Axis 450cc Bedienungsanleitung
Introduction450ccUtility
1-1
INTRODUCTION
Congratulations on your purchase of the 450cc Utility. This Owner’s / Operator’s manual will
provide you information regarding safe operation, operational instructions, maintenance and
care. Fully understanding this manual and following all of the instructions herein will provide
the knowledge needed to have safe and enjoyable UTV operation.
For questions regarding this UTV, please call (972) 446-0760.
IMPORTANT SAFETY MESSAGES
● READ THIS MANUAL CAREFULLY AND COMPLETELY BEFORE OPERATING YOUR UTV.
MAKE SURE YOU UNDERSTAND ALL INSTRUCTIONS.
● PAY CLOSE ATTENTION TO THE WARNING AND CAUTION LABELS ON THE UTV.
● NEVER OPERATE THE UTV WITHOUT PROPER TRAINING OR INSTRUCTION.
● THIS UTV SHOULD NOT BE RIDDEN BY ANYONE UNDER 16 YEARS OF AGE.
Introduction450ccUtility
1-2
IMPORTANT MANUAL INFORMATION
FAILURE TO FOLLOW THE WARNINGS CONTAINED IN THIS MANUAL CAN RESULT IN SERIOUS
INJURY
OR DEATH. Particularly important information is distinguished in this manual by the following
notations:
The Safety Alert Symbol means ATTENTION!
YOUR SAFETY IS INVOLVED!
Failure to follow WARNING instructions could result in severe injury or death to
the machine operator, bystander or a person inspecting or repairing the
machine.
A CAUTION indicates special precautions that must be taken to avoid damage
to the machine.
NOTE: A NOTE provides key information to make procedures easier to understand.
Introduction450ccUtility
1-3
IMPORTANT NOTICE
This UTV is designed and manufactured for OFF - ROAD use only. It is illegal and unsafe to operate this
UTV on any public street, road or highway.
This UTV complies with all applicable OFF - ROAD noise level and spark arrestor laws and regulations in
effect at the time of manufacture.
Please check your local riding laws and regulations before operating this UTV.
When the temperature is below -4°F (-20°C), park the UTV in a place where the temperature is higher
than -4°F (-20°C). Start the UTV after the UTV has warmed up. Please see page 7-3 on the warming up
process.
Follow the proper parking procedures when the temperature is higher than 100°F (38°C): turn off the
engine; make sure the radiator fan is on for 3 minutes before turning off the power switch.
Starting the UTV for the first time will take longer because the fuel will need reach the fuel injectors. To
start the UTV the first time, hold the ignition key on at 5-second intervals. Allow the starter to rest 15
seconds between each start attempt.
Introduction450ccUtility
1-4
UNIVERSAL SYMBOLS
As a guide to the operation of your vehicle, various universal symbols have been utilized on the
instruments and controls. The symbols are shown below with an indication of their meaning.
Safety Alert Symbol Lift Cylinder-Retract
Diesel Fuel Lift Cylinder-Extend
Engine coolant-Temperature Lift Cylinder-Float
Parking Brake Hazard Warning Lights
Battery Charging Condition High Beam
Engine Oil-Pressure Horn
Turn Signal/Hazard EPS System Error
Differential Lock 2WD/ 4WD
Position Lights
Introduction450ccUtility
1-5
Table of Contents
Subject Page
Introduction 1-1
Important manual information 1-2
Important notice 1-3
Universal symbols 1-4
Location of parts 1-7
Illustrated contents 1-8
Safe operation 2-1
Safety instructions 2-1
Operation 2-2
Children safety instructions 2-2
Driving on a slope 2-3
Driving in harsh conditions 2-3
Driving at high speed 2-3
Instructions for cargo bed 2-4
Parking 2-4
Transporting vehicle 2-4
Maintenance 2-4
Warning and caution labels 3-1
Servicing of vehicle 4-1
Specifications table 5-1
Vehicle limitations 5-3
Pre-operation 6-1
Operating the engine 7-1
Starting the engine 7-1
Cold starting 7-2
Stopping the engine 7-2
Warming up 7-2
Warming Up Transmission 7-2
Operating the vehicle 8-1
Operating new vehicle 8-1
Do not operate the vehicle at full
speed for the first 50 hours
8-1
Changing lubricating oil for new vehicles
8-1
Starting 8-1
Subject
Page
Seat belt 8-1
Head light switch 8-2
Hazard light switch 8-2
Turn signal light switch 8-2
Brake pedal 8-3
Range gear shift lever 8-3
4WD lever 8-4
Accelerator pedal 8-5
Stopping 8-5
Coolant temperature gauge 8-5
Winch operations 9-1
Transporting vehicle 9-1
Service intervals 9-2
Periodic service 10-1
How to open the front hood and seat 10-1
Front hood cover 10-1
Operator’s sea 10-1
How to raise the cargo bed 10-1
Raising and Lowering the Cargo Bed 10-1
Jack-up point 10-2
Front end 10-2
Rear end 10-2
Daily check 10-2
Walk around inspection 10-3
Checking and Refueling 10-3
Checking coolant level 10-3
Cleaning radiator screen 10-4
Checking brake fluid level 10-4
Checking brake pedal 10-5
Checking parking brake 10-5
Checking gauges and indicator lights 10-6
Checking head light turn signal light etc
10-6
Checking seat belt and ROPS 10-6
Checking joint boot 10-6
Introduction450ccUtility
1-6
Checking tire inflation pressure 10-6
Every 50 hours 10-6
Greasing 10-6
Checking engine start system 10-7
Checking wheel bolt torque 10-7
Cleaning air cleaner primary element 10-8
Checking battery condition 10-9
Adjusting toe-in 10-10
Cleaning muffler 10-11
Every 200 hour 10-11
Changing engine oil 10-11
Replacing engine oil filter 10-12
Replacing transmission oil 10-12
Checking brake pedal 10-13
Checking brake hose and pipe 10-13
Checking brake light switch 10-13
Checking radiator hose and clamp 10-13
Checking intake air tube 10-14
Every 300 hours 10-14
Checking tire 10-14
Every 400 hours 10-15
Changing transmission fluid 10-15
Changing front and rear axle case oil 10-15
Every 500 hours 10-15
Replacing fuel filter 10-15
Every 1500 hours 10-16
Checking injection and fuel pump 10-16
Every 1 year 10-16
Every 2 years 10-16
Flushing Cooling system and changing
coolant
10-16
Anti-freeze 10-17
Replacing radiator hose (water pipes) 10-18
Replacing fuel hose 10-18
Replacing brake master cylinder (inner
parts)
10-18
Replacing front brake seal 10-18
Replacing rear brake cylinder seal 10-18
Replacing intake air line 10-18
Every 4 years 10-18
Replacing brake hose 10-18
Replacing slow-blow fuses 10-18
Storage 10-19
Vehicle storage 10-19
Removing the vehicle from storage 10-20
Troubleshooting 11-1
Engine troubleshooting 11-1
Diagnostic trouble code table 11-2
Battery troubleshooting 11-3
Machine troubleshooting 11-4
Accesories 12-1
Emissions warranty 13-1
Introduction450ccUtility
1-7
LOCATION OF PARTS
Front TireFront Tire
Front Shock Absorber
Introduction450ccUtility
1-8
ILLUSTRATED CONTENTS
Introduction450ccUtility
1-9
Inhaltsverzeichnis
Andere Axis Nutzfahrzeug Handbücher
