Barco Coronis Fusion 4MP Bedienungsanleitung

Getting Started Guide

Nio Fusion 4MP

(This page intentionally left blank.)

This document is copyrighted. All rights are reserved. Nor this

document, nor any part of it, may be reproduced or copied in any form

or by any means - graphical, electronic, or mechanical including

photocopying, taping or information storage and retrieval systems -

without written permission of Barco

Table of Contents

Preface ....................................................................................... 5

Environmental information................................................................. 9

Safety Instructions............................................................................. 10

Explanation of symbols ..................................................................... 13

Introduction ............................................................................. 15

Display parts, controls and connectors............................................. 16

Front............................................................................................ 16

Rear............................................................................................. 17

Connectors .................................................................................. 19

Display installation .................................................................. 23

Installation precautions..................................................................... 24

Connecting the signal cables ............................................................ 25

Cable routing ..................................................................................... 28

Vesa-mount installation.................................................................... 29

Where to get more information .............................................. 31

Troubleshooting ....................................................................... 35

General tips........................................................................................ 36

Warranty Statement ................................................................ 41

Preface

Table of Contents

Notice

Although every attempt has been made to achieve technical accuracy in

this document, we assume no responsibility for errors that may be

found. Our goal is to provide you with the most accurate and usable

documentation possible; if you discover errors, please let us know.

BarcoView software products are the property of BarcoView. They are

distributed under copyright by Barco N.V. or BarcoView, LLC., for use only

under the specific terms of a software license agreement between

Barco N.V. or BarcoView LLC. and the licensee. No other use, duplication,

or disclosure of a BarcoView software product, in any form, is

authorized.

The specifications of BarcoView products are subject to change without

notice.

Trademarks

All trademarks and registered trademarks are property of their

respective owners.

FCC Compliance Information (display)

This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the

limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

Table of Contents

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for

help.

Canadian notice

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la Classe A est conforme à la norme NMB-

003 du Canada.

FCC Compliance Information (display controller)

CLASS B:

This Barco Graphics Controller complies with part 15 of the FCC rules.

Operation is subject to the following two conditions:

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC rules. These limits

are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in

accordance with manufacturer’s instructions, may cause harmful

interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Re-orient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

1. This device may not cause harmful interference, and

1. this device must accept any interference received, including

interference that may cause undesired operation.

Table of Contents

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for

help.

The use of shielded cables for connection of the monitor to the

graphics card is required to ensure compliance with FCC regula-

tions. Changes or modifications to this unit not expressly

approved by Barco could void the user’s authority to operate this

equipment.

Environmental information

Disposal Information

The lamps inside the display contain mercury. Do not throw the display

in the trash. Dispose of it as required by local ordinances or regulations.

This equipment has required the extraction and use of natural resources

for its production. It may contain hazardous substances for health and

environment.

In order to avoid the dissemination of those substances in the

environment and to diminish the pressure on natural resources, we

encourage you to use the appropriate take-back systems.

Those systems will reuse or recycle most of the materials of your end-

of-life equipment in a sound way.

The crossed-out wheeled bin symbol invites you to use those

systems.

If you need more information on the collection, reuse and

recycling systems, please contact your local or regional waste

administrator.

You can also contact us for more information on the environmental

performances of our products.

Safety Instructions

General Recommendations

Read the safety and operating instructions before operating the display.

Retain safety and operating instructions for future reference.

Adhere to all warnings on the display and in the operating instructions

manual.

Follow all instructions for operation and use.

Electrical shock

Type of protection (electrical):

Display with external power supply: Class III equipment

Degree of safety (flammable anesthetic mixture):

Equipment not suitable for use in the presence of a flammable

anesthetic mixture with air or with oxygen or nitrous oxide.

Non-patient care equipment

Equipment primarily for use in a health care facility that is intended for

use where contact with a patient is unlikely.

Power connection - display with external power supply

• Power requirements: The display must be powered using a

medical approved 24 VDC SELV power supply.

• The medical approved DC power supply must be powered by the

AC mains voltage.

Andere Handbücher für Coronis Fusion 4MP

Inhaltsverzeichnis

Andere Barco Monitor Handbücher

Barco

Barco Eonis MDRC-2222 WP Bedienungsanleitung

Barco

Barco Coronis Fusion 6MP Bedienungsanleitung

Barco

Barco MDRC-2124 TS Betriebsanleitung

Barco

Barco Coronis 21-inch Installation & user manua Bedienungsanleitung

Barco

Barco Coronis Uniti MDMC-12133 Bedienungsanleitung

Barco

Barco OLite 510 Bedienungsanleitung

Barco

Barco OverView EVD4621 Betriebsanleitung

Barco

Barco MDSC-1119 Bedienungsanleitung

Barco

Barco OPScenter Bedienungsanleitung

Barco

Barco MDFC-8232 3SW Bedienungsanleitung

Barco

Barco RHDM-1701 Bedienungsanleitung

Barco

Barco Coronis Bedienungsanleitung

Barco

Barco Nio systems Bedienungsanleitung

Barco

Barco MDSC-1119 Bedienungsanleitung

Barco

Barco MDSC-2224 Bedienungsanleitung

Barco

Barco RDDS Bedienungsanleitung

Barco

Barco MDRC-2122 WP Bedienungsanleitung

Barco

Barco MDNG-3220 Bedienungsanleitung

Barco

Barco Coronis MDCC 2121 Bedienungsanleitung

Barco

Barco HALO Bedienungsanleitung

Barco

Barco MDSC-1119 Bedienungsanleitung

Barco

Barco MFCD 1219 (TS) Bedienungsanleitung

Barco

Barco Coronis 3MP LED Bedienungsanleitung

Barco

Barco MDMG-5221 Bedienungsanleitung

Beliebte Monitor Handbücher anderer Marken

Linear Acoustic

Linear Acoustic LQ-1000 Bedienungsanleitung

AOC

AOC I2579V Bedienungsanleitung

Gateway

Gateway FPD1520 Bedienungsanleitung

Furuno

Furuno Mu 120c Bedienungsanleitung

Asus

Asus VB171D - 17" LCD Monitor Bedienungsanleitung

Dell

Dell S2230MX Gebrauchsanweisung

Philips

Philips 107C64 Bedienungsanleitung

Dell

Dell S2409WFP Bedienungsanleitung

EverFocus

EverFocus EN-7517E Bedienungsanleitung

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Bedienungsanleitung

Dell

Dell Precision 7680 Bedienungsanleitung

LG 50PM1M - - 50" Plasma Panel Bedienungsanleitung

Bosch

Bosch DDU 9 Bedienungsanleitung

Acer

Acer A231HL Bedienungsanleitung

Philips

Philips 86BDL4152T Bedienungsanleitung

NEC

NEC AccuSync LCD5V Bedienungsanleitung

Emay

Emay SleepO2 Bedienungsanleitung

IBM

IBM 6360 Montageanleitung