bajaj electricals limited Page 2of 2
•Do not attempt to repair the unit at home or allow any unauthorised person to do so
either.
•In the event of the unit needing attention, take it to the nearest Bajaj authorised service
dealer or branch service center.
IDENTIFICATION OF PARTS
HOW TO USE THE JUICE EXTRACTOR
01. Place the mesh housing on the main motor body unit.
02. Keep the mesh at its place inside the mesh housing.
03. Place the top cover over the mesh housing onto the juicer body and lock the side clamps.
Note that the Juice Extractor will not operate until the side clamps are locked in
place.
04. Keep the Pulp container & Juice container at their respective places. To keep the pulp
container in place, align the top horizontal edge of the pulp container with the top cover
edge, just below the view window on both the sides and push it firmly towards the vertical
edge of the top cover. Press the pulp container downwards to lock it firmly in place.
05. Wash and cut the fruit/vegetables to pieces, small enough to feed them through the feeder.
06. Plug in the unit to the power supply, switch on. Push the fruit/vegetable pieces through the
feeder with the help of pusher.
07. The juice will be collected in the juice container and the pulp will fall into the pulp container.
08. Remove the juice and the pulp from the respective containers whenever they are full. For
removing the pulp container, press the pulp container upwards and just pull it out.
09. At the end of the operation switch off the unit, unplug.
10. Unclamp the top cover and remove. Remove the mesh from the unit; clean it with the help
of nylon wire brush under a jet of tap water.
11. Clean the juice/pulp containers with the help of liquid detergent and water.
12. After drying, re-assemble the unit as described above and store it properly for the next use.
