Bavis Transaction Drawer Bedienungsanleitung
Extra Small (XS) Transaction Drawer
Manual Operation Kit
Installation Manual
E. F. Bavis & Associates, Inc.
201 Grandin Road
Maineville, Ohio 45039
(513) 677-0500
Copyright 2011 E. F. Bavis & Associates, Inc. Revised 8/17/2011
All Rights Reserved P/N 00624021
Extras Small Transaction Drawer
Manual Operation Kit Installation Instructions
The manual operation kit for the Transaction Drawer™ is intended to allow operation of the
drawer in the event of a power outage or failure of the drive system on the drawer. This kit
consists of a switch assembly, which deactivates the dynamic brake system on the motor when
the manual rod is inserted into the drawer, a manual operation rod with knob, and a manual rod
receiving block, which attaches to the drawer of the Transaction Drawer™. The drawer is
operated by pushing and pulling on the rod, which opens and closes the drawer.
Warning - Risk of electrical shock - Disconnect power before servicing.
To install this kit requires removal of the back panel of the drawer.
Access to the inside of the drawer is through the back (Fig. 1). There are three screws on the
face and two on the bottom that hold the back panel in place. After removing the screws, tilt the
bottom of the back panel out until the side flanges clear the bottom of the shell, and then drop it
down to clear the lip of the top panel. Reverse this procedure to reinstall the back panel.
Figure 1
REMOVE SCREW
REMOVE SCREW
REMOVE SCREW
REMOVE SCREW
1
Slide the manual rod receiving block between the right side slide angle and the shell of the
drawer. Line up the clearance holes in the side slide angle with the drilled and tapped holes in
the receiving block. Secure with the 1/4-20 bolts provided.
Install the switch assembly onto the back panel, by placing the holes in the bracket over the studs
provided on the right side of the back panel, so the side of the bracket with the switches on it is
facing the outside of the drawer. Secure with the 4-40 nuts provided.
Disconnect the red wire of the motor, which connects to the red wire coming out of the wire
chase above the motor.
Connect one red wire of the switch to the red wire of the motor and the other red wire of the
switch to the red wire coming out of the wire chase above the motor.
Reinstall the back panel with wires routed away from moving drawer slide.
To use the manual rod:
Remove the 5/8" Hole Plug from the right side of the back panel. Slide the manual rod into the
hole until it contacts the receiver block. Tighten the rod clockwise until it seats. Push and pull
on the rod to operate the drawer.
Note: TD motor will not run while manual rod is inserted.
Remove the rod and install the 5/8" hole plug back into the hole once normal operation has been
restored.
Note: The Red Bin cannot be removed with the Receiving block installed.
Figure 2
2
Inhaltsverzeichnis
Andere Bavis Industrieanlagen Handbücher
