BenQ MH760 Bedienungsanleitung

MH760

Projector RS232 Command Control

Installation Guide

2 
Table of Contents 
Introduction ............................................................................................................................................. 3 
Wire arrangement........................................................................................................................................................3 
RS232 pin assignment..................................................................................................................................................3 
Connections and communication settings......................................................................................... 4 
RS232 serial port with a crossover cable ...............................................................................................................4 
Settings ..................................................................................................................................................................4 
RS232 via LAN..............................................................................................................................................................6 
Settings ..................................................................................................................................................................6 
RS232 via HDBaseT.....................................................................................................................................................6 
Settings ..................................................................................................................................................................6 
Command table....................................................................................................................................... 8 
 
 

Introduction

The document describes how to control your BenQ projector via RS232 from a computer. Follow the

procedures to complete the connection and settings first, and refer to the command table for RS232

commands.

Available functions and commands vary by model. Check the specifications and user manual of the purchased projector for

product functions.

Wire arrangement

Wire Arrangement

Color

Black

Brown

Red

Orange

Yellow

Green

Blue

Purple

Gray

Case

Drain wire

Case

RS232 pin assignment

Description

RXD

TXD

GND

RTS

CTS

Connections and communication settings

Choose one of the connections and set up properly before RS232 control.

RS232 serial port with a crossover cable

Settings

On-screen images in this document are for reference only. The screens may vary depending on your Operating System,

I/O ports used for connection, and the specifications of the connected projector.

1. Determine the COM Port name used for the RS232 communications in Device Manager.

PC or laptop

Communication cable (crossover)

D-Sub 9 pin (female)

D-Sub 9 pin (male) on a projector

2. Choose Serial and the corresponding COM port as the communication port. In this given example,

COM6 is selected.

3. Finish Serial port setup.

Baud rate

9600 / 14400 / 19200 / 38400 / 57600 / 115200 bps

Check the baud rate of the connected projector from its OSD menu.

Data length

8 bit

Parity check

None

Stop bit

1 bit

Flow control

None

RS232 via LAN

Settings

1. Find the Wired LAN IP address of the connected projector from the OSD menu and make sure the

projector and the computer are within the same network.

2. Input 8000 in the TCP port # field.

RS232 via HDBaseT

Settings

1. Determine the COM Port name used for the RS232 communications in Device Manager.

2. Choose Serial and the corresponding COM port as the communication port. In this given example,

COM6 is selected.

PC or laptop

RJ45 port on a projector

LAN cable

PC or laptop

HDBaseT compatible device

D-Sub 9 pin

RJ45

RJ45 port on a projector

LAN cable

D-Sub 9 pin

3. Finish Serial port setup.

Baud rate

9600 / 14400 / 19200 / 38400 / 57600 / 115200 bps

Check the baud rate of the connected projector from its OSD menu.

Data length

8 bit

Parity check

None

Stop bit

1 bit

Flow control

None

Command table

•Available features differ by projector specification, input sources, settings, etc..

•Commands are working if the standby power is 0.5W or a supported baud rate of the projector is set.

•Uppercase, lowercase, and a mixture of both types of characters are accepted for a command.

•If a command format is illegal, it will echo Illegal format.

•If a command with correct format is not valid for the projector model, it will echo Unsupported item.

•If a command with correct format cannot be executed under certain condition, it will echo Block item.

•If RS232 control is performed via LAN, a command works whether it starts and ends with <CR>. All the commands and

behaviors are identical with the control through a serial port.

Function

Type

Operation

ASCII

Support

Power

Write

Power On

Yes

Write

Power off

Read

Power Status

Source

Selection

Write

COMPUTER/YPbPr

Write

COMPUTER 2/YPbPr2

Write

COMPUTER 3/YPbPr3

Write

Component

Write

Component2

Write

DVI-A

Write

DVI-D

Write

HDMI

Write

HDMI 2

Write

Composite

Write

S-Video

Write

Network

<CR>*sour=network#<CR>

Write

USB Display

<CR>*sour=usbdisplay#<CR>

Write

USB Reader

<CR>*sour=usbreader#<CR>

Write

Wireless

<CR>*sour=wireless#<CR>

Write

HDbaseT

<CR>*sour=hdconnect#<CR>

Write

DisplayPort

Read

Current source

Audio Control

Write

Mute On

Write

Mute Off

Read

Mute Status

Write

Volume +

Write

Volume -

Read

Volume Status

Write

Mic.Volume +

<CR>*micvol=+#<CR>

Write

Mic.Volume -

<CR>*micvol=-#<CR>

Read

Mic.Volume Status

<CR>*micvol=?#<CR>

Audio source

select

Write

Audio pass Through off

<CR>*audiosour=off#<CR>

Write

Audio-Computer1

(AUDIO IN)

<CR>*audiosour=RGB#<CR>

Write

Audio-Computer2

(AUDIO IN 2)

<CR>*audiosour=RGB2#<CR>

Write

Audio-Video/S-Video

(AUDIO IN L/R)

<CR>*audiosour=vid#<CR>

Write

Audio-Component

<CR>*audiosour=ypbr#<CR>

Write

Audio-HDMI

<CR>*audiosour=hdmi#<CR>

Write

Audio-HDMI2

<CR>*audiosour=hdmi2#<CR>

Read

Audio pass Status

<CR>*audiosour=?#<CR>

Picture Mode

Write

Dynamic

<CR>*appmod=dynamic#<CR>

Write

Presentation

<CR>*appmod=preset#<CR>

Write

sRGB

<CR>*appmod=srgb#<CR>

Write

Bright

<CR>*appmod=bright#<CR>

Write

Living Room

<CR>*appmod=livingroom#<CR>

Write

Game

<CR>*appmod=game#<CR>

Write

Cinema

<CR>*appmod=cine#<CR>

Write

Standard/Vivid

<CR>*appmod=std#<CR>

Write

User1

<CR>*appmod=user1#<CR>

Write

User2

<CR>*appmod=user2#<CR>

Write

User3

<CR>*appmod=user3#<CR>

Write

ISF Day

(Expert mode 1)

<CR>*appmod=isfday#<CR>

Write

ISF Night

(Expert mode 2)

<CR>*appmod=isfnight#<CR>

Write

<CR>*appmod=threed#<CR>

Read

Picture Mode

<CR>*appmod=?#<CR>

Picture Setting

Write

Contrast +

Write

Contrast -

Read

Contrast value

Write

Brightness +

Write

Brightness -

Read

Brightness value

Write

Color +

<CR>*color=+#<CR>

Write

Color -

<CR>*color=-#<CR>

Read

Color value

<CR>*color=?#<CR>

Write

Sharpness +

<CR>*sharp=+#<CR>

Write

Sharpness -

<CR>*sharp=-#<CR>

Read

Sharpness value

<CR>*sharp=?#<CR>

Write

Color Temperature-Warmer

<CR>*ct=warmer#<CR>

Write

Color Temperature-Warm

Write

Color Temperature-Normal

<CR>*ct=normal#<CR>

Write

Color Temperature-Cool

Write

Color Temperature-Cooler

<CR>*ct=cooler#<CR>

Write

Color Temperature-lamp

native

<CR>*ct=native#<CR>

Read

Color Temperature Status

Write

Aspect 4:3

Write

Aspect 16:9

Write

Aspect 16:10

Write

Aspect Auto

Write

Aspect Real

Write

Aspect Letterbox

Write

Aspect Wide

Write

Aspect Anamorphic

Read

Aspect Status

Write

Digital Zoom In

<CR>*zoomI#<CR>

Write

Digital Zoom out

<CR>*zoomO#<CR>

Write

Auto

Write

Brilliant color on

Write

Brilliant color off

Read

Brilliant color status

Operation

Settings

Write

Projector Position-Front

Table

Write

Projector Position-Rear

Table

Write

Projector Position-Rear

Ceiling

Write

Projector Position-Front

Ceiling

Write

Quick auto search

Andere Handbücher für MH760

Inhaltsverzeichnis

Andere BenQ Projektor Handbücher

BenQ

BenQ HT4550i Bedienungsanleitung

BenQ

BenQ Home Entertainment Series Bedienungsanleitung

BenQ

BenQ TH682ST Bedienungsanleitung

BenQ

BenQ W1060 Bedienungsanleitung

BenQ

BenQ HT1070 Bedienungsanleitung

BenQ

BenQ LU9715 Bedienungsanleitung

BenQ

BenQ MX813ST Bedienungsanleitung

BenQ

BenQ MS500 Bedienungsanleitung

BenQ

BenQ MX819ST Bedienungsanleitung

BenQ

BenQ MS500 Bedienungsanleitung

BenQ

BenQ MS521 Bedienungsanleitung

BenQ

BenQ W1070 Bedienungsanleitung

BenQ

BenQ HT6050 Bedienungsanleitung

BenQ

BenQ MX720 Bedienungsanleitung

BenQ

BenQ MS500H Bedienungsanleitung

BenQ

BenQ MW855UST+ Bedienungsanleitung

BenQ

BenQ PU9730 Bedienungsanleitung

BenQ

BenQ W1250 Bedienungsanleitung

BenQ

BenQ MP615P Bedienungsanleitung

BenQ

BenQ BH3020 Bedienungsanleitung

BenQ

BenQ GP100 Bedienungsanleitung

BenQ

BenQ MX511 Bedienungsanleitung

BenQ

BenQ Joybee GP2 Bedienungsanleitung

BenQ

BenQ HT3050 Bedienungsanleitung

Beliebte Projektor Handbücher anderer Marken

iEmmet

iEmmet MP-312 Bedienungsanleitung

Epson

Epson VS400 Bedienungsanleitung

Sony

Sony VPL-HS10 Marketing Specifications & Features Bedienungsanleitung

Sony

Sony VPL-HW65ES Service-Handbuch

Toshiba

Toshiba TLP-791U Bedienungsanleitung

Philips

Philips LC1341 Referenzhandbuch

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Bedienungsanleitung

NEC

NEC NP600S EDU Bedienungsanleitung

Eiki

Eiki EK-623U series Bedienungsanleitung

Epson

Epson PowerLite Pro Cinema 6020UB Bedienungsanleitung

Epson

Epson PowerLite Home Cinema 705HD Bedienungsanleitung

Christie

Christie LHD700 Bedienungsanleitung

Navitar

Navitar FX Bedienungsanleitung

InFocus

InFocus LitePro 560 Bedienungsanleitung

Sony

Sony SRX-R815P Bedienungsanleitung

Vivitar

Vivitar DP1500 X Bedienungsanleitung

Acer

Acer C20 Series Bedienungsanleitung

Asus

Asus ZenBeam Latte Bedienungsanleitung