Axkid Kidzone Bedienungsanleitung

Kidzone

Instruction manual

Rearward facing

9 - 25 kilo

Tested and approved according to

ECE R44 / 04

Forward facing with seat belt

9 - 18 kilo

Forward facing with adult belt

15 - 25 kilo

ank you for choosing a child seat from Axon Kids. e team developing Kid-

zone have more than 30 years of experience in child safety products between us,

and we have done our outmost to make this child seat as safe as possible.

e Kidzone child seat has of course also been tested and certied according to

ECE R/44 04, the latest European standard for child safety.

To maximize your child’s safety, please observe the following:

Read this instruction manual before assemble the

child seat in the car.

Read the instructions thoroughly before you attempt to install

the child seat. If you have any doubts, please contact your store

of purchase, which can show you the correct installation. Incor-

rect installation means danger to your child.

Never mount the child seat in a seat with an active airbag. If you

still wish to use the seat, disconnect the airbag at an authorized

service center, or if your car is equipped with it, use the key to

turn the airbag o. It is important to always note if the car’s in-

dicator shows that the airbag is turned o.

Keep the child seat facing backwards as long as possible. Studies

have shown that the risk for an accident to be fatal for your child

is ve times higher if your seat is front facing.

Always use the support leg when the seat is mounted backwards.

e support leg serves a very important safety purpose and is

designed to maximize your child’s safety in an accident.

In case of a car accident, no matter how small, always replace the

car seat. It may have invisible damage that seriously aects your

child’s safety. is is also the reason for why you never should by

a used child seat. Axon Kids recommendation is that you always

should buy a new chair in a store.

Important information

Contents

e Kidzone child seat is possible to use from when the child is approximately six

months, or can sit without support, up to about the age of six. e chair can be

mounted in three dierent ways, depending on your child’s age and size. A review

of the chair’s parts can be found on the next page. On the following pages you

will nd instructions on how to assemble your chair:

Rearward facing fastened with seat belt

is assembly can be used when the child weighs between 9 and 25 kilos (20 to

55 lb).

Forward facing assembly with seatbelt

If you want your child to sit forward and it weighs between 15 and 18 kilos, this

assembly can be used in all car seats with a three-point belt.

Forward facing with adult belt

Once the child has become large enough to sit forward and use the car’s three-point

itself, you can use your Kidzone as a booster seat. is assembly is suitable for chil-

dren weighing between 15 and 25 kilos.

For the safety of you child; Use backwards

assembly as long as possible

Never use this child seat in a car seat that is not

equipped with an approved three-point belt.

1. Belt guide top (Forward facing with

internal harness only)

2. Head support

3. Belt guides head support (Forward fac-

ing with vehicle 3 point belt)

4. Internal harness.

5. Lower belt guide. (Forward facing with

vehicle 3 point belt)

6. Adjuster for internal harness

7. Adjuster arm for seat angel

8. Base

9. Tether strap

10. Support leg

11. Adjuster handels for supportleg

12. Lock-o

13. Heel

14. Pocket for storing the manual

Never use the child seat in a car seat where

airbag hasn’t been disabled.

Rearward facing fastened with

seat belt

Important to remember

Never mount the child seat inaseatwith

an active airbag. If you still wish to use the

seat, disconnect the airbag at an authorized

service center, or if your car is equipped with

it, use the key to turn the airbag o. It is im-

portant to always note if the car’s indicator

shows that the airbag is turned o.

Place the chair

e simplest way to lift the child seat

into the car is with its back rst.

Place the child seat in the car seat and

turn it so that the back is facing the front

of the car. e heels of the seat (1) should

bend over the edge of the seat. e highlight

on the side of the heel should align vertically

with the end of the car seat. If you have a

small car, and the child is small enough not

to require extra leg room, you can instead

put the car seat with the heel up on the car

seat. When mounting the child seat in the

car’s front seat it is possible, but not crucial,

for the back of the child seat to have contact

with the dashboard.

Push down the lever for adjusting the

backrest angle (2). With the lever pushed

down, you can then adjust the seat and

choose one of its three tilt positions. e

choice of tilt position should be one that is

as upright as possible, but the child should

Continued on next page

be able to keep its head up on its own, and the

head should not hang forward if the child falls

asleep. e rule of thumb is that the older the

child grows, the more upright the tilt position

can be. Also note that the child seat will be angled

down slightly when it is clamped and sinks into

the car’s seat.

Fasten seat belt in the car

Open both belt lock-os(3) on the child seat.

Grasp the seat belt, and pull the belt roll. e lap

section of the belt should be at least 70-80 centi-

meters (27-32 inch) long.

Now place the belt through the hole in (4)

and push it under the fabric until it comes out on

the other side. If you prefer you can instead pull

the belt on top of the fabric.

Next step is to fasten the seat belt. Tighten

the belt rmly, the belt passing through or over

the seat should not have any slack. Fasten your

belt in belt buckle. In the belt lock-o closest to

the car-buckle both lap and shoulder belt should

be secured. In the belt lock-o on the opposite

side, only the lap belt should be secured.

Attach the tether straps

Your car may have two eyelets in the front seat

rails, or when mounting in the front seat, in front

of the same seat. When your car has no eyelet you

should instead use the supplied strap which is in

the child seat. If the child seat is installed in the

rear seat, put one end of the strap through either

the rear of the front seat rails or another suitable

fastening point in the front seat. e loop should

be as close as possible to the oor. Choose an ap-

propriate length of the strap and then put the

loop through one of the openings on the side of

Continued on next page

Skip this part

if your car is

equipped with

eyelets

the strap. When installing in the front seat the

strap has to be attached under the seat.

Pull out the strap(1) to an appropriate

length. Secure the fastening device in the loop

of the car or the strap. Repeat on the other side.

Tighten the straps by rmly pulling the end

strap.

Unfold the support leg (2) to its maximal

angle. Pull the latch on the upper length ad-

juster (3) and pull down the leg so that it gets

in contact with the car’s oor. If the leg still can-

not reach the oor, repeat on the bottom length

adjuster (3).

Now you could try to rmly pull the straps

to make sure that your seat is fully secured.

If you have mounted the child seat in the

rear seat of the car, move the front seat to a com-

fortable location. e seat’s backside can, but

must not, have contact with the car seat.

Adjust the seat belt

Place the child in the child seat. Place the

child’s arms in between the shoulder straps so

that the shoulder straps are hanging over the

chest and stomach of the child. Put together the

shoulder belts and fasten the buckle between

the child’s legs. Pull the adjustment strap (4).

is will tighten the belt and the headrest will

automatically slide down to the proper height.

To loosen the belt, hold down belt adjustment

and pull both belts.

Forward facing with seatbelt

Fixed installation of seat

Make sure the seat’s tilt is in its

0-position. If not, hold the adjust-

ment lever for its angle (1) change the

chair until it stands straight up.

Place your Kidzone on the seat.

Pull the car’s safety belt and place the

shoulder strap into belt guide(2) on

the upper side of the seat. en pull

the belt straight vertically down, on

the backside, to the nearest hole in

the backseat (3). Lap section of the

belt is simultaneously pulled up and

guided into the same hole as shoul-

der belt. Bring the belts through the

hole, across the front of the chair and

then back through the second hole

(3). Pull both belts horizontally across

the side on the chair and then down.

Fasten seat belts in the belt buckle and

secure it with the lock-o(4). Please

make sure that the belts hasn’t tangled

up or been folded anywhere.

Also make sure that both shoulder

and lap belt is securely fastened every-

where. Use your own weight to press

down the chair in order to automati-

cally fasten the seat belt further.

Never use the child seat in a car seat where

airbag hasn’t been disabled.

Continued on next page

Step 0

Step 1

Step 2

Adjust the seat belt

Place the child in the child seat. Place

the child’s arms in between the shoul-

der straps so that the shoulder straps is

hanging over the chest and stomach

of the child. Put together the shoulder

belts and fasten the buckle between the

child’s legs. Pull the adjustment strap (3).

is will tighten the belt and the head-

rest will automatically slide down to the

proper height. e headrest must always

be drawn down at least 35 millimeters.

ere is a line in the headrest which can

be detected with your ngers. If it is

behind the cover the headrest has been

pulled down correctly. (See picture A)

Make sure that the headrest is in the

locked position by pulling the belt ad-

juster one more time. e headrest shall

not move down when you pull the belt.

If it is impossible to get the headrest in

a locked position, the child seat should

instead be used as a booster seat (see next

chapter).

To loosen the belt, hold down the belt

adjuster and pull both belts.

Never use the child seat in a car seat where

airbag hasn’t been disabled.

is line should be hidden

behind the cover.

Picture A

Forward facing with adult belt

Important to remember

Never mount the child seat in a seat with

an active airbag. If you still wish to use

the seat, disconnect the airbag at an au-

thorized service center, or if your car is

equipped with it, use the key to turn the

airbag o. It is important to always note if

the car’s indicator shows that the airbag is

turnedo. Since the air bag is designed

for adults, it can seriously harm your

child in a crash.

Remove the seat belt

Since you are now going to use car

belts, you must rst remove the inter-

nal child seat belts.

Loosen the shoulder straps of the yoke

(1) and pull the belt up on the chair.

e part passing through the yoke

forming a loop, must be attached in

the neck rest’s xing plate(2).

After inserting the loop, pull down

the retaining plate and the headrest

to a height appropriate for your child.

Tighten the strap by pulling the belt

adjustment (3) in the front of the

chair.

Make sure the seat’s angle is in its

0-position. If not, hold the lever for

adjusting its angle (4) change the

chair until it stands straight up. Now

your Kidzone can be used as a booster

seat.

Continued on next page

Step 0

Step 1

Step 2

Andere Handbücher für Kidzone

Inhaltsverzeichnis

Andere Axkid Autositz Handbücher

Axkid

Axkid Minikid 3 Bedienungsanleitung

Axkid

Axkid SPINKID Bedienungsanleitung

Axkid

Axkid Babyfix Bedienungsanleitung

Axkid

Axkid Mate Bedienungsanleitung

Axkid

Axkid Minikid Bedienungsanleitung

Axkid

Axkid Modukid Bedienungsanleitung

Axkid

Axkid One Bedienungsanleitung

Axkid

Axkid Minikid Bedienungsanleitung

Axkid

Axkid ENVIROKID Bedienungsanleitung

Axkid

Axkid Duofix Bedienungsanleitung

Axkid

Axkid Minikid Bedienungsanleitung

Axkid

Axkid Modukid Bedienungsanleitung

Axkid

Axkid Keezone Bedienungsanleitung

Axkid

Axkid ENVIROBASE Bedienungsanleitung

Axkid

Axkid ENVIROBABY Bedienungsanleitung

Axkid

Axkid Duofix Bedienungsanleitung

Axkid

Axkid Modukid Infant Bedienungsanleitung

Axkid

Axkid Babyfix Bedienungsanleitung

Axkid

Axkid Wolmax Bedienungsanleitung

Axkid

Axkid Rekid Bedienungsanleitung

Axkid

Axkid Babyfix Bedienungsanleitung

Axkid

Axkid MODUKID INFANT 2 Bedienungsanleitung

Axkid

Axkid Nextkid Bedienungsanleitung

Axkid

Axkid Kidzone Bedienungsanleitung

Beliebte Autositz Handbücher anderer Marken

Britax

Britax PARKWAY SGL Bedienungsanleitung

JANE

JANE nurse cruiser Bedienungsanleitung

Digicom

Digicom Tippy Pad Bedienungsanleitung

Fisher-Price

Fisher-Price Futura 20/60 Bedienungsanleitung

Giordani

Giordani orion 012 Bedienungsanleitung

BRIO

BRIO ZENTO Bedienungsanleitung

Combi

Combi Zeus Turn 8815 Series Bedienungsanleitung

Graco

Graco Car Booster Seat Bedienungsanleitung

Coccolle

Coccolle Atira Bedienungsanleitung

hifold

hifold HF01-GL Bedienungsanleitung

CYBEX

CYBEX SOLUTION X2-FIX Bedienungsanleitung

kiwy

kiwy SLF 123 Bedienungsanleitung

Safety 1st

Safety 1st Summit ISO 30 Bedienungsanleitung

Safety 1st

Safety 1st Grand 2-IN-1 Bedienungsanleitung

Graco

Graco NAUTILUS Bedienungsanleitung

Britax

Britax Multi-Tech BB0-702-00 Bedienungsanleitung

Grammer

Grammer MSG45/421 Betriebsanleitung

Nuna

Nuna REBL PLUS Bedienungsanleitung