98
• Clean with soap and water as needed.
The base is dishwasher safe for top rack only.
The lid is NOT dishwasher safe.
• Do not put the unit in the freezer.
• Store out of direct sunlight.
• Do not store pressurized for more than 36 hours.
• Spray air through the unit to dry out the silicone
tube before storing for long periods.
• It’s a good idea to lock the trigger in the ON
position when storing for long periods to keep
the Pinch Tube from kinking.
• Spare parts are available on lunatecgear.com.
• Instructional videos are available on product
pages at lunatecgear.com.
• For help, contact us at support@lunatecgear.com
Aquabot®MAINTENANCE High Level Disinfection of OtoClear®,
powered by Aquabot®:
It is recommended to high level disinfect OtoClear®, powered by Aquabot®
after any use where there was contact with blood, infectious material, or
non-intact skin.
01. Use one of the following high level disinfecting (HLD) solutions that are
compatible with OtoClear®, powered by Aquabot®:
• Ortho-Phthalaldehyde Solution (0.55% maximum)
• Accelerated Hydrogen Peroxide Solution (2% maximum)
• Glutaraldehyde Solution (3.0% maximum)
02. Prepare the HLD solution per the manufacturer’s instructions.
03. Remove the spray head from the bottle.
04. Ensure all water has been drained from the bottle and the spray head.
05. Fill OtoClear®, powered by Aquabot®with the HLD solution and reattach the
spray head.
06. Pump OtoClear®, powered by Aquabot®until HLD solution discharges.
07. Remove the spray head and completely fill the bottle with HLD solution.
08. Reattach the spray head.
09. Allow the HLD solution to soak in OtoClear®, powered by Aquabot®per the
HLD manufacturer’s instructions for use.
10. After the manufacturer’s recommended soak, remove the spray head from the
bottle and empty the HLD solution from the bottle.
11. Thoroughly rinse the outer surfaces of the bottle and spray head with water.
12. Fill the bottle with clean rinse water and reattach the spray head.
13. Pump until half of the bottle is discharged.
14. Repeat steps 11 – 13 until the bottle has been rinsed three times.
15. Remove the spray head from the bottle.
16. Drain all water from the bottle.
17. Pump the spray head until all water is discharged.
18. Dry the outer surfaces of the bottle and spray head and leave them separated
to allow complete drying.
19. To high level disinfect the ear basin, repeat steps 1 & 2 and follow the
manufacturer’s instructions.
