Azden 300UPR Bedienungsanleitung

300LT SYSTEM

User’s Guide

300UPR • 30BT

ON-CAMERA

UHF WIRELESS MICROPHONE SYSTEM

Azden Corporation, 147 New Hyde Park Road, P.O. Box 10, Franklin Square, NY 11010

vox - 516.328.7500 • fax - 516.328.7506 • email - [email protected]

Printed in USA

Specifications

Due to constant improvements, specifications are subject to change without notice.

300UPR Receiver

Frequency Range UHF 240-Channel Selectable (794.000 – 805.950MHz)

Type of Reception Antenna Diversity Receiver

Oscillator PLL Synthesized

RF Squelch Level 15dBµ

Frequency Response 50Hz – 15kHz

S/N Ratio >70dB “A” Weighted

udio Distortion <1% @ 1kHz

Operating Temp. 0°C – 45°C (32°F – 113°F)

MIC Out -64dBm @ 600 Ω - 3.5mm Mini-Jack (unbalanced)

-58dBm @ 600 Ω - 3.5mm Mini-Jack (balanced)

Power Requirement 2 – 1.5V “AA” Alkaline Batteries - 6 – 8 Hours

Dimensions 63W x 98H x 28.5D mm (2.48W x 3.86H x 1.12D inches)

Weight Approx. 180g Including Battery (6.35oz)

30BT Transmitter

Frequency Range UHF 240-Channel Selectable (794.000 – 805.950MH)

Oscillator PLL Synthesized

RF Power 10mW (30mW Max.)

Frequency Response 50Hz – 15kHz

Max. Deviation ±40kHz @ 1kHz Modulation

S/N Ratio >70dB “A” Weighted

udio Distortion <1% @ 1kHz

MIC Sensitivity ±5kHz @ -60dBm MIC Input (0dBm=+0.775V) - 3.5mm Mini-Jack

Operating Temp. 0°C – 45°C (32°F – 113°F)

Power Requirement 2 – 1.5V Alkaline “AA” Batteries - 8 – 10 Hours

Dimensions 63W x 98H x 28.5D mm (2.48W x 3.86H x 1.12D inches)

Weight Approx. 170g Including Battery (6oz)

Important information

Licensing of this, or any Azden wireless equipment is the user’s responsibility. The ability to receive a license

depends largely on the user’s classification, application and frequency. Contact the appropriate agency (FCC in

the US) for further information.

These devices comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) These devices may not cause harmful interference, and (2) These devices must accept any interference

received, including interference that may cause undesired operation.

NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifica-

tions to this equipment. Such modifications could void the user's authority to operate the equipment.

These devices and their antenna(s) must not be co-located or operated in conjunction with any other antenna

or transmitter.

sound through the receiver’s phone output. If the sound

is distorted lower the mic input level on the transmitter. If

there is not enough volume raise the mic input level on

the transmitter.

4 1

Thank you for purchasing Azden’s 300LT wireless

system, which consist of the 300UPR receiver, 30BT

transmitter and EX-503L lapel microphone. This

equipment is designed primarily for video cameras but is

usable with most electronic components having a

microphone level input.

RECEIVER (300UPR)

(1) Remove the battery compartment lid by sliding it

down.

(2) Insert two fresh alkaline “AA” batteries into the

compartment. Make sure the battery polarity is correct

as marked inside the battery compartment.

In addition to the battery, inside the battery compartment

you will find:

(3) Phone level output adjustment: Using the supplied

tool, turn the dial clockwise to increase earphone output

level. Turn the dial counterclockwise to decrease

earphone output level.

(4) Power

Switches the Receiver “On” or “Off”.

(5) Mic Output Jack

The 300UPR is supplied with two cables.

For mini jack microphone inputs: Use the supplied mini-

to-mini cable. Plug the end of the cable with one black

band into the receiver. Plug the end of the cable with the

two black bands into the microphone input of the video

camera.

For 3-pin XLR microphone inputs: Use the supplied mini

to XLR cable. Plug the mini end of the cable into the

desired channel, numbered from 1 to 240. Once the

desired channel number has been selected on the

transmitter, set the receiver to the same channel number.

Operating the system

Because this is a frequency agile system, the receiver

and transmitter must be on the same channel number.

To change the channel number, use the tip of the

provided tool and press the UP or DOWN button to the

desired channel. Make sure both the receiver and

transmitter are on the same channel.

300UPR Receiver

After installing new batteries, mount the receiver to your

video camera with the supplied shoe mount or hook &

loop fastener. Select one of the supplied cables and

connect the output cable to the receiver and to the

microphone input on the video camera. Switch the

300UPR to “ON” and the battery level indicator should

come on. If it does not, check the battery. Plug an

earphone into the phone jack to monitor sound. Adjust

the phone volume as necessary. When the 300UPR

receives a signal from the transmitter the reception level

indicator will come on. If it does not make sure both the

receiver and transmitter are on the same channel.

30BT Transmitter

Plug in the supplied lapel microphone and clip it to your

subject. The microphone should be placed 4-12 inches

from your subject’s mouth. Clip the transmitter to a belt

using the supplied belt-clip (10) or place it in a pocket.

Switch the 30BT to “ON” and the battery level indicator

should come on. If it does not, check the battery. Have

someone speak into the microphone as you monitor the

2 3

receiver. Plug the XLR end of the cable into the

microphone input of the video camera.

(6) LCD Display

This display shows the following information.

Channels: Numbered from 1 to 240

Battery Condition: Using a 3 step indicator. (1 Low to 3

High)

Reception Level: Using a 4 step indicator. (1 Low to 4

High)

To change the channel number: Use the tip of the tool

provided and press the UP or DOWN button to the

desired channel, numbered from 1 to 240. Once the

desired channel number has been selected on the

receiver, set the transmitter to the same channel number.

(7) Phone Jack

Plug an earphone into this jack to monitor the sound.

You can use mono or stereo headphones.

(8) Shoe Stand

Attach the 300UPR to the shoe mount of the video

camera, by sliding it into place. Turn the thumbwheel

clockwise to tighten. Reverse this procedure to remove

the 300UPR from the camera.

BODYPACK TRANSMITTER (30BT)

(1) Remove the battery compartment lid by sliding it

down.

(2) Insert two fresh alkaline “AA” batteries into the

compartment. Make sure the battery polarity is correct

as marked inside the battery compartment.

In addition to the battery, inside the battery compartment

you will find:

(3) Mic Input Level Control

The Mic Input Level control enables you to adjust the

input level of the microphone. Using the supplied tool,

turn the dial clockwise to increase, or counterclockwise

to decrease the input level.

(4) Power

Switches the Transmitter “On” or “Off”.

(5) Mic Input Jack

Plug the supplied EX-503L microphone into the Mic Input

Jack and tighten the collar until snug. (DO NOT

OVERTIGHTEN) In addition other lapel and/or headset

microphones with 3.5mm mini plugs can also be used

with the 30BT.

(6) LCD Display

This display shows the following information.

Channels: Numbered from 1 to 240

Battery Condition: Using a 3 step indicator. (1 Low to 3

High)

To change the channel number: Use the tip of the tool

provided and press the UP or DOWN button to the

(9) Antennas

For best reception the antennas should be pointed in an

upward fashion. Use caution, and do not force them into

this position.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Azden Mikrofonsystem Handbücher

Azden

Azden 1201URX/VM Bedienungsanleitung

Azden

Azden WLX-PRO Bedienungsanleitung

Azden

Azden Body-pack Transmitter 35BT Bedienungsanleitung

Azden

Azden 105UPR Bedienungsanleitung

Azden

Azden WMT-PRO Bedienungsanleitung

Azden

Azden Body-pack Transmitter 35BT Bedienungsanleitung

Azden

Azden VHF PERFORMANCE Series Bedienungsanleitung

Azden

Azden IR-CSX Bedienungsanleitung

Azden

Azden 310UDR Bedienungsanleitung

Azden

Azden 1200BT Bedienungsanleitung

Azden

Azden SMX-100 Bedienungsanleitung

Azden

Azden Body-pack Transmitter 35BT Bedienungsanleitung

Azden

Azden 10BT Bedienungsanleitung

Azden

Azden 330UPR Bedienungsanleitung

Azden

Azden 105UPR Bedienungsanleitung

Azden

Azden 330UPR Bedienungsanleitung

Azden

Azden 1201XT Bedienungsanleitung

Azden

Azden UHF Performance Series Bedienungsanleitung

Azden

Azden 1000BT Bedienungsanleitung

Azden

Azden WHX-PRO Bedienungsanleitung

Azden

Azden WHX-PRO Bedienungsanleitung

Azden

Azden 200R Bedienungsanleitung

Azden

Azden EX-503 Bedienungsanleitung

Azden

Azden EX-503 Bedienungsanleitung

Beliebte Mikrofonsystem Handbücher anderer Marken

Paso

Paso R824 Bedienungsanleitung

Naxa

Naxa NAM-982 Bedienungsanleitung

Motorola

Motorola PMNN4461 Bedienungsanleitung

Xvive

Xvive U3 Bedienungsanleitung

Tekon

Tekon DUOS Bedienungsanleitung

Heyuan Intelligence

Heyuan Intelligence IOT-G2S-01 Bedienungsanleitung

Devine

Devine WMD-IE Bedienungsanleitung

LG LF-D7150 Bedienungsanleitung

GE S768DAV Bedienungsanleitung

LD U305 HBH 2 Bedienungsanleitung

Chainway

Chainway URA8 Bedienungsanleitung

ORATOR

ORATOR D860TD Bedienungsanleitung

Sennheiser

Sennheiser Evolution Wireless Digital EW-DX EM 2 Bedienungsanleitung

Alpha Technologies

Alpha Technologies RBMS Bedienungsanleitung

SWIT Electronics Co.,LTD.

SWIT Electronics Co.,LTD. CW-S150 Bedienungsanleitung

Shure

Shure UA844 Bedienungsanleitung

Panasonic

Panasonic SHFX70 - DVD HOME THEATER WIRELESS SYSTEM Bedienungsanleitung

Pyle

Pyle PDWM5000 Bedienungsanleitung