Operating Instructions
BöSha GmbH + Co. KG · Industriegebiet Heidberg 10 · D - 59602 Rüthen
Ph.: ++49 - (0)2952 – 97091-0 · Fax: ++49 - (0)2952 – 97091-150 · Email: info@boesha.de ·
www.boesha.de
MU/26.04.2016 13:33:00/BS671.doc 26.04.2016 13:33:00
Type Rated voltage Frequency Lamp wattage Current consumption
approx.
BS 685
BS 685
BS 686
BS 686
BS 687
BS 687
BS 688
BS 688
BS 689
BS 690
BS 691
BS 692
BS 693
230 V
0-50/60 Hz
3 x 36 W
3 x 40 W
4 x 36 W
4 x 40 W
3 x 36 W
3 x 40 W
4 x 36 W
4 x 40 W
3 x 55 W
4 x 55 W
3 x 80 W
4 x 80 W
8 x 18 W
0.47 A
0.52 A
0.63 A
0.70 A
0.47 A
0.52 A
0.63 A
0.70 A
0.72 A
0.96 A
1.04 A
1.39 A
0.63 A
Installation and connection
The projectors of type BS 67.., BS 68.. and BS 69.. may be installed in any position. Mounting straps being
attached to the enclosure serve as mounting aid for wall mounting, or eyebolts for suspension from a ceiling.
Beneath the reflector, there is the terminal compartment containing a terminal board, a protective ground
conductor terminal and a terminal diagram. The mains power supply line is fed through a cable entry into
the terminal compartment and is connected to the terminal board and the ground conductor terminal
according to the enclosed terminal diagram. In case the projectors are equipped with plug and socket
connectors there is no terminal board, and the internal wiring is already installed by the manufacturer.
ATTENTION! If the enclosure is equipped with threaded sleeves these will have thread M 36 x 1.5!
Starting operation
Before starting operation of luminaires with cable entries care must be taken that the terminals of the
connecting cables are properly tightened and the enclosure of the projector is tightly closed (check the
screws in the lid and the cable entries or the plug and socket connectors).
Repair
Defect illuminants (customary four-pin compact fluorescent lamps with socket 2 G 11 – 36, 40, 55 or 80 W
– or customary bi-pin fluorescent tubes with G 13 sockets – 18 W) may be exchanged by the operator
himself, under the condition that the installation instructions are regarded. For this purpose versions without
micro switches have to be completely de-energized; for versions with micro switches this is not required as
the lamp holders become de-energized when the lid is opened (see warning label on the housing lid or – in
case there is a micro switch – on the reflector: Do Not Open While Energized!). Regard has also to be paid
