Behringer 2500 Series Bedienungsanleitung

Quick Start Guide

DUAL ENVELOPE

GENERATOR MODULE 1003

Legendary 2500 Series Dual Envelope

Generator Module for Eurorack

Controls

(1) (2)

(3)

(4)

(5)

(6)

(7)

(8) (9) (10) (11)

(1) ATTACK TIME – Adjusts the rate at which the envelope

reaches its peak voltage.

(2) SIGNAL LED – Indicates when a gate signal is present.

(3) INITIAL DECAY TIME – Adjusts the rate at which the

envelope decays from its peak to its designated

sustain level.

(4) SUSTAIN LEVEL – Controls the level at which the

envelope remains after its peak but before release,

sustaining as long as the input signal is present or the

manual gate button is held down.

(5) FINAL DECAY TIME – Controls how quickly the envelope

falls after the input signal stops or the manual gate button

is released.

(6) TRIGGER MODE – Selects between single mode,

where only the gate signal controls the envelope,

or multiple mode, which uses a positive trigger pulse to

re-trigger the envelope while a gate signal is present.

(7) MANUAL GATE – Press and hold to start the

envelope cycle.

(8) GATE– Connect a gate signal to control the envelope cycle.

(9) TRIG – Triggers a new attack of the envelope if a gate

signal is also present.

(10) OUT L – Send the left envelope positive and negative

control voltage to other modules via 3.5 mm TS cable.

(11) OUT R – Send the right envelope positive and negative

control voltages to other modules via 3.5 mm TS cable.

Power Connection

The unit comes with the required power cable for connecting

to a standard Eurorack power supply system. Follow these

steps to connect power to the module. It is easier to make these

connections before the module has been mounted into a

rack case.

1. Turn the power supply or rack case power o and

disconnect the power cable.

2. Insert the 16-pin connector on the power cable into the

socket on the power supply or rack case. The connector has

a tab that will align with the gap in the socket, so it cannot

be inserted incorrectly. If the power supply does not have

a keyed socket, be sure to orient pin 1 (-12 V) with the red

stripe on the cable.

3. Insert the 10-pin connector into the socket on the back of

the module. The connector has a tab that will align with the

socket for correct orientation.

4. After both ends of the power cable have been securely

attached, you may mount the module in a case and turn on

the power supply.

V 1.0

Installation

The necessary screws are included with the module for mounting

in a Eurorack case. Connect the power cable before mounting.

Depending on the rack case, there may be a series of xed holes

spaced 2 HP apart along the length of the case, or a track that

allows individual threaded plates to slide along the length

of the case. The free-moving threaded plates allow precise

positioning of the module, but each plate should be positioned in

the approximate relation to the mounting holes in your module

before attaching the screws.

Hold the module against the Eurorack rails so that each of the

mounting holes are aligned with a threaded rail or threaded

plate. Attach the screws part way to start, which will allow

small adjustments to the positioning while you get them all

aligned. After the nal position has been established, tighten the

screws down.

Specications

Inputs

Gate

Type 3.5 mm TS jack, DC coupled

Impedance >35 kΩ

Gate threshold +4 V

Max input level +12 V

Trig

Type 3.5 mm TS jack, DC coupled

Impedance >20 kΩ

Trigger threshold +4 V

Max input level +12 V

Outputs

Out A

Type 2 x 3.5 mm TS jacks, DC coupled

Impedance 1 kΩ

Max output level -10 V or +10 V

Out B

Type 2 x 3.5 mm TS jacks, DC coupled

Impedance 1 kΩ

Max output level -10 V or +10 V

Controls

Attack 1 ms to 2 s

Initial decay 5 ms to 7 s

Sustain 0 to 10 V

Final decay 6 ms to 8 s

Trigger modes Single - gate controls envelope

Multiple - trigger pulse +

gate controls envelope

Manual gate Envelope cycle start

Power

Power supply Eurorack

Current draw 40 mA (+12 V), 20 mA (-12 V)

Physical

Dimensions 42 x 81 x 129 mm

(1.7 x 3.2 x 5.1")

Rack units 16 HP

Weight 0.16 kg (0.35 lbs)

LEGAL DISCLAIMER

Music Tribe accepts no liability for any loss which may be suered by any

person who relies either wholly or in part upon any description, photograph,

or statement contained herein. Technical specications, appearances and

other information are subject to change without notice. All trademarks are the

property of their respective owners. Midas, KlarkTeknik, Lab Gruppen, Lake,

Tannoy,Turbosound,TC Electronic, TC Helicon, Behringer, Bugera, Auratone

and Coolaudio are trademarks or registered trademarks of MusicTribe

LIMITED WARRANTY

For the applicable warranty terms and conditions and additional information

regarding MusicTribe’s Limited Warranty, please see complete details online

at musictribe.com/warranty.

Andere Handbücher für 2500 Series

Dieses Handbuch passt für folgende Modelle

Andere Behringer Aufnahmegeräte Handbücher

Behringer

Behringer EURODESK MX3282A Bedienungsanleitung

Behringer

Behringer GUITAR LINK UCG102 Bedienungsanleitung

Behringer

Behringer PRO-1 Bedienungsanleitung

Behringer

Behringer MIDI FOOT CONTROLLER FCB1010 Bedienungsanleitung

Behringer

Behringer GUITAR LINK UCG102 Bedienungsanleitung

Behringer

Behringer FADERB CF2000B Bedienungsanleitung

Behringer

Behringer POWERPLAY 16 P16-D Bedienungsanleitung

Behringer

Behringer B-Control Fader BCF2000-WH Bedienungsanleitung

Behringer

Behringer MODULIZER PRO DSP1224P Bedienungsanleitung

Behringer

Behringer F-Control Audio FCA202 Bedienungsanleitung

Behringer

Behringer X-UF Bedienungsanleitung

Behringer

Behringer U-PHORIA UMC1820 Bedienungsanleitung

Behringer

Behringer Virtualizer Pro DSP2024P Bedienungsanleitung

Behringer

Behringer ULTRA-DI DI600P Bedienungsanleitung

Behringer

Behringer MAGICIAN T1950 Bedienungsanleitung

Behringer

Behringer POWERPLAY 16 P16-I Bedienungs- und Sicherheitshinweise

Behringer

Behringer 305 EQ/MIXER/OUTPUT Bedienungsanleitung

Behringer

Behringer ULTRA-DI DI100 Bedienungsanleitung

Behringer

Behringer Tweakalizer DFX69 Bedienungsanleitung

Behringer

Behringer Ultrabass BX3000T Bedienungsanleitung

Behringer

Behringer BRAINS Bedienungsanleitung

Behringer

Behringer X V-AMP LX1-X Bedienungsanleitung

Behringer

Behringer ULTRAPATCH PX1000 Bedienungsanleitung

Behringer

Behringer DI800 Bedienungsanleitung

Beliebte Aufnahmegeräte Handbücher anderer Marken

KV2 Audio

KV2 Audio 500 Series Bedienungsanleitung

Robotics Technologies

Robotics Technologies microBus-Cam II Bedienungsanleitung

Seca

Seca 460 Bedienungsanleitung

Cognex

Cognex MVS-8000 Series Bedienungsanleitung

Mect

Mect MPNC006 Series Bedienungsanleitung

Bad Caf

Bad Caf THE LEASH Bedienungsanleitung

Strymon

Strymon NIGHTSKY Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric 16CH DIGITAL RECORDER DX-TL5000U Bedienungsanleitung

Tews Technologies

Tews Technologies TPMC465 Bedienungsanleitung

Honeywell

Honeywell Excel 50 Bedienungsanleitung

SeaLevel

SeaLevel COMM+8.LPCI Bedienungsanleitung

Arturia

Arturia AUDIOFUSE STUDIO Bedienungsanleitung

Rukra

Rukra RK-1240 Bedienungsanleitung

Samson

Samson SCOM Bedienungsanleitung

Dynacord

Dynacord DPS260 Bedienungsanleitung

Nice

Nice Core Bedienungsanleitung

Pyle Pro

Pyle Pro PSS8 Bedienungsanleitung

RF-System

RF-System TinyGate Gebrauchs- und Pflegehandbuch