Billion SG600R2 Bedienungsanleitung

Billion SG600R2

Smart Energy Wireless

Router

Quick Start Guide

V1.01_20161103

Table of Contents

CHAPTER 1: Introduction..............................................................................0

Introduction of BEsmart...................................................................1

BEsmart Application ........................................................................2

CHAPTER 2 Installation of Web Manager....................................................3

2.1 Quick Start ......................................................................................27

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

‧Reorient or relocate the receiving antenna.

‧Increase the separation between the equipment and receiver.

‧Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

‧Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1)

This device may not cause harmful interference

(2)

This device must accept any interference received, including interference that may

cause undesired operation. Any changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority to operate this

equipment. . This device and its antenna(s) must not be co-located or operating in

conjunction with any other antenna or transmitter.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated with

minimum distance 20cm between the radiator & your body.

Contains TX FCC ID:QI3BIL-MD1000

WARNING

電磁波曝露量MPE標準值1mW/cm2，送測產品實測值為:0.0392 mW/cm2，本產

品使用建議應距離人體大於 20 cm以上

NCC Warning Statement

Article 12

Without permission, any company, firm or user shall not alter the frequency,

increase the power, or change the characteristics and functions of the original

design of the certified lower power frequency electric machinery.

Article 14

The application of low power frequency electric machineries shall not affect the

navigation safety nor interfere a legal communication, if an interference is found,

the service will be suspended until improvement is made and the interference no

longer exists.

CHAPTER 1

Introduction

Introduction of BEsmart

The issue of environmental protection and energy conservation has been

received great attentions since the global warming and energy shortage have

become a serious worldwide crisis. Billion BEsmart highlights the importance

of energy preservations and managements, and contributes smart solutions for

Telco/ISP/SI service providers who dedicate to strengthening customer

satisfactions. With the implement of the smart control, track, and monitor

power consumption technologies, energy usage could be clearly examined

and analyzed anytime and anywhere simply through a smart phone. It helps

reduce energy waste, provide a green environment, and further increase the

benefit of the mutual investment, that is, the investors and customers.

BEsmart brings a great amount of benefits with a long-term effect:

Increase Average Revenue, Increase Customers’ Satisfaction and Loyalty,

Reduce Customers’ Churn Rate, Leverage Existing Network Infrastructure,

Bring GREEN and Carry Out CSR. Furthermore, BEsmart also provides

effective power management, highly flexible on connection and establishment,

and extended applications on other services. Creating a win-win situation for

service providers and customers and establishing a green society are what

BEsmart expect to accomplish.

BEsmart Application

The Billion BILLION SG600R2, ZigBee Wireless Smart Energy Gateway, is a

TCP/IP based ZigBee/Wi-Fi appliance designed for users to enjoy real-time

power management. Integrated with ZigBee wireless technology, the BILLION

SG600R2 can communicate wirelessly with Billion ZigBee-enabled smart device,

like SG3015-Tx meter and SG110-A Temperature / Humidity sensor.

The Billion BILLION SG600R2 not only provides a wireless AP feature for

connecting with local smart phone or notebook but also acts as a wireless client

for connecting to Internet. This feature can extend the wireless coverage and

reduce the wiring cost.

This ZigBee Wireless Smart Energy Gateway pushes all the recorded data to

the back-end / cloud system which were built by SI and software companies so

users can remotely monitor energy consumption and manage their appliances.

This solution is ideal for SI of energy management, utility projects and service

providers.

CHAPTER 2

Installation of Web Manager

The router not only functions as a smart wireless bridge but builds Power

Management Application into Web GUI. End users can monitor real time

power information and control the Smart Energy Meter through Web GUI

remotely. Please be noted that here we just focus on functions that are

relevant to the power smart management. Let’s start the configurations.

2.1 Quick Start

Step 1 : Hardware setting

Connect the BILLION SG600R2 to your PC’s Ethernet interface with supplied

RJ-45 Ethernet cable and the other side to a router or modem with Ethernet

cable or wireless client for the internet connection.

Step 2: Computer IP setting

The default address of BILLION SG600R2 is 10.10.10.252. For the first

setting, please modify your PC IP to the recommended IP 10.10.10.100

(ranged from 10.10.10.1 to 10.10.10.251).

Step3: Access to BILLION SG600R2 WEB GUI

Open your web browser and enter the IP address of your router, which by

default is 10.10.10.252, and click “Go”. Then a login window prompt will

appear.

The default username and password are “admin” and “admin” respectively.

Choose “Administrator” from the account type to configure and managethe

web settings if your are authorized to access the router.

Once you have logged in to your BILLION SG600R2, you can begin to set

it up according to your requirements. You would see the main page of

basic status, including Device Information, Port Status, and WAN

information.

Time Zone Setting

First, set up the time to meet the time zone of your country. Click “Continute”.

6. There are 3 types of connection protocols available for WAN connectmode:

Obtain an IP Address Automatically, Fixed IP Address, and PPPoE

BILLION SG600R2 provides the WAN interface based on your own

backbonerouter. There are 2 Connect Modes: Ethernet and Wireless

Client.

EWAN: Your backbone router/cable modem is based on Ethernet base.

Wireless Client: Your backbone router or cable modem has the Wi-Fi

function.

For the detail Configuration, please refer to BILLION SG600R2internet

configuration document.

connection.

Obtain an IP Address Automatically (DHCP)

When connecting to the ISP, your router also functions as a DHCP client. That

is, your backbone device is xDSL router and your PC is assigned an IP

address automatically.

Inhaltsverzeichnis

Andere Billion WLAN-Router Handbücher

Billion

Billion 52 Series Kurzanleitung

Billion

Billion BiPAC 7800DXL Bedienungsanleitung

Billion

Billion BiPAC 6404VGP Bedienungsanleitung

Billion

Billion myGuard 7202G Bedienungsanleitung

Billion

Billion BiPAC 7202 Bedienungsanleitung

Billion

Billion BiPAC 7300W Bedienungsanleitung

Billion

Billion BiPAC 7300 Bedienungsanleitung

Billion

Billion BIPAC-7402W Bedienungsanleitung

Billion

Billion BiPAC 7300NX Installations- und Betriebshandbuch

Billion

Billion BiPAC 7800NX Betriebsanleitung

Billion

Billion BIPAC 6500W Bedienungsanleitung

Billion

Billion BiPAC 6300NX Installations- und Betriebshandbuch

Billion

Billion BiPAC 5400N R2 Bedienungsanleitung

Billion

Billion BiPAC 5200N RC Bedienungsanleitung

Billion

Billion BiPAC 7820NZ Bedienungsanleitung

Billion

Billion BiPAC 7800VDOX Bedienungsanleitung

Billion

Billion BiPAC 7800(N)X(L) Bedienungsanleitung

Billion

Billion BiPAC 7800X Bedienungsanleitung

Billion

Billion BiPAC 8800AXL Bedienungsanleitung

Billion

Billion BiPAC 7800(N)X(L) Bedienungsanleitung

Billion

Billion BiPAC 6300NXL Bedienungsanleitung

Billion

Billion BiPAC 7300GX Bedienungsanleitung

Billion

Billion BiPAC 6300NX Bedienungsanleitung

Billion

Billion BiPAC 7800NL Bedienungsanleitung

Beliebte WLAN-Router Handbücher anderer Marken

Milesight

Milesight UG67 Bedienungsanleitung

Airlogic

Airlogic AirSync Class 1 Betriebsanleitung

Samsung

Samsung WCH730B Bedienungsanleitung

TELEFONICA

TELEFONICA USB Adapter Bedienungsanleitung

NETGEAR

NETGEAR PowerLINE WiFi 1000 Series Bedienungsanleitung

Askey

Askey RAC2V1K Bedienungsanleitung

Alloy

Alloy WLF2454AP-S Bedienungsanleitung

TP-Link

TP-Link TL-WR542G Bedienungsanleitung

NETGEAR

NETGEAR WNR2000v4 Bedienungsanleitung

Hama

Hama 53120 Bedienungsanleitung

Intellinet

Intellinet 524582 Bedienungsanleitung

Asus

Asus RT-N10P Bedienungsanleitung

D-Link

D-Link DIR-506L Bedienungsanleitung

Sapido

Sapido GR297n Bedienungsanleitung

Asus

Asus DSL-N55U Bedienungsanleitung

AMTC

AMTC WR7502 Bedienungsanleitung

Compaq

Compaq CP-2W - iPAQ Connection Point Bedienungsanleitung

SMC Networks

SMC Networks WBR14-N2 FICHE Bedienungsanleitung