Behringer BASS SYNTHESIZER BSY600 Bedienungsanleitung

BASS SYNTHESIZER BSY600

Ultimate Bass Synthesizer Eects Pedal

Thank you for showing your condence in us by purchasing the BEHRINGER BASS SYNTHESIZER BSY600.

This high-quality eects pedal reproduces the fat and powerful sound of classic analog synthesizers—

at the touch of a footswitch.

1. Controls

(1) The DIRECT control adjusts the level of the

direct, unaected signal.

(2) The EFFECT control adjusts the level of the

synthesizer eect signal.

(3) The RES(onance) control adjusts the

strength of the low-pass lter frequency

peak (see below).

(4) The FREQ(uency) control adjusts the

low-pass/allpass lter frequency which

cuts the high-frequencies and therefore

determines the upper and lower limit of the

frequency range the lter moves along.

(5) The DECAY/RATE control has 2 dierent

functions. Depending on the MODE switch

position (see below) it adjusts either the

LFO speed that modulates the amplitude

of the lter frequency (RATE: mode 3 and

6 only) or sets the time over which the lter

frequency moves (DECAY). When the decay time is set to MAX, the cut-o lter frequency is xed.

(6) Use the MODE switch to dial up one of 11 synthesizer modes with 4 dierent waveforms.

1. SAW (sawtooth wave that produces sharp-edged sound)

2. SAW (sawtooth wave one octave lower than mode 1)

3. SAW (sawtooth wave with automatic lter frequency shifting)

4. SQUARE (square wave that produces milder sound than the sawtooth modes)

5. SQUARE (similar to mode 4 with additional square wave one octave below)

6. SQUARE (square wave with automatic lter frequency shifting)

7. PULSE (pulse wave that produces sharp-edged sound dierent from sawtooth modes)

8. PULSE (pulse wave with all-pass lter for more depth and motion)

9. PULSE (pulse wave with pulse width modulation for fat, spre ading sound)

10. WAVE (input signal is directly transformed to a synthesizer sound. Filter rises when string is

played and returns gradually)

11. WAVE (similar to mode 10, but lter drops when string is played and returns gradually)

(7) The ON/BATT LED illuminates when the eect is activated and ashes when the PITCH HOLD

function is active (see below). It also serves as a battery level indicator.

(8) Use the footswitch to activate/deactivate the eect. Keeping the footswitch depressed will

activate the PITCH HOLD function (modes 1 - 9 only) that causes the unit to output the eect

signal continuously, even if the bass is not played at this moment (ON/BATT LED ashes). You can

also play the bass while keeping the footswitch pressed and mix the continuously output eect

signal with the direct bass signal. Release the footswitch to deactivate this function.

(9) Use this ¼" TS IN connector to plug in the instrument cable.

(10) The two ¼" TS OUT and DIR OUT connectors send the signal to your amp. Use both connectors if

you want to separate the unprocessed input signal (> DIR OUT) and the synthesized signal (> OUT).

To mix both signals together use OUT only.

(1)

(2)

(7)

(9)

(11)

(6)

(8)

(5)

(4)

(3)

(10)

BASS SYNTHESIZER BSY600

TECHNICAL SPECIFICATIONS AND APPEARANCES ARE SUBJECT TO CHANGEWITHOUT NOTICE AND ACCURACY IS NOT GUARANTEED. BEHRINGER IS PART OF THE

MUSIC GROUP (MUSIC-GROUP.COM). ALLTRADEMARKS ARE THE PROPERTY OF THEIR RESPECTIVE OWNERS. MUSICGROUP ACCEPTS NO LIABILITY FOR ANY LOSS

WHICH MAY BE SUFFERED BY ANY PERSON WHO RELIES EITHER WHOLLY OR IN PART UPON ANY DESCRIPTION, PHOTOGRAPH OR STATEMENT CONTAINED HEREIN.

COLORS AND SPECIFICATIONS MAY VARY FROM ACTUAL PRODUCT. MUSIC GROUP PRODUCTS ARE SOLD THROUGH AUTHORIZED FULLFILLERS AND RESELLERS

ONLY. FULLFILLERSAND RESELLERS ARE NOT AGENTS OF MUSICGROUP AND HAVE ABSOLUTELY NO AUTHORITY TO BIND MUSICGROUP BY ANY EXPRESS OR

IMPLIED UNDERTAKING OR REPRESENTATION. THIS MANUAL IS COPYRIGHTED. NO PART OF THIS MANUAL MAY BE REPRODUCED OR TRANSMITTED IN ANY FORM

OR BY ANY MEANS, ELECTRONIC OR MECHANICAL, INCLUDING PHOTOCOPYING AND RECORDING OF ANY KIND, FOR ANY PURPOSE,WITHOUT THE EXPRESS

Tortola, British Virgin Islands

(11) Use the ¼" TRS EXP(ression) connector to connect an expression pedal. This way you can externally

control the movement of the lter frequency (DECAY) or—for mode 3 and 6—the speed of the

eect (RATE). When using an expression pedal the DECAY/RATE control determines the max. value

(expression pedal fully pressed).

Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).

The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery,

press the hinges with a ballpen and remove the pedal cover. Be careful not to scratch the unit.

◊ The BSY600 has no on/o switch. As soon as you insert the plug into the in connector,

the BSY600 begins running. When not using the BSY600, remove the plug from the

in connector. This extends the life of the battery.

The SERIAL NUMBER is located at the underside.

◊ In rare cases interferences of the normal function may appear by external inuence

(e.g. electrostatic discharge), as for example sound disturbances or malfunctions. If this

occurs, please turn down the volume on subsequent ampliers and disconnect the input

connector briey to restart the application.

2. Safety Instructions

Do not use near water, or install near heat sources. Use only authorized attachments/accessories.

Do not service product yourself. Contact our qualied servicing personnel for servicing or repairs,

especially when power supply cord or plug is damaged.

3. Warranty

Please register your new BEHRINGER equipment right after your purchase by visiting http://behringer.com

and read the terms and conditions of our warranty carefully.

4. Specications

Connector ¼" TS

Impedance 500 kΩ

Out

Connector ¼" TS

Impedance 1 kΩ

DIR OUT

Connector ¼" TS

Impedance 1 kΩ

Power Supply

9 V𝌂, 100 mA regulated

BEHRINGER PSU-SB

USA/Canada 120 V~, 60 Hz

Europe/U.K./ 230 V~, 50 Hz

Australia

China 220 V~, 50 Hz

Korea 220 V~, 60 Hz

Japan 100 V~, 50/60 Hz

Power connector 2 mm DC jack,

negative center

Battery 9 V type 6LR61

Power consumption 30 mA

Physical/Weight

Dimensions approx. 2 ⁄ x 2 ¾ x 4 ⁄"

(H x W x D) approx. 54 x 70 x 123 mm

Weight approx. 0.73 lbs / 0.33 kg

BEHRINGER is constantly striving to maintain the

highest professional standards. As a result of these efforts,

modifications may be made from time to time to existing

products without prior notice. Specifications and appearance

may therefore differ from those listed or shown.

Inhaltsverzeichnis

Andere Behringer Musikpedal Handbücher

Behringer

Behringer MIDI FOOT CONTROLLER FCB1010 Bedienungsanleitung

Behringer

Behringer V-TONE ACOUSTIC ADI21 Bedienungsanleitung

Behringer

Behringer CHORUS SPACE-D CD400 Bedienungsanleitung

Behringer

Behringer Digital Multi-FX FX600 Bedienungsanleitung

Behringer

Behringer Ultra Distortion UD300 Bedienungsanleitung

Behringer

Behringer Super Octaver SO400 Bedienungsanleitung

Behringer

Behringer ULTRA FLANGER UF100 Bedienungsanleitung

Behringer

Behringer Compressor Sustainer CS100 Bedienungsanleitung

Behringer

Behringer ULTRA VIBRATO UV300 Bedienungsanleitung

Behringer

Behringer ULTRA METAL UM300 Bedienungsanleitung

Behringer

Behringer CC300 Bedienungsanleitung

Behringer

Behringer SUPER PHASE SHIFTER SP400 Bedienungsanleitung

Behringer

Behringer ULTRA OCTAVER UO100 Bedienungsanleitung

Behringer

Behringer DR100 Bedienungsanleitung

Behringer

Behringer MIDI FOOT CONTROLLER FCB1010 Bedienungsanleitung

Behringer

Behringer NOISE REDUCER NR100 Bedienungsanleitung

Behringer

Behringer Power Overdrive PO300 Bedienungsanleitung

Behringer

Behringer PB600 Bedienungsanleitung

Behringer

Behringer HEAVY DISTORTION HD300 Bedienungsanleitung

Behringer

Behringer DISTORTION MODELER DM100 Bedienungsanleitung

Behringer

Behringer HI BAND FLANGER HF300 Bedienungsanleitung

Behringer

Behringer VINTAGE BASS VB1 Bedienungsanleitung

Behringer

Behringer SUPER FUZZ SF300 Bedienungsanleitung

Behringer

Behringer V-TONE GUITAR DRIVER DI GDI21 Bedienungsanleitung

Beliebte Musikpedal Handbücher anderer Marken

Whirlwind

Whirlwind oc-bass Bedienungsanleitung

Strymon

Strymon Lex-rotary Bedienungsanleitung

Lexicon

Lexicon MX200 Bedienungsanleitung

Dunlop

Dunlop Hendrix 68 Shrine Octavio Fuzz Series Bedienungsanleitung

Matthews Effects

Matthews Effects Whaler V2 Bedienungsanleitung

Grid 1

Grid 1 Pedal Jeanie Bedienungsanleitung

Amptweaker

Amptweaker tightboost Bedienungsanleitung

Ibanez

Ibanez TS-808 Tube Screamer Overdrive Pro Bedienungsanleitung

Dimavery

Dimavery EPVP-50 Bedienungsanleitung

Tefi Vintage Lab

Tefi Vintage Lab GEGÈ Bedienungsanleitung

Pro-MIDI

Pro-MIDI G25 Bedienungsanleitung

DW 7000 Bedienungsanleitung

FAMC

FAMC Liquid-Foot Jr. Series Bedienungsanleitung

Dimavery

Dimavery EPOD-50 Overdrive Bedienungsanleitung

TREX

TREX ToneBug Totenschläger Bedienungsanleitung

BBE

BBE ORANGE SQUASH Bedienungsanleitung

Tube Works

Tube Works 310 Bedienungsanleitung

EarthQuaker Devices

EarthQuaker Devices Tentacle Bedienungsanleitung