General description
The OmniaMOD-V2 central station receives events from remote security sys-
tems. A remote security system consists of a control panel with built-in digital
communicator. Data from the control panel is sent via telephone to the Om-
niaMOD-V2 modem, which then sends it to the computer. Event data that is
received by the modem is interpreted by the Central Station software, accord-
ing to the client data:
Øclient address;
Øtelephone number;
Øsystem pictures and ground plans;
Øsensor position on the premises;
Ødiagram of arm/disarm times of the remote security system.
Each event which occurs in the remote system causes the communicator
to send coded data to the OmniaMOD-V2. When the event is acknow-
ledged, it is displayed on the monitor (and also printed on the printer) ac-
cording to its priority. Events are classified in three groups:
Øalarms (an event is acknowledged by an acoustic signal and flashing of
the message in the active window);
Øwarnings (also generate the acoustic signal and message in the active
window);
Ømessages give the rest of the information which tells the operator of the
status of the remote systems, and of the Central Station itself (arm/disarm,
test communications, operator change-over, ...).
When an alarm or warning occurs, the operator, according to instructions, scans
the system information and pictures, then takes the necessary actions to elimi-
nate the cause of the event (calls the fire brigade, sends a security team to the
system location, sends maintenance service to the system location).
System requirements and description
Computer
rCPU i80486 or higher.
r4Mb of RAM.
rAt least 10 Mb free on the hard disk.
rMS-DOS 3.3 or higher
rPrinter.
Telephone lines Public telephone network or local telephone network with equivalent char-
acteristics.
Modem BENTEL OmniaMOD-V2.
remote security
system Built-in communicator with the capability of sending data in ADEMCO pro-
tocol 10 baud in required data format 3+1, 3+2, 4+1, 4+2.
6Central Station OmniaMOD-V2
