Biamp Desono DX-S Bedienungsanleitung

A:9300 S.W. Gemini Drive Beaverton, OR 97008 USA W:www.biamp.com

Desono™

DX-S U-Bracket (SPA-UBDXxxx)

Installation Guide

SPA-UBDX100 - ts DX-S5

SPA-UBDX200 - ts DX-S8

The U-Bracket is a low profile powder-coated marine grade

aluminum design that allows the unit to be connected to a

center suspension post or against the wall, ceiling, or other

flat surface. It can also be mounted to a variety of third party

stand and pole adapters.

A hole drilling template is included in each box to make

installation easier.

U-Bracket

ClickPlug

Spacers

Bolts

Installation

1. Mount the U-Bracket prior to loudspeaker installation.

If mounting it horizontally on a wall, the slots should

face up - see image at right. Route cable through the

channel. Su󰀩cient cable should be pulled through

an unused bracket hole to create a drip loop (damp/

wet applications) with enough extra to connect to the

ClickPlug.

NOTE: If the wall is not nished before the loudspeaker is

mounted, the U-Bracket and cable should be masked with

painter's tape or other masking material.

2. Wire the ClickPlug as shown leaving enough for the

likely mounting angle and a drip loop if necessary. Do

this before mounting the loudspeaker.

Cable / Wire Size

ClickPlug Cable gland nut will accept a 4-8mm (0.15-.3 in)

diameter cable or 2 pairs 1.5mm² (16 ga) or 1 pair 2.5mm²

(14 ga). For outside or moisture-rich environments - round

SJOW cable or equivalent is advised to provide a weather-

resistant seal in the tightened gland nut.

Tools Needed

• 5.5mm (or 7/32") Hex wrench

• Thin blade or flat screwdriver

Structure Mounting Points

(Hardware not provided)

Cable channel

Thread cable through the gland nut

and barrel into ClickPlug

(2 conductor cable shown)

ClickPlug wired with 2 pairs for

daisy-chained applications

SPA-UBDX Installation Guide

Attach the Loudspeaker to the U-Bracket

3. Remove the round caps covering the center mounting

holes. Insert a thin blade into the front or rear of each

end cap and pry them up. Pinch the side supports, and

remove the caps. They can be discarded.

4. Insert a spacer into the recess. The thicker edge should

be toward the rear of the loudspeaker, and the tabs

should t into the recess slots.

5. Thread a at head bolt into the center hole on each end,

leaving about 1/4" (6mm) of thread exposed.

6. Slide the loudspeaker onto the U-Bracket with the

bolts tting in the slots. It is easier if the back of the

loudspeaker is facing the bracket.

7. Rotate to the approximate aiming position and tighten

the bolts to hold the unit in place, but still allow it to

rotate slightly.

8. Set aiming angle and tighten the bolts to prevent any

movement. Once the angle is nal, fully tighten bolts by

using a 5.5mm (7/32") hex wrench. The loudspeaker will

rotate 200° on the bracket.

IMPORTANT: The cabinet is nished with a light coat of paint.

Take care to avoid scratching or marring the nish when sliding the

loudspeaker onto the U-Bracket.

Vertical Orientation Horizontal Orientation

SPA-UBDX Installation Guide

Adjust the Tap Switch

9. Rotate the tap switch knob to the

desired setting before you attach

the ClickPlug to the loudspeaker.

CLICK

CAUTION: The ClickPlug t is very tight and is di󰀩cult to

remove, especially if it is oriented toward the side of the

unit. Avoid attaching the ClickPlug until the speaker is fully

installed. If the unit is installed outdoors or in a damp location

make sure a cable drip loop is utilized to prevent any moisture

from migrating into the gland nut.

Attach the ClickPlug

10. Insert the wired ClickPlug into the opening with the plug

top (or side) into the indent under the safety cable loop

rst, then "click" it into place by pushing it against the

latch until it is fully seated, and the latch returns to the

"up" position. The general orientation of the ClickPlug

should be with the gland nut pointed down (exception

noted on the next page). It cannot be mounted with the

gland nut pointed toward the safety loop.

IMPORTANT: The t is very tight; press on the raised

portion of the ClickPlug rather than the gland nut when

inserting it.

10 10

SPA-UBDX Installation Guide

NOTE: When mounted horizontally, the ClickPlug gland nut and

U-Bracket may interfere with each other. In this instance, the

ClickPlug needs to be rotated 90° to provide clearance for the

U-Bracket rotation. See image at right. In damp/wet applications

you must use a drip loop to prevent the chance of water traveling

into the gland nut.

The ClickPlug should be oriented as shown below. It can not

be installed upside-down.

ClickPlug Orientation

Attach safety

cable here

Attach Safety Cable

11. Secure the loudspeaker with a safety cable attached to

the loop on the rear. The cable should be mounted to a

secondary structural mounting point close to, and above

the U-Bracket to avoid any kinetic force if the mount

should fail.

NOTE: The installer is responsible for sourcing the proper safety

cable to meet all applicable local building codes and standards.

A:9300 S.W. Gemini Drive Beaverton, OR 97008 USA W:www.biamp.com

SPECIFICATIONS

Material / Finish:Powder-coated Marine Grade

aluminum. Black (RAL 9017) or White (RAL 9016)

Color matched ABS spacer

Unit Weight

SPA-UBDX100: xx lbs (xx kg)

Scan this QR-code to download the

full DX-S Installation guide

TECHNICAL DRAWINGS

08NOV2022

Email: [email protected]

Web: support.biamp.com

Warranty: biamp.com/legal/warranty-information

Desono™

DX-S U-Bracket (SPA-UBDXxxx)

bia.mp/DX-S_pubs

SPA-UBDX100 SPA-UBDX200

Inhaltsverzeichnis

Andere Biamp TV-Halterung Handbücher

Biamp

Biamp Desono E200-UMK Original Betriebsanleitung

Beliebte TV-Halterung Handbücher anderer Marken

Ergotron

Ergotron Neo Flex Cantilever UHD Bedienungsanleitung

StarTech.com

StarTech.com FPCEILBTB Bedienungsanleitung

VonHaus

VonHaus 05/038 Bedienungsanleitung

Techlink

Techlink ECHO TV Bedienungsanleitung

Sandstrom

Sandstrom SSTVMC12X Bedienungsanleitung

Sony

Sony SU-WL700 Leitfaden

ICW

ICW SCACC18 Bedienungsanleitung

LG WM-L640V Bedienungsanleitung

Gembird

Gembird WM-65ST-01 Bedienungsanleitung

ERARD

ERARD FiTUP XXL 035320 Bedienungsanleitung

PEERLESS

PEERLESS PLCK-1 Leitfaden

Kanto

Kanto RCF180 Bedienungsanleitung

GEM

GEM GEM GP001 Bedienungsanleitung

Gladiator Joe

Gladiator Joe GJ0A0053 Bedienungsanleitung

Vivotek

Vivotek AM-105 Bedienungsanleitung

Vivo

Vivo VESA STAND-VAD1B Bedienungsanleitung

AmazonBasics

AmazonBasics B07QG3LMG4 Bedienungsanleitung

Secura

Secura QLF210 Bedienungsanleitung