4
Special Opera ons of the AC Hot Water
Dry Mode Removes moisture from the air in high humidity by cycling the indoor
fan offor to very low speed.
Cooling Only Use the system the same as you would use any air condi oning system,
set you air movement flaps to suit the room. Recommended
temperature to be set to is 24`C, however every 1`C increase may save
as much as 10% on your running costs.
ng only Use the system the same as you would use any air condi oning system,
set you air movement flaps to suit the room. Recommended
temperature to be set to is 22`C, however every 1`C decrease may save
as much as 10% on your running costs.
Auto This will select a temperature displayed on the screen in the centre of
the unit and maintain it in h ng or cooling. (not a recommended
ng)
Hot Water Only The system can be manually switched on now, Via a wall switch or a
clock and smart systems to gain advantage of off peak power. The
infra red controller can also switch the system on. The water is
automa cally controlled to a set temperature of 60`C.
Cooling and Hot Water You operate your system as a normal air condi oner and while you are
doing so it he ng your hot water for Free.
ng and Hot Water Because of the unique design of the system, the indoor unit will only
start to func on when the tank temperature is above 32`C. If hea ng is
required straight away then turn offyour hot water(remember to turn
back on later, or switch the system to hot water only l it reaches
32`C and then turn the he g on as well.
Auto and Hot Water Same as Cooling and ng modes
Dry and Hot Water Func on not available. Hot Water is not produced in the func on as the
op on of the system is not conducive to produce hot water.
Smart System The Hot Water Smart System will monitor if the compressors opera on
in Auto, Cooling and Hea ng, if the compressor does not operate for
One hour, the system will switch to Heat Pump hot water mode. The
Smart System was designed if you accidentally forget to turn offyour
aircondi oner and the house/room has cooled down over night and you
or your family shower in the morning, the hot water system would have
started to heat the water because of the Smart System.
The compressor needs to run to generates all the heat that heats your
families water.
