4. Operation
4.1. Connect the external power supply unit to electric circuit.
4.2. Place samples on the platform.
4.3. Switch On the Power switch (Fig.1/1) (the timer display (Fig.1/3) will light).
4.4. Using the p and q keys (Fig.1/4) set the working time. The set time is
displayed on the Timer indicator in hours and minutes (hh:mm).
4.5. Press the Start key (Fig. 1/2). The platform will start rocking movement and the
timer will start counting up the set time interval. Timer display shows actual
elapsed time: until 1 hour – in minutes and seconds (mm:ss), after 1 hour – in
hours and minutes (hh:mm).
4.6. Set the shaking speed as recommended, using the Speed knob (Fig 1/6)
4.7. After the set time interval expires the platform movement will stop and the set
working time will be shown on the timer display.
4.8.Press the Start key to repeat operation with the same working time and speed.
4.9.The unit can be stopped before the set time elapses if necessary by pressing
the Stop key (Fig. 1/5). For 20 seconds the time indicator will be showing the
time the shaker has worked, and after that it will be showing the set time.
4.10.Pressing the Stop key for more than 3 s resets the set time.
4.11. If the working time is not set (or reset) and the display shows 0:00, pressing the
Start key will start time indication and will cause the unit to operate non-stop
until the Stop key is pressed.
4.12.After finishing the work turn the Power switch to the Off position. Disconnect
the external power supply unit from electric circuit.
64321
Speed
Time
Power
On
Off
Start Stop/Reset
5
Fig.1 Control panel
Page 8
