BAK Thermoplastic Welding Technology AG
WARRANTY AND LIABILTY
Warranty and liability apply from the date of purchase
(documented by the invoice/delivery note) according to the
currently valid general terms of business from BAK. BAK
refuses to honour any warranty for devices which are not in their
original condition. BAK devices may never be reconfigured
and/or modified.
BAK reserves the right to deny any responsibility if this is
ignored. No liability can be assumed by BAK for incorrect
installation and/or use as well as natural wear and tear of
components (e.g. heating elements).
Note:
This operating manual must be available to the installation and
operating personnel at all times. Read these operating
instructions carefully before installing and using the device.
Copyright:
This document must not be disclosed to third parties without the
explicit written approval of BAK. Any forms of reproduction or
copying and electronic storage are prohibited.
INTENDED USE
Heating-up for forming, bending and sealing of
thermoplastic semi-finished materials.
Drying of water-damp surfaces and joints.
Shrinking of heat-sink sleeves, films, tapes, solder sleeves
and moulded parts.
Activating / dissolving of of solvent free adhesives and
fusion adhesives.
Removing old shellac, oil and resin paints and under seals
on vehicles.
Defrosting of frozen water pipes.
