22 Click the adapter wire into the closing unit:
- lead the wire from the left-hand side of the closing unit
and place the adapter in the power socket.
or:
- lead the wire through the opening on the right-hand side
of the closing unit and under the designated hook
(figure ). Place the adapter into the power socket.
Ensure that the wire is placed neatly along
the window casing.
The adapter with 5m wire can be ordered as an accessory under
item number 2902-31-98.
Problem-solving
The window does not close
• Disconnect the chain from the window and check that
the window does not become stuck and operates without
problems.
• Check that installation steps have been followed correctly.
• The batteries may be flat (have insufficient power).
Replace the batteries in the unit and/or remote control
(figure ).
• The unit has been configured too tightly.
The closing unit may (for example, due to the wood setting
our because of temperature differences) not properly
close the window in certain cases, if it has been configured
too tightly. Remove the 2 outer screws (figure ) from
the closing unit. Turn the adjustment screw fully to the right
(figure ). Repeat step 14 to/incl. 17. Mount the 2 outer
screws on to the window unit once again.
The unit does not react or reacts insufficiently
• Temporarily remove the batteries or remove the adapter
plug from the power socket and wait 2 minutes. Press a
button on the remote control as if you are about to use
the unit. Replace the batteries or the adapter.
Now try to use the unit by pressing one of the buttons on the
remote control.
Unit does not immediately respond to the remote control,
sleep mode
• To save energy, the unit switches to sleep mode after a
certain period of time; that is why you sometimes need
to press twice on the remote control to activate the unit.
• Environmental factors could have an impact on the range of
the remote control. Full sun, TL lighting very close to the
front of the unit or a dusty/moist environment could
reduce the operating range. In this case, you must move
closer to the closing unit to operate it.
• The batteries may be flat (have insufficient power). Replace
the batteries in the unit and/or remote control.
Replace batteries
Low-battery indicator
• If the LED starts to flash red/green intermittently, this
means the batteries need to be replaced very soon.
The AXA-Remote will always ensure that the last remaining
power in the batteries is used to close the window.
• Open the cap of the unit and remove the 4 flat batteries.
Insert 4 new batteries (AA) as identified in this assembly
manual (figure ).
Only use good alkaline AA batteries (do not use
rechargeable batteries)
Configure multiple units with the same remote control
• Briefly remove the batteries from the to-be-configured
window unit or briefly remove the adapter from the power
socket and wait 2 minutes. Replace the batteries or the
adapter. Continue to configure the remote control so long
as the LED light remains green (20 seconds) (see figure ).
Ventilation capacity
According to NEN 1087 and NEN 8087, which identify mini-
mum ventilation per area, the AXA Remote 2.0 complies with
the minimum ventilation capacity of 25 m3/hour per area,
based on a window surface area of 0.26m2. Due to its many
opening possibilities, the AXA Remote 2.0 is also suitable for
aeration. For the mentioned window size, each AXA Remote 2.0
is able to sufficiently ventilate an area of 22.5 m.The AXA
Remote 2.0 also complies with the capacity guideline establis-
hed in NPR 1088 because it enables continuous opening and
closing. This allows the required ventilation to be arranged.
NB. The AXA Remote is only intended for items with a
residential or office purpose.
S
S
P
C
C
C
AXA Remote 2.0
37-223 (05-12)
EMC 2004/108/EC
4
O
Remote-controlled window opener
POLICE
HALLMARK
SAFE LIVING
