- 20 -
Installation of the water filter system
1. Close the shut-off valve on the water supply line and disconnect the terminal unit from
the power supply.
2. Install the water filter system using the wall mounting bracket in the desired place.
During the installation observe the mounting dimensions and hose bending radius.
CAUTION! Only hoses with flat gaskets may be used at the connection joints, because
hoses with cone seat unions would damage the filter head connections, which will void
the warranty.
3. Close the shut-off valve on the water supply hose (IN), in order to cut off the water
supply. Connect the hose for flushing the water filter system to the water outlet (OUT).
a. The water from the hose connected to the water outlet (OUT) should be
drained to the appropriate container (e.g. bucket).
b. Open the shut-off valve on the water supply line and flush the water filter system
until the water starts flowing evenly without air bubbles.
c. Close the water supply with the shut-off valve.
4. Connect the hose which will connect the water outlet (OUT) with the terminal unit.
5. Open the water supply and connect the terminal unit to the power supply.
6. Check the system for leakages.
Replacement of the water filter system
1. The water filter system needs to be replaced after reaching a specified volume
(depending on the carbonate hardness) during the period defined by the manufacturer,
but not later than within 6 months after its launch (whatever comes first).
During the replacement of the water filter system, write down the date of the next
expected replacement (a date in the date field on the filter).
CAUTION! During the replacement of the filter inspect all the parts of the device!
Replace damaged parts and clean the contaminated ones. Do not use abrasive
agents, cleaning solutions or coarse cleaning materials.
2. Before the first use of the product in the recommended ambient temperature, after
being stored or transported in the temperature below 0°C, leave the device for at
least 24 hours in an open original packaging.
3. Close the water inlet and disconnect the power supply from the terminal unit.
4. Before the filter’s replacement, open the drain valve in order to reduce the pressure in
the system.
