Bennett 515-XP Pump Controller Instruction & Service Manual Safety Information
1
SECTION 1: SAFETY INFORMATION
For safe installation of this equipment, read and understand all dangers, warnings, and cautionary information. Save this safety
information in a readily accessible location. Look for the following warnings throughout the manual:
Red and White “DANGER” means: If you do not follow the instructions, severe injury or death will occur.
Orange and Black “WARNING” means: If you do not follow the instructions, severe injury or death can occur.
Yellow and Black “CAUTION” means: If you do not follow the instructions, damage can occur to the dispenser.
Blue and White “IMPORTANT” means: Helpful tips and other recommendations on equipment installation, usage, and
maintenance should be observed.
DANGER PELIGRO DANGER
FIRE, EXPLOSION, INJURY, OR DEATH WILL OCCUR IF FUEL
FILTERS ARE CHANGED BY UNTRAINED PERSONNEL. MAKE SURE,
ONLY TRAINED PERSONNEL CHANGE FILTERS.
TO PREVENT INJURY TO YOU FROM VEHICLES AND ONLOOKERS,
ALWAYS PLACE A BARRIER AROUND THIS EQUIPMENT BEFORE
PERFORMING SERVICE OR MAINTENANCE.
GASOLINE AND FUEL ETHANOL IS FLAMMABLE. NO SMOKING
OR OPEN FLAME.
FUEL ETHANOL IS POISONOUS AND SHOULD NOT BE INGESTED.
DISCONNECT ALL POWER, RELIEVE PRESSURE TO THIS
EQUIPMENT, AND ASSOCIATED COMPRESSOR DURING
INSTALLATION, SERVICE, OR ANY MAINTENANCE I.E.,
CHANGING FILTERS.
THE 515 IS NOT DESIGNED TO BE MOUNTED ON THE FUEL
ISLAND. MOUNT IN EQUIPMENT ROOM NEAR POWER PANELS.
WARNING ADVERTENCIA MISE EN
GARDE
You must have training in the installation, service, or maintenance
of this equipment (dispenser, pump, console, control box, or
submerged pump) before working on it. Maintenance repairs
must be done by authorized personnel only. Warranty work may
only be performed by Bennett certified technicians.
To prevent electric shock, keep the electrical parts of the
dispenser dry.
Electronic components are static sensitive. Use only proper static
precautions (e.g. static straps) before working on the equipment.
The emergency shut-off valve (also called the fire valve, shear
valve, or impact valve) must be closed when service or
maintenance is performed on this equipment.
You must have training in the operation and programming of this
dispenser before using it. READ THE OPERATORS MANUAL.
Make sure this equipment is correctly grounded. Failure to do will
cause injury or damage equipment or improper operation.
Improper grounding voids the warranty.
When anchoring the dispenser, always level the dispenser with
shims before bolting to the island. DO NOT shim the middle of
base rails to bolt down the dispenser.
Make sure that all labels, decals, warning, cautions, and
instructions are fastened to the equipment. Order replacement
labels from Bennett.
CAUTION PRECAUCIÓN MISE EN GARDE
Do not drill holes in fuel dispensers. Holes can cause failure of the
electronic equipment. THE WARRANTY WILL BECOME VOID. Use
only adhesive backed sign mounting brackets.
IMPORTANT IMPORTANTE IMPORTANT
All trained technicians must work in accordance to all
requirements, standards, and guidelines specified by the suppliers
Environmental Standards® Health, Safety, Security & Environment
(HSSE) policies. Note: Bennett Pump highly recommends all
technicians observe HSSE policies defined by the supplier. Bennett
Pump does not impose any restrictions or additional
requirements contained in Environmental Standards® Health,
Safety, Security & Environment (HSSE) policies.
!! READ AND UNDERSTAND ALL WARNING LABELS ATTACHED TO THE DISPENSER !!
