By Pushing the Control Panel Cover, the Load can be turned On/Off
-06-
-05-
-04-
INSTALLATION INSTRUCTIONS
The Sensor Switch is programmed independently for Vacancy Mode as
Manual On/Off Button
Turning On the Load under Vacancy Mode
Manual On/Off Button has to be pushed to turn On the Load.
Automatic Turning Off the Load
Under either mode, the Sensor keeps the Load On until no motion is
refer to the Band Switch position under the control panel cover.
under VAC mode. (Illustrated as Figure 5)
detected plus the set time delay, load(s) to be Off automatically.
OPERATION
---- the Night light will turn on under occupancy when load is off.
OFF
NOTE :
---- The Night Light keeps on constantly;
VAC
Conversely, the NIGHT LIGHT will turn off when load is on.
Figure 5
For WAVE-PIR-120/277-N, there is night
light behind the Fresnel Lens as follows:
Manual Turning Off the Load
By pushing the Manual On/Off button, the Load can be turned Off under
by any mode.
The Load turns On while no desired
1. Mask the Sensor Switch’s lens to eliminate unwanted coverage area.
2. Turn the Sensitivity Level knob toward left to avoid false alert in smaller
room and near the door way.
(Test Mode), make sure there is no motion (no LED flashing), the
detected. To verify proper operation, turn the Time Delay Knob to 15s
The Load is out of control (frequently flashing)
1. It can take up to three minutes for initial run.
2. Check the wiring connections, especially the
The Load does not turn On without LED flashing or LED flashing
1. Push Manual On/Off Button, if the load turns On; verify that Sensitivity
Range is on high. If the Load does not turn On, go to Step 2.
2. Check the wiring connections.
The Load does not turn On while LED flashing with motion detected
1. Check to see if Ambient Light Level is enable by covering the lens
2. Push Manual On/Off Button, if the load turns On; verify that Sensitivity
Range is on high. If the Load does not turn On, go to Step 3
3. Check the wiring connections, especially Hot Line and Ground wiring.
The Load does not turn Off
1. There can be up to a 30 minutes time delay after the last motion
regardless of motion
2. Check if there is any significant heat source mounted within six feet (two
meters) that may cause false detection such as high wattage light bulb,
portable heater and HAVC device.
3. Check the wiring connections, especially the Ground wiring to the
Ground Wiring .
by hand.
Load should turn Off in 15 seconds.
sensor switch.
WARRANTY INFORMATION
B.E.G. Controls warranties its products to be free of defects in
materials and
workmanship for a period of five (5) years.
There are no obligations or
liabilities on the part of our company
for consequential damages arising
out of or in connection with the use
or performance of this product or
other indirect damages with respect to
loss of property, revenue, or profit,
or cost of removal, installation or
reinstallation. Feb, 2017
The Time Delay knob is default set on 15 seconds, do not adjust it until
For proper operation, the Sensor Switch has to consume power from hot
Therefore, a
initial run is finished and proper operation function confirmed.
Ground Secured Ground Wiring is required.
and
TROUBLESHOOTING
Initial run
The Sensor Switch needs
During the
initial run, the load might be turned On and Off several times.
initial run within three minutes.
For technical support please call (770)
349-6341 and press "2" at the prompt, or
support is available Monday through Friday,
8:00 AM to 5:00 PM Eastern time.
