AXIOMTEK ICO120-E3350-A Bedienungsanleitung

ICO120-E3350-A

ICO120-E3350-B

ICO120-E3350-C

ICO120-E3350-E

Robust Din-rail Fanless

Embedded System

User’s Manual

Disclaimer

This manual has been carefully checked and is believed to contain accurate information.

Axiomtek Co., Ltd. assumes no responsibility for any infringements of patents or any

third party’s rights, and any liability arising from such use.

Axiomtek does not warrant or assume any legal liability or responsibility for the accuracy,

completeness or usefulness of any information in this document. Axiomtek does not make any

commitment to update the information in this manual.

Axiomtek reserves the right to change or revise this document and/or product at any time

without notice.

No part of this document may be reproduced, stored in a retrieval system, or transmitted, in

any form or by any means, electronic, mechanical, photocopying, recording, or otherwise,

without the prior written permission of Axiomtek Co., Ltd.

June 2023, Version A1

Printed in Taiwan

iii

Safety Precautions

Before getting started, please read the following important safety precautions.

The ICO120-E3350-A/B/C does not come equipped with an operating system. An

operating system must be loaded first before installing any software into the

computer.

Be sure to ground yourself to prevent static charge when installing the internal

components. Use a grounding wrist strap and place all electronic components in

any static-shielded devices. Most electronic components are sensitive to static

electrical charge.

Disconnect the power cord from the ICO120-E3350-A/B/C before making any

installation. Be sure both the system and the external devices are turned off. Sudden

surge of power could ruin sensitive components. Make sure the ICO120-E3350-

A/B/C is properly grounded.

Make sure the voltage of the power source is correct before connecting the

equipment to the power outlet.

Turn OFF the system power before cleaning. Clean the system using a cloth only.

Do not spray any liquid cleaner directly onto the screen.

Do not leave this equipment in an uncontrolled environment where the storage

temperature is below -40℃or above 85℃. It may damage the equipment.

Do not open the system’s back cover. If opening the cover for maintenance is a

must, only a trained technician is allowed to do so. Integrated circuits on computer

boards are sensitive to static electricity. To avoid damaging chips from electrostatic

discharge, observe the following precautions:

▪

Before handling a board or integrated circuit, touch an unpainted portion of the

system unit chassis for a few seconds. This will help to discharge any static

electricity on your body.

▪

When handling boards and components, wear a wrist-grounding strap,

available from most electronic component stores.

Caution

There is risk of explosion if incorrect type battery is installed; p leas e disposeof

the used batteries according to the instructions.

Warning

Hot Surface Do Not

Touch.

Restricted access area: The equipment should only be installed in a Restricted Access

Area.

10.

This product is intended to be supplied by a Listed Power Adapter or DC power

source, output meets SELV, rated 12-24Vdc, minimum 1.30-0.74A, Tma = 60

degrees C, and the altitude of operation = 2000m.

If need further assistance with purchasing the power source, please contact the

manufacturer for further information.

11.

This product is intended to be supplied by DC power source, output meets SELV,

rated 12-24Vdc, minimum 1.30-0.74A, Tma = 70 degrees C, and the altitude of

operation = 2000m.

If need further assistance with purchasing the power source, please contact the

manufacturer for further information.

12.

When use with desk top Class I power adapter, the Power Cord only shall only connect

to a socket-outlet with earthing connection.

Classification

Degree of production against electric shock: not classified

Degree of protection against the ingress of water: IP30

Equipment not suitable for use in the presence of a flammable anesthetic mixture

with air or with oxygen or nitrous oxide.

Mode of operation: Continuous

Type of protection against electric shock: Class I equipment

General Cleaning Tips

You may need to read the following precautions carefully before you begin to clean the

computer. When you clean any single part or component for the computer, please read

and understand the details below fully.

When you need to clean the device, please rub it with a piece of dry cloth.

Be cautious of the tiny removable components when you use a vacuum cleaner

to absorb the dirt on the floor.

Turn the system off before you start to clean up the component or computer.

Never drop the components inside the computer or get the circuit board damp or wet.

Be cautious of all kinds of cleaning solvents or chemicals when you use it for the

sake of cleaning. Some individuals may be allergic to the ingredients.

Try not to put any food, drink or cigarette around the computer.

Cleaning Tools

Although many companies have created products to help improve the process of

cleaning your computer and peripherals users can also use household items to clean

their computers and peripherals. Below is a listing of items you may need or want to use

while cleaning your computer or computer peripherals.

Keep in mind that some components in your computer may only be able to be cleaned

using a product designed for cleaning that component, if this is the case it will be

mentioned in the cleaning.

Cloth: A piece of cloth is the best tool to use when rubbing up a component. Although

paper towels or tissues can be used on most hardware as well, we still recommend you

rub it with a piece of cloth.

Water or rubbing alcohol: You may moisten a piece of cloth a bit with some

water

or rubbing alcohol and rub it on the computer. Unknown solvents may be harmful

to the plastic parts.

Vacuum cleaner: Absorb the dust, dirt, hair, cigarette particles, and other particles

out of a computer can be one of the best methods of cleaning a computer. Over

time these items can restrict the airflow in a computer and cause circuitry to

corrode.

Cotton swabs: Cotton swaps moistened with rubbing alcohol or water are excellent

tools for wiping hard-to -reach areas in your keyboard, mouse, and other locations.

Foam swabs: Whenever possible it is better to use lint-free swabs such as foam

swabs.

Note: We strongly recommended that you should shut down the system before you start

to clean any single component.

Please follow the steps below:

Close all application

programs

Close operating software

Turn off t h e power

Remove all device

Pull out the power cable

vii

Scrap Computer Recycling

If the computer equipment needs the maintenance or are beyond repair, we strongly

recommended that you should inform your Axiomtek distributor as soon as possible for

the suitable solution. For the computers that are no longer useful or no longer working

well, please contact your Axiomtek distributor for recycling and we will make the proper

arrangement.

Trademarks Acknowledgments

Axiomtek is a trademark of Axiomtek Co., Ltd.

IBM, PC/AT, PS/2, VGA are trademarks

of International Business Machines Corporation.

Intel®and

Pentium®are registered trademarks of Intel Corporation.

MS-DOS, Microsoft C and QuickBASIC are trademarks of Microsoft Corporation. VIA is

a trademark of VIA Technologies, Inc.

SST is a trademark of Silicon Storage Technology, Inc.

UMC is a trademark of United Microelectronics Corporation. Other brand names and

trademarks are the properties and registered brands of their respective owners.

viii 
 
 
Table of Contents 
Disclaimers............................................................................................................. ii 
Safety Precautions.................................................................................................iii 
Classification........................................................................................................... 
v
 
General Cleaning Tips ............................................................................................ 
v
 
Cleaning 
Tools
........................................................................................................vi 
Scrap Computer 
Recycling
 ...................................................................................vii 
CHAPTER 1 INTRODUCTION............................................................................1 
1.1 
General Description ............................................................................... 1 
1.2 
System 
Specifications
............................................................................. 2 
1.3 
Dimensions............................................................................................. 6 
1.4 
I/O Outlets.............................................................................................. 7 
CHAPTER 2 HARDWARE INSTALLATION.......................................................9 
2.1 
Installing the Memory 
Module
................................................................ 9 
2.2 
Installing the 
mSATA
............................................................................ 11 
2.3 
Installing Din-rail Mounting.................................................................. 13 
2.4 
Installing Wall Mounting (optional)...................................................... 14 
CHAPTER 3 AMI UEFI BIOS UTILITY.............................................................15 
3.1 
Entering 
Setup
...................................................................................... 15 
3.2 
The Main Menu ......................................................................................16 
3.3 
Advanced Features............................................................................... 17 
3.4 
Chipset Feature.....................................................................................32 
3.5 
Security................................................................................................. 34 
3.6 
Boot Mode............................................................................................. 35 
3.7 
Save & Exit............................................................................................ 38 
APPENDIX A WATCHDOG TIMER..................................................................40 

viii

This page is intentionally left blank.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere AXIOMTEK Einplatinencomputer Handbücher

AXIOMTEK

AXIOMTEK SBC8440 Bedienungsanleitung

AXIOMTEK

AXIOMTEK PICO512 Series Bedienungsanleitung

AXIOMTEK

AXIOMTEK SHB110 Series Bedienungsanleitung

AXIOMTEK

AXIOMTEK SBC81206 Series Bedienungsanleitung

AXIOMTEK

AXIOMTEK eBOX626-853-FL Series Bedienungsanleitung

AXIOMTEK

AXIOMTEK SBC81205 Bedienungsanleitung

AXIOMTEK

AXIOMTEK eBOX626-311-FL Bedienungsanleitung

AXIOMTEK

AXIOMTEK SHB130 Series Bedienungsanleitung

AXIOMTEK

AXIOMTEK SHB230 Bedienungsanleitung

AXIOMTEK

AXIOMTEK SBC84830 Series Bedienungsanleitung

AXIOMTEK

AXIOMTEK CAPA831 Bedienungsanleitung

AXIOMTEK

AXIOMTEK CAPA312 Bedienungsanleitung

AXIOMTEK

AXIOMTEK PICO880 Series Bedienungsanleitung

AXIOMTEK

AXIOMTEK SBC81700 Series Bedienungsanleitung

AXIOMTEK

AXIOMTEK CAPA55R Bedienungsanleitung

AXIOMTEK

AXIOMTEK SBC81203 Series Bedienungsanleitung

AXIOMTEK

AXIOMTEK SBC81206 Series Bedienungsanleitung

AXIOMTEK

AXIOMTEK SBC84831 Series Bedienungsanleitung

AXIOMTEK

AXIOMTEK CAPA13R Bedienungsanleitung

AXIOMTEK

AXIOMTEK SHB106 Series Bedienungsanleitung

AXIOMTEK

AXIOMTEK SHB150R Series Bedienungsanleitung

AXIOMTEK

AXIOMTEK SHB210VGG Bedienungsanleitung

Beliebte Einplatinencomputer Handbücher anderer Marken

WIN Enterprises

WIN Enterprises PL-80910 Bedienungsanleitung

Embest

Embest SOM-PH8800 Bedienungsanleitung

SeaLevel

SeaLevel SBC-R9 Bedienungsanleitung

SMART Embedded Computing

SMART Embedded Computing ATCA-8310 Bedienungsanleitung

WinSystems

WinSystems PPM-LX800-G Bedienungsanleitung

GIGAIPC

GIGAIPC QBiX-PPC Series Bedienungsanleitung

OLIMEX

OLIMEX A10S-OLinuXino-MICRO Bedienungsanleitung

Commell

Commell FS-978 Bedienungsanleitung

GIGAIPC

GIGAIPC QBiP-8665A/ Bedienungsanleitung

VersaLogic

VersaLogic Python EBX-11 Bedienungsanleitung

Micro Computer Specialists

Micro Computer Specialists IRV-3702 Bedienungsanleitung

CompuLab

CompuLab SB-A510 Bedienungsanleitung

Boser

Boser HS-7321 Bedienungsanleitung

Premier Farnell

Premier Farnell Embest SBC8530 Bedienungsanleitung

MicroSys Electronics

MicroSys Electronics miriac SBC-LS1043A2 Bedienungsanleitung

Aaeon

Aaeon UP Bedienungsanleitung

Portwell

Portwell WUX Series Bedienungsanleitung

Lanner electronics

Lanner electronics IAC-F847 Series Bedienungsanleitung