V1 ENGLISH 21-0048
Insert the straightened wire into either of the two
holes of the hot and neutral locations on the side of
the outlet. Power passes between the two
corresponding holes for pass-thru wiring. Attach
the ground wire to the bottom of the outlet.
6Tighten every screw and make sure that no
bare copper wire is exposed. When tightening
screws, use 14 pounds-per-inch of torque.
7Carefully insert the
charger outlet into the
wall box.
8Secure the charger
outlet to the wall box
with the two long
screws (provided).
9Secure the wall plate to
the charger outlet
with the two short
screws (provided).
10 Restore power by
replacing the fuse or
turning on the circuit
breaker. The charger
outlet is ready to use.
Using the charger outlet
• To charge USB devices (like mobile phones or
tablets), plug USB cables into the USB ports on
the charger outlet and into the USB ports on the
devices.
• To power electrical devices (like lamps or laptop),
plug them into the electrical outlets.
Specications
Dimensions (H × W × D)
With plate:
4.7 × 3 × 1.9 in. (120 × 76 × 47.5 mm)
Without plate:
4.2 × 1.7 × 1.9 in (106 x 43 x 47.5 mm)
Electrical
Receptacle Rating: 15Amp, 125VAC
USB Rating: Two USB ports with total 3.6A, 5V DC
Line voltage: 125V AC @ 60 Hz
Wire Terminals: #14-#12 AWG
Legal notices
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
One-year limited warranty
Visit www.bestbuy.com/bestbuyessentials for
details.
Contact Best Buy Essentials
For customer service, call 866-597-8427 (U.S. and
Canada)
www.bestbuy.com/bestbuyessentials
Best Buy Essentials is a trademark of Best Buy and its aliated
companies.
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2021 Best Buy. All rights reserved.
BE-HW36A218_21-0048_QSG_V1_EN_Final.ai 2 2/10/2021 9:37:30 AM
