BARON AIR-RIDE (B.A.R) – REMOTE CONTROL
Universal Fitment
BA-8610-00
Included In Kit:
•Black Receiver
•Black Relay
•Remote Solenoid
•Airline Splitter
•Airline Tubing
•(2) Remote Keyfobs
Tools Required:
•Soldering Iron (recommended)
•Heat Shrink Tubing (recommended
•Wire Cutters
•Wire Strippers
•Electrical Tape
•Butt Connectors
Thank you for purchasing the Baron Air Ride Remote Control. Installation is reasonably simple providing
you follow the instructions below implicitly. As always, please read the instructions in full prior to
installing the product. If you feel you don’t understand it, please call our tech support line, or have the
product installed by a professional technician. We strongly suggest that all connections be soldered and
covered with heat shrink tubing for best results and longevity.
Revision 2.0 (05/10/07)
1. Locate a position for the timer, transmitter and solenoid (keep these in a dry location).
2. Using a cigar cutter or new razor blade, cut and splice-in the new airline splitter and length of hose,
then attach to solenoid. Be sure to leave room for the line to reach your dump valve (included with the
Air Ride system).
3. Attach one wire from the solenoid to chassis ground. The other wire from the solenoid goes to the
white wire on the receiver.
4. Attach 2 black wires from the receiver to chassis ground.
5. Attach black and yellow wires from relay to chassis ground.
6. Attach green wire on receiver to white on the relay.
7. Blue wire from the relay should be attached to both manual switch and black wire that goes to the
compressor.
8. Remaining black wire on manual switch should go to chassis ground.
9. Attach red wire on receiver and orange wire on compressor to battery positive (+).
10. Adjust dump speed by turning brass nut/screw in on solenoid to slow the dump or turn out to speed it
up. Wire not used: Blue on Receiver
Left button on keyfob will raise bike to desired cycle time (6 or 15 seconds). Right button on keyfob is
momentary dump.
See Wiring Diagram on reverse page
311 #1 Industrial Way - Fallbrook, CA 92028 - USA
Phone: (760) 731-1200 Fax: (760) 731-1284
Website: www.baronscustom.com
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or fitment
may be required. Baron bears no responsibility on installation costs associated with this product.
© 2007 Baron Custom Accessories
