Intended use
Read the usage and maintenance in-
structions carefully before mounting the
spyhole. Keep the manual with you for
future use. If the product is passed on to
any third party, include the manual withit.
Warnings: There should be no dangers
whatsoever expected in the pro-
fessional assembly and operation
compliant with the instructions.
Small parts and packaging mate-
rials can be swallowed by children
and lead to choking! Make sure that small
parts and packaging materials do not get
into the hands of children. Dispose of the
packaging material immediately.
Please read these operating instructions
before using the device. The camera or
main body MUST NOT be dismantled.
Please handle the device carefully. In or-
der to prepare for the assembly, please
loosen the two screws on the lower side
of the viewer, take out the retaining plate
and remove the protective film.
The manufacturer expressly reserves the
right to make technical changes.
Disclaimer
The manufacturer accepts no liability for
damage or injury resulting from incorrect
handling.
Disposal
Help to protect the environment
and dispose of the product and the
packaging materials in accordance with
the local regulations. Do not dispose of
the device in household waste! Electronic
devices must be disposed of in accord-
ance with the directive on waste electri-
cal and electronic equipment via the lo-
cal collection points for waste electronic
equipment!
BEFORE THE ASSEMBLY:
Please put in the battery first before you
install the door viewer.
Assembly:
Step 1:
Remove the retaining plate of the digi-
tal door viewer by loosening the 2 lower
fastening screws and put in the batteries
properly.
Step 2:
Remove existing viewer or drill a 14 mm
wide hole in the door at eye level. Put in
the camera form outside and simultane-
ously place the washers between back of
the lens and the door. Make sure that the
arrow at the front of the camera points
upwards.
Step 3:
Now route the camera’s connection ca-
ble withe the plug on the inside of the
door through the retaining plate.
Place
the retaining plate over the end of the
camera lens and then screw the fasten-
ing cylinder on the camera threads; this
will fasten the place on the door. You can
now secure the plate with two or three
screws (enclosed). Make sure that the ar-
row on the plate points upwards.
Step 4:
The camera’s connecting wire should
now be properly connected at the
bushing at the back of the door view-
er (see WARNING); excess wire should
be fastened behind the small hook.
General notes
