Bebe Care Mira Lite Bedienungsanleitung

MIRA LITE

STROLLER

MODEL # 011230

IMPORTANT: RETAIN FOR

FUTURE REFERENCE,

READ CAREFULLY

Fingers or parts of the body could be injured when the stroller is being folded or unfolded. Please use

caution when folding or unfolding the stroller.

Always check that safety locks are engaged before placing a child in the stroller.

Ensure your child is secured with a correctly adjusted safety harness.

Do not allow children to stand on the seat.

Do not hang bags or goods from the handle as this could cause the stroller to tip over.

Do not place more than 5kgs in the basket or 1kg in the hood pocket (if supplied).

The weight of the child using the product should not exceed 20kgs.

The height of the child using the product should not exceed 96cm.

It is unsafe to use parts other than those approved by the manufacturer.

Never ride with more than one child in the stroller.

Regularly inspect all parts and locking devices, promptly replace worn out or broken parts.

Never leave a child in the pram/stroller when ascending or descending stairs or escalators or when

travelling on other forms of transport.

To prevent the risk of the stroller catching ﬁre, do not park it near an open ﬁre, heater or barbeque.

Do not make any changes or alterations to this product, unless through an approved service agent.

To avoid the risk of suffocation, keep all plastic packaging materials out of reach of children.

Never leave safety harness connected when not ﬁtted to a child in the stroller as this may create loops

that could cause a strangulation hazard.

Ensure the storage latch is fully engaged when lifting or carrying the stroller

TO AVOID INJURY OR DEATH:

ALWAYS APPLY THE BRAKES WHENEVER THE STROLLER IS

STATIONARY.

DO NOT LEAVE CHILD UNATTENDED.

SECURE THE CHILD IN THE HARNESS AT ALL TIMES.

DO NOT CARRY EXTRA CHILDREN OR BAGS ON THIS STROLLER.

MAKE SURE CHILDREN ARE CLEAR OF ANY MOVING PARTS IF

YOU ADJUST THE STROLLER.

TO AVOID INJURY ENSURE THAT YOUR CHILD IS KEPT AWAY

WHEN FOLDING AND UNFOLDING THE STROLLER.

ENSURE THAT ALL LOCKING DEVICES ARE ENGAGED BEFORE USE

WARNING

Before assembling this stroller, read and understand the instructions. Incorrect assembly may make the stroller

unsafe. Do not use this stroller if any part is broken, torn or missing. Keep instructions in a safe place for future

reference.

SAFETY PRECAUTIONS

Due to variations in the style and design of our products, the photographs and illustrations

shown in this instruction manual are generic, therefore product fabrics, colour and design

may vary from images shown. CNP Brands reserves the right to alter product speciﬁcations

without notice as a result of our ongoing policy of product improvement.

Assembly contents list

Assembly / Operating instructions

Stroller accessories

How to care for your bebe care stroller

Contents

Congratulations on your purchase of the

bebe care Mira Lite Stroller.

This product has been designed and developed with

safety, comfort and functionality in mind. Please take

the time to read this manual carefully before using

this product and keep it in a safe place for future

reference.

Lx1

Rx1

Check what you have received...

You have received 1 box. Please check the contents of the box against the list below. If anything is

missing, please contact Customer Service. In Australia, contact CNP Brands on 1300 667 137, in

New Zealand contact Wainhouse Distribution on 0800 567 5000.

Supplied loose in box:

Dual front swivel wheels

Canopy

Bumper bar

Car seat adapters

(Britax: Orion / Strider / Cruiser)

Stroller frame, with the following components

pre-assembled on frame:

Rear wheels

Basket

Assembly Contents

Unfolding the stroller

1. Hold down the stroller by the handles and release the storage

lock.

Front swivel wheels assembly

1. Push wheel ﬁrmly onto the mounting point on the front legs.

ensure arrow on swivel housing is pointing upwards. Push until

wheel clicks into position.

2. Pull back on wheel to ensure that it is secure.

3. Repeat for other front wheel.

2. Lift the handles and allow the front legs to drop towards the

ﬂoor. Do not try to open the stroller by forcing the handles apart.

Emsure the storage lock is released.

3. Push down on the lower locking bar until the frame is fully opened

and locked. (Check that both the upper and lower locking bars

are fully engaged).

Assembly Instructions

To use brakes

1. To lock brakes, push down on each

brake lever with foot.

2. To release brakes, lift each brake

lever up with foot.

CAUTION: Always apply both brakes

when parking stroller.

To adjust the seat extension

1. Lower the seat extension by pressing up the release latches

located underneath on both sides of the seat extension.

2. Push down and raise the seat extension by lifting it until the

release latches lock into place.

CAUTION: Do not adjust the extension while the child is in the stroller

Front swivel function

1. To lock swivel function on front

wheels, lift the locking clip up. The

swivel wheels can only be locked

when the wheels are in the trailing

position under the frame (wheels

under frame).

2. Push the locking clip down to allow

the wheels to swivel.

Lock Unlock

To attach canopy

1. Slide the canopy clips onto the

mounting brackets on the stroller

frame.

2. Attach the velcro loops around the

top of the frame as shown.

Assembly Instructions

Lock Unlock

To adjust canopy

To open the canopy, pull the canopy forwards and ensure the locking

hinge is locked into position by pushing it downwards. To close the

canopy, push the centre of the locking hinge upwards to unlock it, and

pull the canopy back.

To adjust sunvisor

To open the sunvisor, pull it downwards. To close the sunvisor, fold it

back up into the hood.

Adjusting the backrest

This stroller has an adjustable backrest. The upright position on the

backrest is not suitable for use with children less than six months old.

For use with a newborn (0-6mths), the seat should be fully reclined. The

backrest should only be adjusted to a more upright position as the child

grows older and is able to support their head without assistance.

1. To lower the backrest; pull backrest adjusting lever upwards and

lower to desired position. Release lever.

2. To raise the backrest; push the backrest upwards.

CAUTION: Do not adjust the backrest while child is in the stroller.

Assembly Instructions

Mesh canopy extension

Unzip the mesh section of canopy carefully. The canopy can then be

adjusted forward or backward to allow ventilation through the mesh

sections.

Restraints - Harness

1. To secure the child in the harness, place left hand

buckle prong (b) on top of (a).

2. Hold both left hand buckle prongs (a) and (b)

together and insert it into buckle housing (e) until

it snaps into position.

3. Repeat previous steps for right hand buckle

prongs (c) and (d).

4. Once all attached, carefully adjust the harness

straps by pulling each slider (f) until the desired

ﬁt is achieved in the lap, shoulder and crotch

straps.

5. To release the buckles, squeeze the top and

bottom prongs (a) and (b), (c) and (d) together

until harness disengages.

CAUTION: Always adjust the harness when changing

the seating position of the child.

Adjuster

Slide up or down

To adjust harness straps

To adjust straps, hold the strap with one hand and

slide the adjuster up or down the strap. Sliding the

adjuster down will loosen the strap, while sliding the

adjuster up will tighten the strap.

(a), (b): Left hand buckle prongs

(c), (d): Right hand buckle prongs

(e): Buckle housing

(f): Strap adjustment sliders

Assembly Instructions

Tether strap

Ensure tether strap is used at all times. Make sure your hand is fed

through the loop as shown in the diagram.

Folding the stroller

1. Before folding the stroller, remove bootcover, close the hood,

place seat in full layback position and transfer handle to forward

facing mode.

2. Simultaneously squeeze both handle levers located in the middle

of the stroller handle and lift the red lever located on the left side

of the stroller handle.

3. Push down on handle to commence folding the unit. Once fold is

complete, push down on the handle to engage the folding locks.

Assembly Instructions

Attaching bumper bar

1. Align the bumper bar ends with the locking buttons on the sides

of armrest moulds of the stroller frame and push inwards until they

“click” and lock into position on each side.

2. To remove bumper bar; push both locking buttons in and pull

bumper bar out.

Assembly Instructions

Cleaning

To ensure the long-lasting use of your stroller, dry it with a soft absorbent cloth after use in rainy

weather. Use a damp cloth to clean the frame. Do not use abrasive cleaners. After using your

stroller on the beach, clean the frame and wheels thoroughly with water to remove the sand and

salt. Allow it to dry thoroughly. Removable and non-removable fabric covers and trims may be

cleaned using a damp cloth with soap or mild detergent. Allow it dry completely before folding

or storing it away. Do not dry clean, or use bleach on fabrics or trims. Do not machine wash,

tumble or spin dry, unless the care labelling on the product permits these methods.

Maintenance

Check stroller regularly to ensure that locking devices and components are secure and working

properly. Always check parts regularly for tightness of screws, nuts and other fasteners – tighten

or replace if required. To maintain the safety of your stroller, seek prompt repairs for bent, torn,

worn or broken parts. Use only those parts and accessories approved by CNP Brands. If the

wheels squeak, use silicone based spray or light oil ensuring it penetrates the wheel and axle

assembly. To prevent mould or mildew, do not fold or store the product if it is damp or wet. Allow

it to dry thoroughly. Always store the product in a well ventilated area and away from direct

sunlight.

If you have any difﬁculties in assembling the stroller, please contact our Service Department.

In Australia, contact CNP Brands on 1300 667 137, in New Zealand contact Wainhouse

Distribution on 0800 567 5000.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Bebe Care Kinderwagen Handbücher

Bebe Care

Bebe Care Petit Bedienungsanleitung

Beliebte Kinderwagen Handbücher anderer Marken

Hauck

Hauck Priya Trioset Bedienungsanleitung

CHILDHOME

CHILDHOME CWQDN Bedienungsanleitung

Dreamer Design

Dreamer Design Rebound GST Bedienungsanleitung

Britax

Britax STEELCRAFT AGILE Bedienungsanleitung

Graco

Graco 7427 Bedienungsanleitung

OBaby

OBaby Aura Bedienungsanleitung

Tutek

Tutek Tirso Bedienungsanleitung

Babify

Babify Dual Plus Bedienungsanleitung

Graco

Graco Stroller Bedienungsanleitung

Special Tomato

Special Tomato Jogger Bedienungsanleitung

Chicco

Chicco CORTINA TOGETHER TWO-PASSENGER STROLLER Bedienungsanleitung

Otto Bock

Otto Bock Kimba neo Bedienungsanleitung

Milly Mally

Milly Mally ROYAL Kurzanleitung

Hauck

Hauck DUETT 3 PRAM Bedienungsanleitung

BOB

BOB DUALLIE Bedienungsanleitung

Nuna

Nuna Pepp Bedienungsanleitung

Britax

Britax B2 Bedienungsanleitung

Graco

Graco VERB Bedienungsanleitung