Biogents CO2 Timer Bedienungsanleitung
Mosquito Control
2
Table of contents
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Product components . . . . . . . . . . . . . . . . . . . 4
Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Attaching to CO2 tubes . . . . . . . . . . . . . . . . . 14
Contact . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 58
3
Introduction
The Biogents CO2Timer lets you to control when CO2is released by establis-
hing specic start and stop times. It enables you to set up two start and end
times for CO2releases per day. The BG-CO2timer is placed between the CO2
tank and the mosquito trap with CO2connecting tubes.
4
Product components
The BG-CO2Timer consists of a body with a display and buttons to set up
the release times, two connections to the CO2tubes and a 9V battery.
Connection to CO2tube to CO2source
Connection to CO2tube to trap
Buttons to set up release times
Display
5
Battery
The 9V battery to run the timer is located in the back of the body and inclu-
ded, but not connected. To run the timer remove the screws from the back
of the body. Insert the battery and connect the connection plate to the
battery. The timer is now switched on. Then replace the screws and tighten.
The status of the battery is shown in the display. The battery should last at
least 9 months.
6
9V battery
Connection plate
Opened back of the body
Battery status
7
Button to switch on display/
Set-up of time frames
Button to increase time /
switch on CO2permanently
Button to decrease time /
switch o CO2permanently
Functions
A3
1
2
5
4Down Arrow indicates CO2emission.
45
“A“ indicates that the timer function is switched o.
8
Switch on the display by pressing button 3.
To start set-up of the current time press button 3 for two
seconds.
To adjust the current time use button 1 to increase and but-
ton 2 to decrease the time.
2 sec.
short
3
3
12
Switch on / Set current time
9
After setting up the current time press button 3. „S1“ (Start
time 1) appears in the display.
Set the rst start time with buttons 1 and 2 as described
above.
Start time 1
Start set-up of
start time 1
3
1
2
Increase time
Decrease time
S1
3
12
10
After setting up the rst start time press button 3. „E1“ (End
time 1) appears in the display.
Set the end time with buttons 1 and 2 as described above.
End time 1
Start set-up of
end time 1
3
1
2
Increase time
Decrease time
E1
3
12
Inhaltsverzeichnis
Sprachen:
Andere Biogents Timer Handbücher
