BenQ LU9235 Bedienungsanleitung

LU9235 / LX9215

Digital Projector

Installation Guide

English

Table of Contents

Notice..................................................................................................... 3

Laser notice .................................................................................................................... 3

Cooling notice ................................................................................................................ 4

When edge blending...................................................................................................... 4

Product information ............................................................................. 5

Packing content.............................................................................................................. 5

Specication ................................................................................................................... 5

Terminals ........................................................................................................................ 6

Installation ............................................................................................. 7

Lens ................................................................................................................................. 7

Projection table.............................................................................................................. 7

Lens shift range .............................................................................................................. 9

Projector dimension ............................................................................. 11

Lens dimension...................................................................................... 12

Remote control ..................................................................................... 13

RS232 command ................................................................................... 14

RS232 pin assignment.................................................................................................... 14

2016/ 4/ 18

English

Notice

Laser notice

This symbol indicates that there is a potential hazard of eye exposure to

laser radiation unless the instructions are closely followed.

CLASS 3R LASER PRODUCT

This Laser Product is designated as Class 3R during all procedures of operation.

LASER LIGHT - AVOID DIRECT EYE EXPOSURE.

Do not point laser or allow laser light to be directed or reected toward other

people or reective objects.

Direct or scattered light can be hazardous to eyes and skin.

There is a potential hazard of eye exposure to laser radiation if the included

instructions are not followed.

Caution – use of controls or adjustments or performance of procedures other than

those specied herein may result in hazardous radiation exposure.

Laser Parameters

Wavelength 450nm - 460nm (Blue)

Mode of operation Pulsed, due to frame rate

Pulse width 1.34ms

Pulse repetition rate 120Hz

Maximum laser energy 0.698mJ

Total internal power >100w

Apparent source size >10mm, at lens stop

Divergence >100 mili Radian

English

Cooling notice

Ventilation

Air inlet

Air outlet

Caution for installation

For proper ventilation of the projector, make sure to leave some space around the projector as

shown in the illustration below:

• Table

50cm

above

50cm

above 70cm above

• Ceiling • Stacking

Mar.2015/2015⸜03㚰

30cm above

Minimum 100mm

When edge blending

• To avoid the image shaking or some pixels in the display may be misaligned, do not use the

projector in the following location:

• In a building close to a construction site.

• In a room where an air conditioner unit is working and it vibrates.

• In a place where the temperature changes dramatically that may cause thermal contraction.

• Before making any adjustment, leave the projector lit for at least 15 minutes after its light source

is turned on. This allows the internal temperature of the projector to stabilize.

English

Product information

Packing content

User manual CD

Installation Guide Power cable VGA cable

Remote control

Projector with anti-dust cap

Batteries

Digital Projector

Installation Guide

Specication

LU9235 LX9215

Projection system DLP Single 0.67 WUXGA

DMD Chip

DLP Single 0.7 XGA

DMD Chip

Native resolution 1920*1200 pixels, 16:10 1024*768 pixels, 4:3

Brightness 6000 Lumens 6000 Lumens

Light source Laser diodes

Power consumption 650Watts (Normal mode)/ 530Watts (Eco mode)

Dimension 470 x 220.5 x 519.5 mm

Weight 24 kg (without lens)

Note:

• The brightness is supplied by standard lens, the value will depends on lenses.

• The brightness output will vary depending on each units and actual usage.

English

Terminals

• MONITOR OUT

Connection to other display equipment for concurrent playback display.

• PC

15-pin VGA port for connection to RGB, component HD source, or PC.

• HDBaseT

For connection to RJ45 Cat5/Cat6 cable to input uncompressed high-denition video (HD).

• DVI-D

Connection to DVI source.

• HDMI 1

Connection to HDMI source.

• HDMI 2/MHL

Connection to HDMI or MHL source.

• LAN

For connection to RJ45 Cat5/Cat6 Ethernet cable to control the projector through a network.

• USB 1.5A

Support 5V/1.5A output.

• 3D SYNC OUT

Connection to 3D IR sync signal transmitter.

• VIDEO

Connection to a video source.

• SERVICE

Maintenance exclusive port for authorized maintenance personnel only.

• RS-232

Standard 9-pin D-sub interface for connection to PC control system and projector maintenance.

• PC 2 (R/Pr, G/Y, B/Pb, H,V)

Connection to RGB or YPbPr/YCbCr output signal with BNC type input terminal.

• AUDIO IN (L/R)

Connection to an audio input source via an audio or audio L/R cable.

• AUDIO OUT (L/R)

Connection to a speaker or headset.

• AUDIO IN

Connection to an audio input source via an audio cable.

• WIRED REMOTE IN

Connection to remote control for wire remote control.

Caution:

Make sure the port is valid before inserting a wired remote controller. The remote controller may be damaged in

case of an invalid port, e.g. a wired remote controller is connected to trigger output.

• WIRED REMOTE OUT

Connection to another projector.

• 12V TRIGGER

3.5mm mini earphone jack, employs 200mA display relay to provide 12(+/-1.5)V output and short circuit

protection.

English

Installation

Lens

Model Lens Type Part Number Throw Ratio Lens Shift

LS2ST3 Wide x 5J.JDH37.002 XGA: 0.81

WUXGA: 0.778