•Please read through all instructions before mounting and using this fireplace.
•This fireplace is designed to mount onto the wall and not recessed within a wall.
•This product should be wall-mounted at least 1 ft. above the ground. A 2 ft. height is recommended.
•There should be at least 3.5 ft. clearance between this product and the ceiling.
•The wall bracket on this product should only be fit horizontally.
•The cable should only be routed to the bottom right of the heater.
•Only use this heater with an AC power supply with the correct voltage.
•Do not plug in other devices into the same circuit.
•Do not turn the appliance on until it is properly installed.
•Do not leave appliance unattended during use or when plugged in.
•Do not let children operate or go near this appliance.
•Do not let children or small pets near during mounting and installation.
•Do not operate this product if the cord or any parts of this appliance are damaged. Do not attempt to
modify the cord.
•Periodically check the cord and appliance for damage.
•Do not run cord under rugs, furniture, etc.
•Do not allow cord to hang over sharp edges or place near hot surfaces.
•Do not cover or obstruct the heater in any way.
•Do not attempt to replace the LED bulbs. Only a licensed and qualified electrician should do so.
•Repairs to this appliance should only be performed by a licensed and qualified electrician.
•Do not attempt to open the back panel unless the electricity is turned o.
•Disconnect and discontinue use of this appliance if any water damage occurs, or if the unit becomes
hot to the touch, broken, or smokes/smells like smoke.
•Do not dispose of this appliance as unsorted waste. Use special collection facilities for electrical
appliances.
NOTE: When the heat function is turned on for the first time, a slight odor may be present. This is normal
and should not occur again.
NOTICE Please retain these instructions for future reference.
| 3
SPECIFICATIONS
Power Supply
Rated Power
120 V/60 Hz
750 W/1500 W
