Axxess GMOS-LAN-09 Bedienungsanleitung

INSTALLATION INSTRUCTIONS FOR PART GMOS-LAN-09

REV. 9/11/2014 INSTGMOS-LAN-09

CAUTION: Metra recommends disconnecting the

negative battery terminal before beginning any

installation. All accessories, switches, and especially

air bag indicator lights must be plugged in before

reconnecting the battery or cycling the ignition.

NOTE: Refer to the instructions included with the

aftermarket radio.

• Providesaccessory(12-volt10-amp)

• RetainsR.A.P.(RetainedAccessoryPower)

• Usedinnon-amplifiedsystems

• Retainschimes

• ProvidesNAVoutputs(ParkingBrake,

Reverse,Mute,andspeedsense)

• RetainsOnStar/OEBluetooth

• AdjustablevolumeforchimesandOnStar

• RetainsOEAUXinput

• Highlevelspeakerinput

• USBupdatable

• Retainsbalanceandfade

• PrewiredASWC-1harness(ASWC-1sold

separately)

KIT FEATURES

•Cuttingtool•Crimpingtool•Tape•Connectors

(example:butt-connectors,bellcaps,etc.)

TOOLS REQUIRED

LAN-29 Data Interface

2014-up

GMOS-LAN-09

APPLICATIONS

•GMOS-LAN-09interface•GMOS-LAN-09

harness•16-pinharnesswithstrippedleads

INTERFACE COMPONENTS

CHEVROLET

Silverado1500 2014-up

Silverado2500/3500 2015-up

Suburban 2015-up

Tahoe 2015-up

GMC

Sierra1500 2014-up

Sierra2500/3500 2015-up

Yukon 2015-up

GMOS-LAN-09

From the 16-pin harness with stripped leads to the aftermarket radio:

• Connectthe(2)Redwirestotheaccessorywire.

Note: If installing the ASWC-1, there will be an accessory wire in the

12-pin harness to connect as well.

• ConnecttheOrange/White wiretotheilluminationwire.Iftheaftermarket

radiohasnoilluminationwire,tapeofftheOrange/Whitewire.

• ConnecttheWhite wiretotheleftfrontpositivespeakeroutput.

• ConnecttheWhite/Blackwiretotheleftfrontnegativespeakeroutput.

• Connectthe Gray wiretotherightfrontpositivespeakeroutput.

• ConnecttheGray/Blackwiretotherightfrontnegativespeakeroutput.

• ConnecttheBlue/White wiretotheampturn-onwire.

Note: This wire must be connected to turn the interface on.

• ConnecttheBrown wiretothemutewire.Iftheaftermarketradiodoesnot

haveaMutewire,tapeupthe Brown wire.Ifthe Brownwireisnotconnected,

theradiowillturnoffwhenOnStarisactivated.

Thefollowingwiresarefortheaftermarketradiosthathavenavigationbuiltin:

• ConnecttheLight Greenwiretotheparkingbrakewire(ifapplicable).

• ConnecttheBlue/Pinkwiretothespeedsensewire(ifapplicable).

• Connectthe Green/Purplewiretothereversewire(ifapplicable).

From the GMOS-LAN-09 harness:

(a) 16-pin harness to the aftermarket radio:

• ConnecttheYellowwiretothe12-voltbatterywire.

• ConnecttheBlack wiretothegroundwire.

• ConnecttheGreenwiretotheleftrearpositivespeakeroutput.

• ConnecttheGreen/Blackwiretotheleftrearnegativespeakeroutput.

• ConnectthePurplewiretotherightrearpositivespeakeroutput.

• ConnectthePurple/Blackwiretotherightrearnegativespeakeroutput.

(b) 22-pin harness to the aftermarket radio:

• TheBlack/YellowwireisfortheOnStarvolumeadjustment.Thiswillbe

discussedintheOnStarLevelAdjustmentsectionofthisinstruction.

• TheDINconnectorisforusewiththeoptionalAX-LCD(soldseparately).This

willgiveyoutheoptionofchangingthesettingsinyourpersonalizationmenu.

• ConnecttheWhiteRCAtotheaftermarketradio’sleftAudioAUXin.

• ConnecttheRedRCAtotheaftermarketradio’srightAudioAUXin.

Note: To retain the factory 3.5mm jack, the radio must have an Audio AUX in.

Connections to be made

GMOS-LAN-09

• Connectthe16-pinharnesswithstrippedleadsintotheinterface.

• Connectthe14-pin,16-pinand20-pinharnessintothevehicle.

• Withallconnectionscompleted,reconnectthenegativebatteryterminal.

• Initializetheinterfacebyturningtheignitiononfor30seconds,thenturnthe

ignitionbackoff,thenbackonagain.

Note: If using the ASWC-1, connect it after you initialize the GMOS-LAN-09,

with the key in the off position.

Installing the GMOS-LAN-09

Connections to be made

(d) 12-pin pre-wired ASWC-1 harness:

• ThisharnessistobeusedinconjunctionwiththeoptionalASWC-1(not

included)toretainsteeringwheelcontrols.IftheASWC-1isnotbeing

used,disregardthisharness.Ifitwillbeused,pleaserefertotheASWC-1

instructionsforradioconnectionsandprogramming.

Note: Disregard the harness that comes with the ASWC-1.

To the aftermarket radio:

• ConnecttheRedwiretotheaccessorywire.

• PushtheOnStarbutton;theradioshouldmute,andyoushouldheartheOnStar

voice.PushtheOnStarcancelbutton;theradioshouldun-muteandplayagain.

Note: The radio will turn off instead if the mute wire is not connected.

Testing the GMOS-LAN-09

To the vehicle:

• ConnecttheGreen/Blackwireto Green/Blackwireintheblack,8-pin

connectorbelowthesteeringcolumn,onthebottomside.(FigureA)

Note: The relay attached to the GMOS-LAN-09 harness is only for audible turn

signal clicks. No extra steps are required to retain this feature, so leave the

relay as-is.

Connections to be made

(Figure A)

Green/Black wire

INSTALLATION INSTRUCTIONS FOR PART GMOS-LAN-09

REV. 9/11/2014 INSTGMOS-LAN-09

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by

enrolling in the most recognized and respected

mobile electronics school in our industry.

Log onto www.installerinstitute.com or call

800-354-6782 for more information and take steps

toward a better tomorrow.

Metra recommends MECP

certified technicians

IMPORTANT WARNING

Thisproductincludesinstructionsforinstallation

whichmustbecarefullyfollowed.Theinstructionsare

wordedinsuchamannertoassumethattheinstaller

iscapableofcompletingthesetypeofelectronic

installations.Ifyouareunclearastowhatyouare

instructedtodoorbelievethatyoudonotunderstand

theinstructionssoastoproperlyandsafelycomplete

theinstallationyou should consult a technician who

does have this knowledge and understanding.

Failure to follow these instructions carefully and

to install the interface as described could cause

harm to the vehicle or to safety systems on the

vehicle. Interference with certain safety systems

could cause harm to persons as well. If you have

any questions in this regard please call the Help

line or Metra at 1-800-221-0932 for assistance.

Chime Volume Adjustment:

• Withthevehicleon,turnitoffandleavethekeyintheignition.Openthedriver’sdoor;

chimeswillbeheard.

• Wait10seconds,andthenwithasmallscrewdriver,turnthepotentiometerclockwisetoraise

thechimelevel;counterclockwisetolowerthechimelevel.

Note: The potentiometer is located on the side of the interface where the 16-pin harness with

stripped leads is connected to.

• Whenthechimelevelisatadesiredlevel,removethekeyfromtheignition.Thiswilllockthe

chimevolumeatitscurrentlevel.

OnStar Level Adjustment

• PresstheOnStarbuttontoactivateit.

• WhileOnStarisspeaking,presstheVOLUMEUPorVOLUMEDOWNbuttonsonthesteeringwheel

toraiseorlowertheOnStarlevel.

• Ifthevehicledoesnotcomeequippedwithsteeringwheelcontrols,findtheBlack/Yellowwireon

the22-pinharness.

• WhileOnStarisspeaking,taptheBlack/Yellowwiretoground.OncetheOnStarlevelisset, 

itwillstayatthatleveluntiltheBlack/Yellowwireistappedtogroundagain.

Adjusting the GMOS-LAN-09

Andere Axxess Aufnahmegeräte Handbücher

Axxess

Axxess GMOS-08 Bedienungsanleitung

Axxess

Axxess AXi-CANBOX1 Bedienungsanleitung

Axxess

Axxess AXDIS-VL42 Bedienungsanleitung

Axxess

Axxess AX-FD-SSO Bedienungsanleitung

Axxess

Axxess GMOS-05 Bedienungsanleitung

Axxess

Axxess AX-FD1-SWC Bedienungsanleitung

Axxess

Axxess AX-ADBOX1 series Bedienungsanleitung

Axxess

Axxess AXDSPX-GL44 Bedienungsanleitung

Axxess

Axxess AX-BM90122 Bedienungsanleitung

Axxess

Axxess AXDSPX-BM1 Bedienungsanleitung

Axxess

Axxess AX-DSP-A2B1 Bedienungsanleitung

Axxess

Axxess LC-CHRC-01 Bedienungsanleitung

Axxess

Axxess AX-AM-VW91 Bedienungsanleitung

Axxess

Axxess ASWC-1 Bedienungsanleitung

Axxess

Axxess ASWC-1 Bedienungsanleitung

Axxess

Axxess GMLAN-AMP-01 Bedienungsanleitung

Axxess

Axxess GMOS-LAN-10 Bedienungsanleitung

Axxess

Axxess AXTC-FD2 Bedienungsanleitung

Axxess

Axxess AX-MLINK-AVHD Bedienungsanleitung

Axxess

Axxess AXDIS-FD3 Bedienungsanleitung

Axxess

Axxess CHTO-02 Bedienungsanleitung

Axxess

Axxess AXTC-VW1 Bedienungsanleitung

Axxess

Axxess AX-CH013-SWC Bedienungsanleitung

Axxess

Axxess GMOS-09 Bedienungsanleitung

Beliebte Aufnahmegeräte Handbücher anderer Marken

KV2 Audio

KV2 Audio 500 Series Bedienungsanleitung

Robotics Technologies

Robotics Technologies microBus-Cam II Bedienungsanleitung

Seca

Seca 460 Bedienungsanleitung

Cognex

Cognex MVS-8000 Series Bedienungsanleitung

Mect

Mect MPNC006 Series Bedienungsanleitung

Bad Caf

Bad Caf THE LEASH Bedienungsanleitung

Strymon

Strymon NIGHTSKY Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric 16CH DIGITAL RECORDER DX-TL5000U Bedienungsanleitung

Tews Technologies

Tews Technologies TPMC465 Bedienungsanleitung

Honeywell

Honeywell Excel 50 Bedienungsanleitung

SeaLevel

SeaLevel COMM+8.LPCI Bedienungsanleitung

Arturia

Arturia AUDIOFUSE STUDIO Bedienungsanleitung

Rukra

Rukra RK-1240 Bedienungsanleitung

Samson

Samson SCOM Bedienungsanleitung

Dynacord

Dynacord DPS260 Bedienungsanleitung

Nice

Nice Core Bedienungsanleitung

Pyle Pro

Pyle Pro PSS8 Bedienungsanleitung

RF-System

RF-System TinyGate Gebrauchs- und Pflegehandbuch