Bestsub JTrans PLUS-KBJN Bedienungsanleitung
USER MANUAL
Item No.: PLUS-KBJN
®
JTrans Plus
DIGITAL MUG PRESS
www.bestsub.com
1
2
LEADING MARKET BY QUALIFIED SERVICE LEADING MARKET BY QUALIFIED SERVICE
®
JTrans PLUS Mug Press ®
JTrans PLUS Mug Press
Item No.: PLUS-KBJN
Item Name.: PLUS Mug Press
Power: 350W
Voltage: 110V / 220V
Temp. System: Celsius & Fahrenheit
Temp. Range: 0~250 Celsius
Time Range: 0~999 Seconds
Heater Size: for 10oz mugs, 11oz mugs, 12oz
latte mugs, or 17oz latte mugs
Power On/Off
Power Interface
Digital Display
Silicon Mug Wrap
Pressure Adjustment Screw
Pressure Handle
OPERATING PROCESS
Step 1: Before power on, put a blank mug inside the machine, use the pressure adjustment screw
to adjust the pressure to be moderate and switch on the mug press.
Step 2: Set temperature and time according to different mug materials.
Temperature setting:
Press "SET" button for the first time and it will show “5P” which means the printing
temperature. Press up and down button to adjust. The recommended temperature
is 140℃~190℃.
Time setting:
Press "SET" button for the second time and it will show “ ”which means the printing time.
Press up and down button to adjust. The recommended time is 60-120seconds.
Press “SET” button for the third time to lock the setting. It shows heating up and time on
the screen. Temperature is rising now.
Step 3:
Wrap the mug with the cut image paper. Make the image in the central and make it symmetrical
both sides; Stick the paper with thermal tape.
Step 4:
When the temperature rises to the set temperature, place the mug horizontally in the center of the
mug press and the mug handle up (you can also place it in a non-central position as needed).
Close down the pressure handle and start to transfer.
Time is counting down; once the time is up, the buzzer will send out sounds. Lift the pressure handle
and turn off the power. If you want to print another mug, then repeat the process above. Unplug
the power cord when the machine is not in use.
Note:
Press SET button for five seconds to covert temperature unit between ℃ and ℉.If the heat platen
temperature doesn't match the set temperature, press SET button once again and enter the
difference to correct temperature. Then press SET button for five seconds again to exit setting mode.
STOP
SET
PV
SV
COUNTER
S
OC
Inhaltsverzeichnis
Andere Bestsub Elektrowerkzeuge Handbücher
