AXIOMTEK ICO-100 Series Bedienungsanleitung
ICO-100 Series
Remote Field Controller
User’s Manual
ii
Disclaimers
This manual has been carefully checked and believed to contain
accurate information. AXIOMTEK Co., Ltd. assumes no responsibility
for any infringements of patents or any third party’s rights, and any
liability arising from such use.
AXIOMTEK does not warrant or assume any legal liability or
responsibility for the accuracy, completeness or usefulness of any
information in this document. AXIOMTEK does not make any
commitment to update the information in this manual.
AXIOMTEK reserves the right to change or revise this document
and/or product at any time without notice.
No part of this document may be reproduced, stored in a retrieval
system, or transmitted, in any form or by any means, electronic,
mechanical, photocopying, recording, or otherwise, without the prior
written permission of AXIOMTEK Co., Ltd.
©Copyright 2008 AXIOMTEK Co., Ltd.
All Rights Reserved
January, Version A1
Printed in Taiwan
iii
Safety Approvals
CE Marking
FCC Class A
FCC Compliance
This equipment has been tested and complies with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. If not installed and used in
accordance with proper instructions, this equipment might generate or
radiate radio frequency energy and cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measurers:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cables must be used in order to comply with
emission limits.
iv
Safety Precautions
Before getting started, read the following important cautions.
1. The ICO-100 Series does not come equipped with an
operating system. An operating system must be loaded first
before installing any software into the computer.
2. Be sure to ground yourself to prevent static charge when
installing the internal components. Use a grounding wrist strap
and place all electronic components in any static-shielded
devices. Most electronic components are sensitive to static
electrical charge.
3. Disconnect the power cord from the ICO-100 Series before
making any installation. Be sure both the system and the
external devices are turned OFF. Sudden surge of power
could ruin sensitive components. Make sure the ICO-100
Series is properly grounded.
Trademarks Acknowledgments
AXIOMTEK is a trademark of AXIOMTEK Co., Ltd.
IBM, PC/AT, PS/2, VGA are trademarks of International Business
Machines Corporation.
Intel®and Pentium®are trademarks of Intel Corporation.
MS-DOS, Microsoft C and Quick BASIC are trademarks of Microsoft
Corporation.
VIA is a trademark of VIA Technologies, Inc.
SST is a trademark of Silicon Storage Technology, Inc.
UMC is a trademark of United Microelectronics Corporation.
Other brand names and trademarks are the properties of their
respective owners.
v
Table of Contents
Disclaimers........................................................................................................... ii
Safety Approvals ................................................................................................. iii
FCC Compliance.................................................................................................. iii
Safety Precautions...............................................................................................iv
Chapter 1 Introduction.................................................................... 1
1.1 General Description................................................................................. 1
1.2 Specifications.......................................................................................... 2
1.2.1 Main CPU board ............................................................................... 2
1.2.2 I/O System........................................................................................ 2
1.2.3 System Specification......................................................................... 3
1.3 Dimensions.............................................................................................. 3
1.4 I/O Outlets ............................................................................................... 8
1.5 Package list............................................................................................. 9
Chapter 2 Hardware Installation .................................................. 11
2.1 Installing the CompactFlash Card......................................................... 11
2.2 Installing the Hard Drive........................................................................ 12
2.3 Installing PC/I04 .................................................................................... 22
2.4 Serial Port Interface............................................................................... 25
2.5 Ethernet................................................................................................. 26
2.6 Mounting Way: Wall Mount ................................................................... 26
2.7 Mini-PCI WLAN Module (optional) ........................................................ 27
Chapter 3 Driver Installation.........................................................31
3.1 Network Controller................................................................................. 32
3.2 AES Driver Installation .......................................................................... 35
3.3 VGA Driver Installation.......................................................................... 39
3.4 PCI Bridge Driver Installation................................................................ 43
3.5 Audio Driver Installation ........................................................................ 47
3.6 WLAN Driver Installation....................................................................... 51
Chapter 4 Remote Monitoring Tool.............................................. 53
4.1 Remote Tool Installation........................................................................ 54
4.2 Monitoring Setting ................................................................................. 55
4.3 Alarm Setting......................................................................................... 57
4.4 Notification Setting ................................................................................ 60
4.5 Security Setting ..................................................................................... 61
4.6 Logging Setting ..................................................................................... 62
4.7 Watchdog Setting.................................................................................. 63
4.8 Version.................................................................................................. 64
vi
MEMO
ICO-100 Series User’s Manual
Introduction 1
C h a p t e r 1
Introduction
This chapter contains general information and detailed specifications
about the ICO-100 Series. Chapter 1 includes the following sections:
General Description
Specification
Dimensions
I/O Outlets
Package List
1.1 General Description
The ICO-100 Series is a compact field controller designed for remote
management application. Equipped with AMD LX800 processor, the
ICO-100 Series features high reliability and expansion capability.
Besides, the ICO-100 Series offers remote management tools of
“Remote Monitoring”, “Remote Alarm”, “Remote Diagnosis” and
“Security” that can enable easy and efficient management over a
wired/wireless network in remote environments, anytime and
anywhere.
Moreover, ICO-100 Series supports the stacking design for capacity
expansion through PC/104 slot and 2.5” HDD easily.
The ICO-100 Series is an ideal application in unmanned rooms,
ICO-100 Series User’s Manual
Introduction
2
transportation, industrial machines, and more.
1.2 Specifications
1.2.1 Main CPU board
zCPU
AMD LX800 500MHz
zSystem Chipset
AMD LX + CS5536AD
zBIOS
Phoenix-Award 4Mbit with RPL/PXE LAN Boot ROM,
SmartView and Customer CMOS Backup
zSystem Memory
One 184-pin DDR DIMM, maximum up to 1 GB
1.2.2 I/O System
zStandard I/O
Two serial ports (1 x RS-232, 1 x RS-232/422/485)
One VGA port
zEthernet
Equipped with 1 x RJ-45 for 10/100 base-T
zAudio
Realtek AC’97 codec audio (Line-out)
zExpansion
Equipped with 1 x Mini-PCI & 1 x PC/104
zCompactFlash Socket
One CompactFlash Type II Socket
ICO-100 Series User’s Manual
Introduction 3
1.2.3 System Specification
zDisk Drive Housing
One CompactFlash Type II Socket
One 2.5” Hard Drive
zDC 24V power supply
zHeat dispensing design
zWeight
2.0 Kgs
zDimension (main body size)
208.5 x 167.3 x 66.5 mm
zOperating temperature
O° to 45°C ; Relative umidity:50%
zRelative humidity
10% to 85% @ 40° C, non-condensing
zAltitude
10,000 ft. (3,000 meters
zVibration (operating)
5 to 500 Hz, 1 G random
zShock (operating)
10 G peak acceleration (11 msec. duration)
NOTE All specifications and images are subject to change
without notice.
1.3 Dimensions
The ICO-100 Series dimensions and outlines are shown as the
following diagrams:
1. CPU board layer
2. CPU board layer with HDD expansion
3. CPU board layer with PC/104 expansion
4. CPU board layer with HDD & PC/104 expansions
ICO-100 Series User’s Manual
Introduction
4
Inhaltsverzeichnis
