Using the Preset Stations
To store your favorite radio station into a preset, first turn on the radio using the Volume p (∧
∧∧
∧) button,
and then tune to the station to be used. Then, hold down the desired preset button for about three
seconds or until it beeps. The upper display will read (for example) “P1” with the frequency of the
preset station, e.g., “P1 88.5.” To switch to one of the preset stations while listening to the radio,
simply press a preset button briefly. Follow the same process for either of the first two preset buttons.
NOTE: If the radio is off, you can hold any of the preset buttons and the radio will turn on to that preset
station; that same preset button can also be used to shut the radio off. The logic above also works for
turning on the Sounds by using preset number 3.
ctivating the larm
Press the ALARM button and make sure the Sun Symbol is illuminated. The display will show the Sun
Symbol and the Alarm Time will be displayed briefly. You can also see the alarm mode that you have
chosen (Beep Symbol, Audio Symbol, or Flash Symbol). If the light is on, it will slowly fade down, or
you can turn it off quickly by pressing and holding the (-) button.
Turning Off the larm
When it’s time to wake up, the light will have reached full brightness and, if enabled, the audio wake or
beep will sound at the chosen alarm time. You can shut off the sound by pressing the alarm button but
the light will remain illuminated. After this, you can shut off the light manually by holding (-) down
for several seconds, otherwise it will shut off automatically after 30 minutes. If nothing is done after
the alarm time, the light will automatically go out.
Using the “Snooze” Feature
To temporarily “snooze” the alarm, press the snooze button while the alarm is operating (beeping, radio
on or light flashing). The light will fade out in a few seconds and the alarm (beep, radio, or sound) will
stop. The light and alarm will come back on again in 10 minutes.
Snooze Button as Temporary Night Light Feature
Whether the Alarm is on or not, you can press the Snooze button to quickly turn the light OFF. It can
also turn the light ON to a low intensity. This is useful for getting up in the night without flooding the
room with too much light.
PROGR MMING THE SUNRISE CONTROLLER
The PROGRAM button allows all the programmable features to be set or adjusted. To adjust any
setting, make sure the alarm button is not engaged. If the alarm is engaged, the SunRise Symbol will
show and you must press the ALARM button to disengage it. The text display above the time digits
will show the setting you are changing and what the current status is. se the PL S button (+) and
MIN S button (-) to change that setting.
Fig. 3 outlines all of the features that can be programmed along with the number of times the Program
button should be pressed to reach each feature. Altogether, there are 20 programming steps that can be
used to set every feature. You can go through them step by step, or you can skip directly to a particular
feature by pressing the program button the number of times indicated. Once you have completed a
setting, you can press the PROGRAM button again to adjust another setting, or simply wait for
approximately 10 seconds until the display returns to the time. At several points in the programming
cycle the display will read “MORE?” to indicate that you can go on programming more features by
pushing the + button, or stop programming by pushing the minus button. Once you have made your
programming selections, the Controller will remember them indefinitely, unless there is an extended
power outage.
4
