BIRD ECONOLOAD 8730 Series Bedienungsanleitung

INSTRUCTION BOOK

ECONOLOAD®LOAD RESISTOR

SERIES 8730

INCLUDING MODELS 8730A, 8731

8732A, 8738A, AND 8738A110

Instruction Book P/N 920-8730S Rev. D

Econoload and Termaline are Registered

Trademarks of Bird Electronic Corporation

This Page Intentionally Left Blank

Safety Precautions

The following are general safety precautions that are not necessarily related to any specific part or pro-

cedure, and do not necessarily appear elsewhere in this publication. These precautions must be thor-

oughly understood and apply to all phases of operation and maintenance.

Safety Symbols

WARNING

Keep Away From Live Circuits

Operating Personnel must at all times observe general safety precautions. Do not

replace components or make adjustments to the inside of the test equipment with

the high voltage supply turned on. To avoid casualties, always remove power.

WARNING

Shock Hazard

Do not attempt to remove the RF transmission line while RF power is present.

WARNING

Do Not Service Or Adjust Alone

Under no circumstances should any person reach into an enclosure for the

purpose of service or adjustment of equipment except in the presence of

someone who is capable of rendering aid.

WARNING

Safety Earth Ground

An uniterruptible earth safety ground must be supplied from the main power

source to test instruments. Grounding one conductor of a two conductor power

cable is not sufficient protection. Serious injury or death can occur if this

grounding is not properly supplied.

WARNING

Resuscitation

Personnel working with or near high voltages should be familiar with modern

methods of resuscitation.

WARNING

Remove Power

Observe general safety precautions. Do not open the instrument with the power on.

WARNING

Warning notes call attention to a procedure, which if not correctly performed,

could result in personal injury.

Calls attention to supplemental information.

Warning Statements

The following safety warnings appear in the text where there is danger to operating and maintenance

personnel, and are repeated here for emphasis.

On pages 6, 13, 14 and 16.

On page 6.

On pages 8 and 14.

On page 17

CAUTION

Caution notes call attention to a procedure, which if not correctly performed,

could result in damage to the instrument.

This symbol indicates that a shock hazard exists if the precau-

tions in the instruction manual are not followed.

The caution symbol appears on the equipment indicating there

is important information in the instruction manual regarding

that particular area.

This symbol indicates that the unit radiates heat and should not

be touched while hot.

WARNING

Disconnect the unit from all power sources before servicing. The unit may be

energized from multiple sources. The potential for electric shock exists.

WARNING

Improper wiring could result in electric shock and death.

WARNING

Never attempt to connect or disconnect RF equipment from the transmission

line while RF power is being applied.

Leaking RF energy is a potential health hazard.

WARNING

If the resistor breaks, there may be splinters or sharp pieces inside the load

housing. Be careful when repairing to avoid being cut.

iii

Caution Statements

The following equipment cautions appear in the text and are repeated here for emphasis.

On page 5.

On page 6.

On pages 6, 7 and 11.

On page 7.

On page 11.

On page 17.

CAUTION

Incorrect hose connections will reverse coolant flow and could destroy the load.

CAUTION

Different control systems are used for 115 Vac and 230 Vac. Use the correct

interlock control for the specific voltage.

CAUTION

If installed, connect optional interlock before applying RF power.

CAUTION

Do not contaminate the coolant with pipe sealant.

CAUTION

Do not interrupt coolant supply. Even momentary application of RF power

while coolant is not circulating could cause immediate destruction of the load

CAUTION

Do not remove the resistor plug. Any attempt to do so will cause leakage and

resistor damage.

Safety Statements

USAGE

ANY USE OF THIS INSTRUMENT IN A MANNER NOT SPECIFIED BY THE MANUFACTURER

MAY IMPAIR THE INSTRUMENT’S SAFETY PROTECTION.

USO

EL USO DE ESTE INSTRUMENTO DE MANERA NO ESPECIFICADA POR EL FABRICANTE,

PUEDE ANULAR LA PROTECCIÓN DE SEGURIDAD DEL INSTRUMENTO.

BENUTZUNG

WIRD DAS GERÄT AUF ANDERE WEISE VERWENDET ALS VOM HERSTELLER

BESCHRIEBEN, KANN DIE GERÄTESICHERHEIT BEEINTRÄCHTIGT WERDEN.

UTILISATION

TOUTE UTILISATION DE CET INSTRUMENT QUI N’EST PAS EXPLICITEMENT PRÉVUE PAR

LE FABRICANT PEUT ENDOMMAGER LE DISPOSITIF DE PROTECTION DE L’INSTRUMENT.

IMPIEGO

QUALORA QUESTO STRUMENTO VENISSE UTILIZZATO IN MODO DIVERSO DA COME

SPECIFICATO DAL PRODUTTORE LA PROZIONE DI SICUREZZA POTREBBE VENIRNE

COMPROMESSA.

SERVICE

SERVICING INSTRUCTIONS ARE FOR USE BY SERVICE - TRAINED PERSONNEL ONLY. TO

AVOID DANGEROUS ELECTRIC SHOCK, DO NOT PERFORM ANY SERVICING UNLESS

QUALIFIED TO DO SO.

SERVICIO

LAS INSTRUCCIONES DE SERVICIO SON PARA USO EXCLUSIVO DEL PERSONAL DE

SERVICIO CAPACITADO. PARA EVITAR EL PELIGRO DE DESCARGAS ELÉCTRICAS, NO

REALICE NINGÚN SERVICIO A MENOS QUE ESTÉ CAPACITADO PARA HACERIO.

WARTUNG

ANWEISUNGEN FÜR DIE WARTUNG DES GERÄTES GELTEN NUR FÜR GESCHULTES

FACHPERSONAL.

ZUR VERMEIDUNG GEFÄHRLICHE, ELEKTRISCHE SCHOCKS, SIND WARTUNGSARBEITEN

AUSSCHLIEßLICH VON QUALIFIZIERTEM SERVICEPERSONAL DURCHZUFÜHREN.

ENTRENTIEN

L’EMPLOI DES INSTRUCTIONS D’ENTRETIEN DOIT ÊTRE RÉSERVÉ AU PERSONNEL

FORMÉ AUX OPÉRATIONS D’ENTRETIEN. POUR PRÉVENIR UN CHOC ÉLECTRIQUE

DANGEREUX, NE PAS EFFECTUER D’ENTRETIEN SI L’ON N’A PAS ÉTÉ QUALIFIÉ POUR CE

FAIRE.

ASSISTENZA TECNICA

LE ISTRUZIONI RELATIVE ALL’ASSISTENZA SONO PREVISTE ESCLUSIVAMENTE PER IL

PERSONALE OPPORTUNAMENTE ADDESTRATO. PER EVITARE PERICOLOSE SCOSSE

ELETTRICHE NON EFFETTUARRE ALCUNA RIPARAZIONE A MENO CHE QUALIFICATI A

FARLA.

CONNECT INTERLOCK TO TRANSMITTER BEFORE OPERATING.

BRANCHER LE VERROUILLAGE À L'ÉMETTEUR AVANT EMPLOI.

CONECTE EL INTERBLOQUEO AL TRANSMISOR ANTES DE LA OPERACION.

VOR INBETRIEBNAHME VERRIEGELUNG AM SENDER ANSCHLIESSEN.

PRIMA DI METTERE IN FUNZIONE L'APPARECCHIO, COLLEGARE IL DISPOSITIVO DI BLOCCO AL

TRASMETTITORE.

vii

About This Manual

This manual covers the operating and maintenance instructions for the following models:

Changes to this Manual

We have made every effort to ensure this manual is accurate. If you discover any errors, or if you

have suggestions for improving this manual, please send your comments to our Solon, Ohio factory.

This manual may be periodically updated. When inquiring about updates to this manual refer to the

part number and revision on the title page.

Terminology

The following terms will be used throughout this manual to refer to certain components of the Econo-

load:

Econoload or Load - The entire unit. It contains the RESISTOR.

Resistor - A subcomponent of the LOAD. This is the ceramic resistor which actually absorbs the RF

power.

Literature Contents

Chapter Layout

Introduction —Describes the features of the Econoload RF Load, lists equipment supplied and

optional equipment, and provides power-up instructions.

Theory of Operation —Describes how the load works on a fundamental level.

Installation —Describes how to install the load or Econoload and it’s components.

Operating Instructions - Describes the features of the Econoload RF Load and its process of operation.

Maintenance —Lists routine maintenance tasks as well as troubleshooting for common problems.

Specifications and parts information are also included.

8730A 8731 8738A

8732A 8738A110

viii

Andere Handbücher für ECONOLOAD 8730 Series

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere BIRD Prüfgeräte Handbücher

BIRD

BIRD TERMLINE 8141 Bedienungsanleitung

BIRD

BIRD FlightHawk Bedienungsanleitung

BIRD

BIRD AT-800 Bedienungsanleitung

BIRD

BIRD AT-800 Bedienungsanleitung

BIRD

BIRD AT-400 Antenna Tester AT-400 Bedienungsanleitung

BIRD

BIRD SMK-3000 Series Bedienungsanleitung

BIRD

BIRD AT-500 Bedienungsanleitung

BIRD

BIRD 4029 Bedienungsanleitung

BIRD

BIRD SignalHawk SH-36S-RM Bedienungsanleitung

Beliebte Prüfgeräte Handbücher anderer Marken

SMART

SMART KANAAD SBT XTREME 3G Series Bedienungsanleitung

Agilent Technologies

Agilent Technologies BERT Serial Bedienungsanleitung

Agilent Technologies

Agilent Technologies N3280A Bedienungsanleitung

Lifeloc

Lifeloc R.A.D.A.R. Bedienungsanleitung

Fluke

Fluke T5-600 Bedienungs- und Montageanleitung

Mercury

Mercury TSL01 Bedienungsanleitung

MAHA

MAHA MBT Series Bedienungsanleitung

Fuji Electric

Fuji Electric P-61 Bedienungsanleitung

ETC

ETC SealerAtor Bedienungsanleitung

Skyfine

Skyfine ETHYWAY V2 Bedienungsanleitung

Appion

Appion G5 Twin Bedienungsanleitung

PCB Piezotronics

PCB Piezotronics 8159-0112A Bedienungsanleitung

BW Technologies

BW Technologies MicroDock II Bedienungsanleitung

Sun Nuclear

Sun Nuclear 1027 Bedienungsanleitung

Biomark

Biomark HPR LITE READER Bedienungsanleitung

Hioki

Hioki 3169-20 Bedienungsanleitung

Ashcroft

Ashcroft ATE-100 Bedienungsanleitung

Rohde & Schwarz

Rohde & Schwarz RTA4000 Bedienungsanleitung