECURING TO WALL
The cabinet must be secured to the wall to prevent it
from tipping over.
1Place the cabinet in the desired location, open the
door and slide out the upper set of hangers.
2Drill two 8 mm holes in the wall through the pre-
drilled holes (1) in the rear of the cabinet.
3Insert the wall plugs (2) into the wall. Slide a spa-
cer (4) on to each screw (7) and t them with the
washers as shown. The screws are found in the
installation kit.
_________________________________________
WARNING! The drying cabinet must not be used
unless it has been secured to the wall,
as it could tip forwards otherwise.
_________________________________________
8
9 (4)
8
CONNECTING TO VENTILATION
VENTILATION/AIR SUPPLY
When the cabinet is running it produces 45 m³ of damp air per hour. You should therefore ensure
that the room is well ventilated to replace the damp air that is extracted.
The drying cabinet should be connected to a ventilation system that meets the relevant standards.
The drying cabinet can be connected to a ventilation duct in two ways, either by using the draft sta-
bilizer or by connecting directly to a mechanical extractor.
If the drying cabinet is connected to an existing ventilation system the draft stabilizer must always be
used, to prevent interference with the general ventilation in the premises.
Direct connection should only be used when a dedicated extractor duct is provided for the drying cabinet.
The manufacturer recommends that the drying cabinet is connected using the draft stabilizer.
Place the supplied spigot over the hole in
the top of the cabinet, insert the screws and
secure the spigot.
3
2
1
1
2
3
9
DIRECT CONNECTION TO MECHANICAL EXTRACTOR
________________________________
The insert is not supplied.
________________________________
Make sure the cabinet air intake is not
blocked.
________________________________
______________________________
Make sure the air intake is not blocked
______________________________
Do not connect the drying cabinet to
an existing chimney.
______________________________
1. Humid air out
2. Ventilation from the room
3. Flexible hose
4. Spigot
5. Draft stabilizer
6. Air intake
WITH DRAFT STABILIZER
Connect the exible hose to the spigot. Connect the other end of the hose to the draft stabilizer and
then secure this over the exhaust vent in the room.
1. Draft stabilizer
2. Flexible hose
3. Spigot
1. Insert
2. Flexible hose
3. Spigot
Air intake
Humid air out
Air intake
Humid air out
When the cabinet is connected directly
to a ventilation duct the whole room is
ventilated through the drying cabinet.
Connect the exible hose to the insert
and to the spigot.
3.dxf
10
The drying cabinet must be connected to a 230 V,
single-phase supply at 50 - 60 Hz, via an earthed
wall socket.
Fuse 10 A.
The drying cabinet is supplied ready for connection
with a power cord and earthed plug.
ELECTRICAL SUPPLY
_______________________________________
The drying cabinet must be connected to an
earthed wall socket using the power cord supplied.
_______________________________________
The socket must be positioned so that the appli-
ance can be easily unplugged if necessary.
_______________________________________
Check that the electrical supply matches the data
on the rating plate and that the supply is earthed
correctly according to the relevant standard. We
recommend that the supply is tted with a residual
current device.
_______________________________________
The socket must have its own fused circuit.
_______________________________________
Do not connect the drying cabinet to the power
supply with an extension lead as the necessary
safety cannot be guaranteed (risk of overhea-
ting).
_______________________________________
The manufacturer will not accept any responsi-
bility if electrical connections are not made as
described in this user manual.
_______________________________________
If the power cord for any reason is damaged, it
must be replaced. A genuine part can obtained
from the cabinet dealer. A replacement cord may
only be installed by a qualied electrician/service
agent.
_______________________________________
Inhaltsverzeichnis
Andere Award Trockner Handbücher
Beliebte Trockner Handbücher anderer Marken
Indesit
Indesit IDV 75 Bedienungsanleitung
Infiniton
Infiniton SD-DG85C Bedienungsanleitung
BOMANN
BOMANN WT 5019 Bedienungsanleitung
Alliance Laundry Systems
Alliance Laundry Systems TMB795C Bedienungsanleitung
Asko
Asko T793C Bedienungsanleitung
Kenmore
Kenmore 8041 - 5.8 cu. Ft. Capacity Electric Dryer Bedienungsanleitung