BenQ EU610ST Bedienungsanleitung

Digital Projector

User Manual

EU610ST V 1.00

2 Warranty and Copyright information

Warranty and Copyright information

Limited warranty

BenQ warrants this product against any defects in material and workmanship, under normal

usage and storage.

Proof of purchase date will be required with any warranty claim. In the event this product is

found to be defective within the warranty period, BenQ's only obligation and your exclusive

remedy shall be replacement of any defective parts (labor included). To obtain warranty

service, immediately notify the dealer from which you purchased the product of any defects.

Important: The above warranty shall be void if the customer fails to operate the product in

accordance with BenQ's written instructions, especially the ambient humidity must be

in-between 10% and 90%, temperature in-between 0°C and 35°C, altitude lower than 4920 feet,

and avoiding to operate the projector in a dusty environment. This warranty gives you specific

legal rights, and you may have other rights which vary from country to country.

For other information, please visit www.BenQ.com.

reproduced, transmitted, transcribed, stored in a retrieval system or translated into any

language or computer language, in any form or by any means, electronic, mechanical,

magnetic, optical, chemical, manual or otherwise, without the prior written permission of BenQ

Corporation.

Disclaimer

BenQ Corporation makes no representations or warranties, either expressed or implied, with

respect to the contents hereof and specifically disclaims any warranties, merchantability or

fitness for any particular purpose. Further, BenQ Corporation reserves the right to revise this

publication and to make changes from time to time in the contents hereof without obligation to

notify any person of such revision or changes.

*DLP, Digital Micromirror Device and DMD are trademarks of Texas Instruments. Others are

copyrights of their respective companies or organizations.

Patents

Please go to http://patmarking.benq.com/ for the details on BenQ projector patent coverage.

3Table of Contents

Table of Contents

Warranty and Copyright information ...............................................................................2

Important safety instructions .........................................................................................4

Introduction ....................................................................................................................7

Shipping contents ............................................................................................................. 7

Projector exterior view...................................................................................................... 9

Controls and functions ................................................................................................... 10

Positioning your projector ............................................................................................13

Choosing a location ........................................................................................................13

Obtaining a preferred projected image size.................................................................. 14

Mounting the projector ................................................................................................... 15

Adjusting the projected image .......................................................................................16

Connection ...................................................................................................................18

Starting up the projector ...............................................................................................20

Operation (under Launcher source) ..............................................................................24

Before you get started ....................................................................................................24

The AMS Service............................................................................................................. 25

Checking for system update .......................................................................................... 32

BenQ Launcher ................................................................................................................33

Operation (under non-Launcher source) .......................................................................71

Using the projector menus under non-Launcher source ..............................................71

Securing the projector ....................................................................................................72

Switching input signal ..................................................................................................... 74

Menu operation............................................................................................................... 75

Shutting down the projector .........................................................................................90

Direct power off .............................................................................................................. 90

Maintenance ................................................................................................................91

Care of the projector .......................................................................................................91

Light information ............................................................................................................. 91

Troubleshooting ...........................................................................................................95

Specifications ..............................................................................................................96

Projector specifications .................................................................................................96

Dimensions ......................................................................................................................97

Timing chart .................................................................................................................... 98

4 Important safety instructions

Important safety instructions

Your projector is designed and tested to meet the latest standards for safety of information

technology equipment. However, to ensure safe use of this product, it is important that you

follow the instructions mentioned in this manual and marked on the product.

1. Please read this manual before you

operate your projector. Save it for future

reference.

2. Do not look straight at the projector lens

during operation. The intense light beam

may damage your eyes.

3. Refer servicing to qualified service

personnel.

4. Always open the lens shutter (if any) or

remove the lens cap (if any) when the

projector lamp is on.

5. The lamp becomes extremely hot during

operation. Allow the projector to cool for

approximately 45 minutes prior to

removing the lamp assembly for

replacement.

6. In some countries, the line voltage is NOT

stable. This projector is designed to

operate safely within a mains voltage

between 100 to 240 volts AC, but could

fail if power cuts or surges of ±10 volts

occur. In areas where the mains voltage

may fluctuate or cut out, it is

recommended that you connect your

projector through a power stabilizer,

surge protector or uninterruptible power

supply (UPS).

7. Do not block the projection lens with any

objects when the projector is under

operation as this could cause the objects

to become heated and deformed or even

cause a fire. To temporarily turn off the

lamp, use the blank function.

8. Do not operate lamps beyond the rated

lamp life. Excessive operation of lamps

beyond the rated life could cause them to

break on rare occasions.

5Important safety instructions

9. Never replace the lamp assembly or any

electronic components unless the

projector is unplugged.

10. Do not place this product on an unstable

cart, stand, or table. The product may fall,

sustaining serious damage.

11. Do not attempt to disassemble this

projector. There are dangerous high

voltages inside which may cause death if

you should come into contact with live

parts. The only user serviceable part is the

lamp which has its own removable cover.

Under no circumstances should you ever

undo or remove any other covers. Refer

servicing only to suitably qualified

professional service personnel.

12. Do not block the ventilation holes.

- Do not place this projector on a blanket, bedding

or any other soft surface.

- Do not cover this projector with a cloth or any

other item.

- Do not place inflammables near the projector.

If the ventilation holes are seriously

obstructed, overheating inside the

projector may result in a fire.

13. Always place the projector on a level,

horizontal surface during operation.

- Do not use if tilted at an angle of more than 10

degrees left to right, nor at angle of more than 15

degrees front to back. Using the projector when it

is not fully horizontal may cause a malfunction

of, or damage to, the lamp.

14. Do not stand the projector on end

vertically. Doing so may cause the

projector to fall over, causing injury or

resulting in damage to the projector.

15. Do not step on the projector or place any

objects upon it. Besides probable physical

damage to the projector, doing so may

result in accidents and possible injury.

16. When the projector is under operation,

you may sense some heated air and odor

from its ventilation grill. It is a normal

phenomenon and not a product defect.

6 Important safety instructions

Risk Group 2

1. According to the classification of photobiological safety of light sources and light source

systems, this product is Risk Group 2, IEC 62471-5:2015.

2. Possibly hazardous optical radiation emitted from this product.

3. Do not stare at operating light source. May be harmful to the eyes.

4. As with any bright source, do not stare into the direct beam.

17. Do not place liquids near or on the

projector. Liquids spilled into the projector

may cause it to fail. If the projector does

become wet, disconnect it from the power

supply's power outlet and call BenQ to

have the projector serviced.

18. This product is capable of displaying

inverted images for ceiling/wall mount

installation.

19. This apparatus must be earthed.

20. Do not place this projector in any of the

following environments.

- Space that is poorly ventilated or confined. Allow

at least 50 cm clearance from walls and free flow

of air around the projector.

- Locations where temperatures may become

excessively high, such as the inside of a car with

all windows rolled up.

- Locations where excessive humidity, dust, or

cigarette smoke may contaminate optical

components, shorten the projector's life span and

darken the image.

- Locations near fire alarms

- Locations with an ambient temperature above

40°C / 104°F

- Locations where the altitudes are higher than

3000 m (10000 feet).

Hg - Lamp contains mercury. Manage in accordance with local disposal laws. See www.lamprecycle.org.

To avoid damaging the DLP chips, never aim a high-power laser beam into the projection lens.

3000 m

(10000 feet)

0 m

(0 feet)

7Introduction

Introduction

Shipping contents

Carefully unpack and verify that you have all of the items shown below. If any of these items are

missing, please contact your place of purchase.

Standard accessories

Optional accessories

Replacing the remote control batteries

1. Press and open the battery cover, as illustrated.

2. Remove the old batteries (if applicable) and install

two AAA batteries. Make sure that the positive and

negative ends are positioned correctly, as illustrated.

3. Replace the battery cover until it clicks into place.

Projector Remote control with

batteries Quick start guide

Warranty card* Power cord Wireless dongle

(EZC-5201BS)

• The supplied accessories will be suitable for your region, and may differ from those illustrated.

• *The warranty card is only supplied in some specific regions. Please consult your dealer for detailed

information.

1. Spare lamp kit

2. 3D glasses

• Avoid leaving the remote control and batteries in an excessive heat or humid environment like the

kitchen, bathroom, sauna, sunroom or in a closed car.

• Replace only with the same or equivalent type recommended by the battery manufacturer.

• Dispose of the used batteries according to the manufacturer's instructions and local environment

regulations for your region.

• Never throw the batteries into a fire. There may be danger of an explosion.

• If the batteries are dead or if you will not be using the remote control for an extended period of time,

remove the batteries to avoid damage to the remote control from possible battery leakage.

8 Introduction

Installing the wireless dongle

See the illustrations below to install the dongle. Make sure that the dongle cover is installed

back correctly after the dongle is plugged. Do not turn the power on with the dongle cover open.

The projector only supports Wi-Fi and/or Bluetooth connections when the wireless dongle (EZC-5201BS)

is installed.

1 2 3

4 5 6

9Introduction

Projector exterior view

1. Focus ring and zoom ring

2. Vent (air exhaust)

3. Adjuster feet

4. Projection lens

5. IR remote sensor

6. External control panel

(See Controls and functions on page 10.)

7. Lamp cover

8. Vent (air inlet)

9. Audio input jacks

Audio output jack

10. USB Type A port (service only)

11. HDMI input port

12. RGB (PC) signal input jack

13. RS-232 control port

14. USB Type A ports

15. AC power jack

16. USB Type A port (for wireless dongle)

17. Wall mount holes

18. Security bar

3 3

10 11 12 13 14

15 16

10 Introduction

Controls and functions

Projector & Remote control

No. When the input source is

BenQ Launcher

When the input source is

NOT BenQ Launcher

1. POWER Toggles the projector between standby mode and on.

ON/ Off

2. POWER indicator

light/TEMPerature warning

light/LAMP indicator light

(See Indicators on page 94.)

3. IR remote sensor

4. (BACK)Returns to the previous

menu, main settings menu

or exit the app.

Goes back to previous OSD

menu or exits menu

settings.

• All the key presses described in this

document are available on the remote

control or projector.

• The remote control is without laser pointer

in Japan.

Inhaltsverzeichnis

Andere BenQ Projektor Handbücher

BenQ

BenQ 9H.J2S77.F3A - DLP Projector SVGA 2700 Bedienungsanleitung

BenQ

BenQ MS612ST Bedienungsanleitung

BenQ

BenQ MH856UST Bedienungsanleitung

BenQ

BenQ MX713 ST Bedienungsanleitung

BenQ

BenQ SP891 Bedienungsanleitung

BenQ

BenQ PB8220 - XGA DLP Projector Bedienungsanleitung

BenQ

BenQ PE7700 - DLP Projector - HD 720p Bedienungsanleitung

BenQ

BenQ S11 Bedienungsanleitung

BenQ

BenQ TH670 Bedienungsanleitung

BenQ

BenQ MP523 - XGA DLP Projector Bedienungsanleitung

BenQ

BenQ MX520 Bedienungsanleitung

BenQ

BenQ W10000/W9000 Bedienungsanleitung

BenQ

BenQ W700 Bedienungsanleitung

BenQ

BenQ Home Entertainment PE5120 Bedienungsanleitung

BenQ

BenQ MS521 Bedienungsanleitung

BenQ

BenQ SX912 Bedienungsanleitung

BenQ

BenQ MP780 ST+ Bedienungsanleitung

BenQ

BenQ EX600 Bedienungsanleitung

BenQ

BenQ MX722 Bedienungsanleitung

BenQ

BenQ DX550 Bedienungsanleitung

BenQ

BenQ HT5550 Bedienungsanleitung

BenQ

BenQ LK990 Bedienungsanleitung

BenQ

BenQ PB6240 - XGA DLP Projector Bedienungsanleitung

BenQ

BenQ CinePrime Series Bedienungsanleitung

Beliebte Projektor Handbücher anderer Marken

iEmmet

iEmmet MP-312 Bedienungsanleitung

Epson

Epson VS400 Bedienungsanleitung

Sony

Sony VPL-HS10 Marketing Specifications & Features Bedienungsanleitung

Sony

Sony VPL-HW65ES Service-Handbuch

Toshiba

Toshiba TLP-791U Bedienungsanleitung

Philips

Philips LC1341 Referenzhandbuch

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Bedienungsanleitung

NEC

NEC NP600S EDU Bedienungsanleitung

Eiki

Eiki EK-623U series Bedienungsanleitung

Epson

Epson PowerLite Pro Cinema 6020UB Bedienungsanleitung

Epson

Epson PowerLite Home Cinema 705HD Bedienungsanleitung

Christie

Christie LHD700 Bedienungsanleitung

Navitar

Navitar FX Bedienungsanleitung

InFocus

InFocus LitePro 560 Bedienungsanleitung

Sony

Sony SRX-R815P Bedienungsanleitung

Vivitar

Vivitar DP1500 X Bedienungsanleitung

Acer

Acer C20 Series Bedienungsanleitung

Asus

Asus ZenBeam Latte Bedienungsanleitung